Of secondary alcohols

A white solid, m.p. 178 C. Primarily of interest as a brominaling agent which will replace activated hydrogen atoms in benzylic or allylic positions, and also those on a carbon atom a to a carbonyl group. Activating influences can produce nuclear substitution in a benzene ring and certain heterocyclic compounds also used in the oxidation of secondary alcohols to ketones. 

Certain aliphatic compounds are oxidised by concentrated nitric acid, the carbon atoms being split off in pairs, with the formation of oxalic acid. This disruptive oxidation is shown by many carbohydrates, e.g., cane sugar, where the chains of secondary alcohol groups, -CH(OH)-CH(OH)-CH(OH)CH(OH)-, present in the molecule break down particularly readily to give oxalic acid. 

By the oxidation of secondary alcohols with potassium dichromate and dilute sulphuric acid, for example ... 

Selective oxidation of secondary alcohols to ketones is usually performed with CrOj/HjSO, I I in acetone (Jones reagent) or with CrOjPyj (Collin s reagent) in the presence of acid-sensitive groups (H.G. Bosche, 1975 C. Djerassi, 1956 W.S. Allen, 1954). As mentioned above, a,)S-unsaturated secondary alcohols are selectively oxidized by MnOj (D.G. Lee, 1969 D. Arndt, 1975) or by DDQ (D. Walker, 1967 H.H. Stechl, 1975). 

Alcohols are oxidized slowly with PdCh. Oxidation of secondary alcohols to ketones is carried out with a catalytic amount of PdCh under an oxygen atmo-sphere[73.74]. Also, selective oxidation of the allylic alcohol 571 without attacking saturated alcohols is possible with a stoichiometric amount of PdfOAc) in aqueous DMF (1% H OifSll],... 

As carbocations go CH3" is particularly unstable and its existence as an inter mediate m chemical reactions has never been demonstrated Primary carbocations although more stable than CH3" are still too unstable to be involved as intermediates m chemical reactions The threshold of stability is reached with secondary carbocations Many reactions including the reaction of secondary alcohols with hydrogen halides are believed to involve secondary carbocations The evidence m support of tertiary carbo cation intermediates is stronger yet... 

Oxidation of secondary alcohols to ke tones (Section 15 10) Many oxidizing agents are available for converting sec ondary alcohols to ketones PDC or PCC may be used as well as other Cr(VI) based agents such as chromic acid or po tassium dichromate and sulfuric acid... 

The hydrocarbon feedstock contains 35—95% ethylene the remaining gases are methane and ethane. Certain unsaturated hydrocarbons are undesirable as their presence leads to the formation of secondary alcohols. 

Oppenauer reaction is oxidation of secondary alcohols to ketones using aluminium t-butoxide... 

The elimination from sulfonates of secondary alcohols is frequently easier than more direct methods applied to the free alcohols. As with the latter, there are the possibilities of isomeric olefin formation and rearrangement reactions. In addition, displacement and hydrolysis may occur, but these side reactions can usually be suppressed. 

The reactivity of various steroid alcohols decreases in the order primary > secondary (equatorial) > secondary (axial) > tertiary. The only systematic investigation relating to the selective protection of steroidal hydroxyl functions has been carried out with the cathylate (ethyl carbonate) group. Since only equatorial hydroxyl groups form cathylates this ester has been used as a diagnostic tool to elucidate the configuration of secondary alcohols. 

Table 6b. Fluorination of Secondary Alcohols with Diethylaminosulfur Trifluoride (DAST)...

A vanety of secondary alcohols with terminal trifluoromethyl group are oxidized by the Dess-Martin periodinane reagent [52 57] (equation 48)... 

A secondary alcohol reacts more slowly (40-45°, 18-24 h, 68-70% yield). In general, excellent selectivity can be achieved for primary alcohols in the presence of secondary alcohols. ... 

To circumvent the need for strong acid and allow the dehydration of secondary alcohols, reagents have been developed that are effective under mild, basic conditions. One such reagent, phosphorus oxychloride (POCI3) in the basic amine solvent pyridine, is often able to effect the dehydration of secondary and tertiary alcohols at 0 °C. 

Aldehydes and ketones are among the most important of ail compounds, both in biochemistry and in the chemical industry. AUdehydes are normally prepared in the laboratory by oxidation of primary alcohols or by partial reduction of esters. Ketones are similarly prepared by oxidation of secondary alcohols or by addition of diorganocopper reagents to acid chlorides. 

The interconversion of alcohols to ketones is a common biochemical reaction. The introduction of hydroxyl groups into toe steroid nucleus and side chain creates a variety of secondary alcohols. Some of these, especially at positions 3, 7, 11 and 17 are frequently oxidised to ketones. 

The molecular ion is slightly more intense in the mass spectra of secondary alcohols than in tertiary alcohols, but even in secondary alcohols, the molecular ion intensity is very small. 

Stirton et al. also studied the influence of the structure of the ester group on the CMC. They found that for a-sulfopalmitates and a-sulfostearates the esters of secondary alcohols, like isopropyl, isobutyl, and secondary butyl esters, have higher CMC values than the esters of primary alcohols [30]. 

Dichromate oxidation of secondary alcohols produces ketones in good yield, with little additional oxidation. For example, CH,CH2CH(OH)CH3 can be oxidized to CH CH2COCH3. The difference between the ease of oxidation of aldehydes and that of ketones is used to distinguish them. Aldehydes can reduce silver ions to form a silver mirror—a coating of silver on test-tube walls—with Tollens reagent, a solution of Ag1" ions in aqueous ammonia (Fig. 19.3) ... 

The second group of studies tries to explain the solvent effects on enantioselectivity by means of the contribution of substrate solvation to the energetics of the reaction [38], For instance, a theoretical model based on the thermodynamics of substrate solvation was developed [39]. However, this model, based on the determination of the desolvated portion of the substrate transition state by molecular modeling and on the calculation of the activity coefficient by UNIFAC, gave contradictory results. In fact, it was successful in predicting solvent effects on the enantio- and prochiral selectivity of y-chymotrypsin with racemic 3-hydroxy-2-phenylpropionate and 2-substituted 1,3-propanediols [39], whereas it failed in the case of subtilisin and racemic sec-phenetyl alcohol and traws-sobrerol [40]. That substrate solvation by the solvent can contribute to enzyme enantioselectivity was also claimed in the case of subtilisin-catalyzed resolution of secondary alcohols [41]. 

Finally in this section on deracemization via cyclic oxidation/reduction methods, there has been some limited work carried out on the deracemization of secondary alcohols. Soda et al. [22] employed lactate oxidase in combination with sodium borohydride to deracemize D/i-lactate (18) via the intermediate pyruvate (19) (Figure 5.12). 

Microbial Deracemization of Secondary Alcohols Using a Single Microorganism... 

An alternative approach to the microbial deracemization of secondary alcohols is to use two different microorganisms with complementary stereoselectivity. Fantin et al. studied the stereoinversion of several secondary alcohols using the culture supernatants of two microorganisms, namely Bacillus stearothermophilus and Yarrowia lipolytica (Figure 5.18) [31]. The authors tested three main systems for deracemization. First, they used the supernatant from cultures of B. stearothermophilus, to which they added Y. lipolytica cells and the racemic alcohols. Secondly, they used the culture supernatant of Y. lipolytica and added B. stearothermophilus cells and the racemic alcohols. Finally, they resuspended the cells of both organisms in phosphate buffer and added the racemic alcohols. The best results were obtained in the first system with 6-penten-2-ol (26) (100% ee and 100% yield). The phosphate buffer system gave... 

The wide substrate tolerance of lipases is demonstrated by the resolution of organometallic substrates [129-131]. The presence of tin, selenium, or tellurium in the structure of secondary alcohols does not inhibit the lipase activity and enantiopure organometallic alcohols were obtained by acylation in organic media (Figure 6.48). 

---