Norbornene addition reactions

Reactions. The thermal decomposition of benzenesulfonyl azide gives radicals which react with aromatic hydrocarbons to give products of amidation.1-3 Like phenyl azide, benzenesulfonyl azide undergoes addition reactions with strained double bonds. Thus it reacts with norbornene (1, bicyclo[2.2.1 ]-2-heptene) with loss of nitrogen to give the azetidine (2) in nearly quantitative yield.2 The reaction is considered to involve the intermediate (a). In contrast the reaction... 

Stereoselectivity in addition reactions of borane with bicyclic alkenes is similar to that observed for reduction of bicyclic ketones with hydride reducing agents. Boranes add to norbornene derivatives from the exo face (27 gave 85% exo attack upon reaction with diborane). In 27-30, all values are percentage yields of the organoborane products obtained by reaction from that face. Interestingly, only 80% exo attack was observed when 27 reacted with disiamylborane, and the size of the borane appears to have little effect on selectivity. 

MODEL STUDIES Early in this study it appeared that [2.2.1]bicyclic olefin resins added conventional crosslinking thiols in a rapid, exothermic, manner. These results appear to contradict earlier reports that internal olefins and cyclic olefins such as cyclohexene and cydopentene react only slowly with thiols. In reality, [2.2.1]bicydic olefins represent a separate dass of reactive olefins. These results are also consistent with reports (16-19) that bicyclic olefins such as norbomadiene are quite reactive to the addition of monofunctional thiols and thiyl radicals. In order to quantify the relative reactivity of norbornene resins with other "standard" ene components, a model study of the addition reaction was undertaken. A "typical" thiol (ethyl mercaptoacetate) was examined in a series of competitive reactions in which there was a defidency of olefin (Figure 4). Olefin substrates that were compared were norbornene, styrene, butyl vinyl ether, [2.2.2]bicydooctene and phenyl allyl ether. The results of that study are listed below in Table I. 

The reaction course taken by photoexcited cycloalkenes in hydroxylic solvent is somewhat different and depends very much on ring size. 1-Methylcyclohexene, 1-methylcycloheptene, and 1-methylcyclooctene all add methanol, but neither 1-methylcyclopentene nor norbornene does so. The key intermediates in the addition reaction are believed to be highly reactive /raws-isomers of the cycloalkene. 

The effective electrophilicity of weak electrophiles, e.g. 2,4-dinitrobenzenesulphenyl chloride, are appreciably increased in addition reactions, e.g. to norbornene, in the presence of strong electrolytes such as LiC104 the proportion of Wagner-Meerwein rearrangement products is thereby increased. 

Catellani and Lautens have independently reported unique palladium/ norbornene-catalyzed reactions of aryl halides, which mechanistically involve a reversible alkene insertion/p-carbon elimination process [11]. For example, iodobenzene reacted with 1-iodobutane and methyl acrylate to form the multiply-alkylated benzene 29 (Scheme 7.9) [12]. The following mechanism is proposed oxidative addition of phenyl iodide onto palladium generates phenylpalladium(ll) iodide. A double bond of norbornene inserts into the C-Pd bond to form an alkylpalladium species, which cleaves a C-H bond nearby to form the palladacycle 25. -Butyl iodide then reacts with 25 to form the Pd(IV) intermediate 26, which undergoes reductive elimination. Repetition of the cyclometalation/alkylation process leads to the formation of 27. Then, P-carbon elimination affords the arylpalladium species 28 together with norbornene. Subsequently, a Heck-type reaction takes place with methyl acrylate, giving rise to 29. 

The Pd(PhCN)2Cl2-catalyzed addition reaction of 1-alkenylstannane reagents with two molecules of norbornene afforded polycyclic products via the oxidative addition of the tin reagent with Pd(0), double insertion, and an intramolecular Heck reaction (eq 34). ... 

In a manner analogous to classic nitrile iinines, the additions of trifluoro-methylacetonitrile phenylimine occur regiospecifically with activated terminal alkenes but less selectively with alkynes [39], The nitnle imine reacts with both dimethyl fumarate and dimethyl maleate m moderate yields to give exclusively the trans product, presumably via epimenzation of the labile H at position 4 [40] (equation 42) The nitrile imine exhibits exo selectivities in its reactions with norbornene and norbornadiene, which are similar to those seen for the nitrile oxide [37], and even greater reactivity with enolates than that of the nitnle oxide [38, 41], Reactions of trifluoroacetomtrile phenyl imine with isocyanates, isothiocyanates, and carbodiimides are also reported [42]... 

A dry 5(X)-mI flask equipped with a thermometer, pressure-equalizing dropping funnel, and magnetic stirrer is flushed with nitrogen and then maintained under a static pressure of the gas. The flask is charged with 50 ml of tetrahydrofuran and 13.3 ml (0.15 mole) of cyclopentene, and then is cooled in an ice bath. Conversion to tricyclo-pentylborane is achieved by dropwise addition of 25 ml of a 1 M solution of diborane (0.15 mole of hydride see Chapter 4, Section 1 for preparation) in tetrahydrofuran. The solution is stirred for 1 hour at 25° and again cooled in an ice bath, and 25 ml of dry t-butyl alcohol is added, followed by 5.5 ml (0.05 mole) of ethyl bromoacetate. Potassium t-butoxide in /-butyl alcohol (50 ml of a 1 M solution) is added over a period of 10 minutes. There is an immediate precipitation of potassium bromide. The reaction mixture is filtered from the potassium bromide and distilled. Ethyl cyclopentylacetate, bp 101730 mm, 1.4398, is obtained in about 75% yield. Similarly, the reaction can be applied to a variety of olefins including 2-butene, cyclohexene, and norbornene. 

Formation of mixtures of products in these reactions can be attributed largely to the properties of the acetate group. The reactions of a number of cycloalkenes with thallium(III) salts have been investigated in some detail and the results obtained have served both to elucidate the stereochemistry of oxythallation and to underline the important role assumed by the anion of the metal salt in these oxidations. The most unambiguous evidence as to the stereochemistry of oxythallation comes from studies by Winstein on the oxythallation of norbornene (VII) and norbornadiene (VIII) with thal-lium(III) acetate in chloroform, in which the adducts (IX) and (X) could be precipitated from the reaction mixture by addition of pentane 128) (Scheme 11). Both by chemical means and by analogy with the oxymercuration... 

Apart from the role of substituents in determining regioselectivity, several other structural features affect the reactivity of dipolarophiles. Strain increases reactivity norbornene, for example, is consistently more reactive than cyclohexene in 1,3-DCA reactions. Conjugated functional groups usually increase reactivity. This increased reactivity has most often been demonstrated with electron-attracting substituents, but for some 1,3-dipoles, enol ethers, enamines, and other alkenes with donor substituents are also quite reactive. Some reactivity data for a series of alkenes with several 1,3-dipoles are given in Table 10.6 of Part A. Additional discussion of these reactivity trends can be found in Section 10.3.1 of Part A. 

Synthesis of block copolymers of norbornene derivatives, with different side groups, has been reported via ROMP [101]. Initially, exo-N-bulyl-7-oxabicyclo[2.2.1]hept-5-ene-2,3-dicarboximide was polymerized in acetone at room temperature with a ruthenium initiator (Scheme 40). The conversion of the reaction was quantitative. Subsequent addition of norbornene derivative carrying a ruthenium complex led to the formation of block copolymers in 85% yield. Due to the presence of ruthenium SEC experiments could not be performed. Therefore, it was not possible to determine the molecular weight... 

Unlike the oxymercuration of acyclic olefins, oxymercuration of bicyclic olefins often gives jy -addition products. Norbornenes 93, for example, show exclusive fvo-oxymercuration. In this reaction, the ratio between the isomers depends on the nature of the fvo-substituent (R1) and tro/o-substituent (R2) (Equation (36)). The presence of electron-withdrawing fvo-substituents always leads to a much greater selectivity in favor of 94a-d over 95a-d.116 117 As indicated by extensive theoretical calculations, the charge distribution in the transition states governs the selectivity of these reactions.118... 

We have reported the first example of a ring-opening metathesis polymerization in C02 [144,145]. In this work, bicyclo[2.2.1]hept-2-ene (norbornene) was polymerized in C02 and C02/methanol mixtures using a Ru(H20)6(tos)2 initiator (see Scheme 6). These reactions were carried out at 65 °C and pressure was varied from 60 to 345 bar they resulted in poly(norbornene) with similar conversions and molecular weights as those obtained in other solvent systems. JH NMR spectroscopy of the poly(norbornene) showed that the product from a polymerization in pure methanol had the same structure as the product from the polymerization in pure C02. More interestingly, it was shown that the cis/trans ratio of the polymer microstructure can be controlled by the addition of a methanol cosolvent to the polymerization medium (see Fig. 12). The poly(norbornene) prepared in pure methanol or in methanol/C02 mixtures had a very high trans-vinylene content, while the polymer prepared in pure C02 had very high ds-vinylene content. These results can be explained by the solvent effects on relative populations of the two different possible metal... 

Similar to the addition of secondary phosphine-borane complexes to alkynes described in Scheme 6.137, the same hydrophosphination agents can also be added to alkenes under broadly similar reaction conditions, leading to alkylarylphosphines (Scheme 6.138) [274], Again, the expected anti-Markovnikov addition products were obtained exclusively. In some cases, the additions also proceeded at room temperature, but required much longer reaction times (2 days). Treatment of the phosphine-borane complexes with a chiral alkene such as (-)-/ -pinene led to chiral cyclohexene derivatives through a radical-initiated ring-opening mechanism. In related work, Ackerman and coworkers described microwave-assisted Lewis acid-mediated inter-molecular hydroamination reactions of norbornene [275]. 

The side products of the reaction between benzoylnitromethane 279 and dipolarophiles (norbornene, styrene, and phenylacetylene) in the presence of l,4-diazabicyclo[2.2.2]octane (DABCO) were identified as furazan derivatives (Scheme 72). The evidence reported indicates that benzoylnitromethane gives the dibenzoylfuroxan as a key intermediate, which is the dimerization product of the nitrile oxide. The furoxan then undergoes addition to the dipolarophile, hydrolysis, and ring rearrangement to the final products (furazans and benzoic acid) <2006EJ03016>. 

---