Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Nitrosyl complexes ligand

The coordination chemistry of NO is often compared to that of CO but, whereas carbonyls are frequently prepared by reactions involving CO at high pressures and temperatures, this route is less viable for nitrosyls because of the thermodynamic instability of NO and its propensity to disproportionate or decompose under such conditions (p. 446). Nitrosyl complexes can sometimes be made by transformations involving pre-existing NO complexes, e.g. by ligand replacement, oxidative addition, reductive elimination or condensation reactions (reductive, thermal or photolytic). Typical examples are ... [Pg.448]

This is the second of the common oxidation states for iron and is familiar for ruthenium, particularly with Group 15-donor ligands (Ru probably forms more nitrosyl complexes than any other metal). Osmium(II) also produces a considerable number of complexes but is usually more strongly reducing than Ru". [Pg.1091]

Ruthenium probably forms more nitrosyl complexes [115] than any other metal. Many are octahedral Ru(NO)Xs systems, where X5 can represent a combination of neutral and anionic ligands these contain a linear (or very nearly) Ru-NO grouping and are regarded as complexes of ruthenium(II). They are often referred to as (Ru(NO) 6 systems. [Pg.42]

In recent years, several model complexes have been synthesized and studied to understand the properties of these complexes, for example, the influence of S- or N-ligands or NO-releasing abilities [119]. It is not always easy to determine the electronic character of the NO-ligands in nitrosyliron complexes thus, forms of NO [120], neutral NO, or NO [121] have been postulated depending on each complex. Similarly, it is difficult to determine the oxidation state of Fe therefore, these complexes are categorized in the Enemark-Feltham notation [122], where the number of rf-electrons of Fe is indicated. In studies on the nitrosylation pathway of thiolate complexes, Liaw et al. could show that the nitrosylation of complexes [Fe(SR)4] (R = Ph, Et) led to the formation of air- and light-sensitive mono-nitrosyl complexes [Fe(NO)(SR)3] in which tetrathiolate iron(+3) complexes were reduced to Fe(+2) under formation of (SR)2. Further nitrosylation by NO yields the dinitrosyl complexes [(SR)2Fe(NO)2], while nitrosylation by NO forms the neutral complex [Fe(NO)2(SR)2] and subsequently Roussin s red ester [Fe2(p-SR)2(NO)4] under reductive elimination forming (SR)2. Thus, nitrosylation of biomimetic oxidized- and reduced-form rubredoxin was mimicked [121]. Lip-pard et al. showed that dinuclear Fe-clusters are susceptible to disassembly in the presence of NO [123]. [Pg.209]

The low reactivity of both Cyt111 and Cyt11 toward NO can be attributed to occupation of the heme iron axial coordination sites by an imidazole nitrogen and by a methionine sulfur of the protein (28). Thus, unlike other heme proteins where one axial site is empty or occupied by H20, formation of the nitrosyl complex not only involves ligand displacement but also significant protein conformational changes which inhibit the reaction with NO. However, the protein does not always inhibit reactivity given that Cat and nNOS are more reactive toward NO than is the model complex Fem(TPPS)(H20)2 (Table II). Conversely, the koS values... [Pg.211]

For example, the substituted aniline Ar-NH2 (Ar = />-CH3OC6H4) reacts with the ruthenium nitrosyl complex Ru(bpy)2(Cl)(NO)2+ (bpy = 2,2 -bipyridine) to give a complex of the diazo ligand, namely Ru(bpy)2(Cl)(NNAr)2+ (57). Upon employing the 15N labeled nitrosyl complex Ru(bpy)2Cl(15NO)2+ this reaction resulted in the 15N coordinated product, Ru(bpy)2Cl(15NNAr)2+, demonstrating that the reaction occurs within the metal complex coordination sphere. When the reactions were conducted in non-protic solvents, these nucleophile-nitrosyl adducts could be isolated. [Pg.225]

At higher NO concentrations, MPO activity is inhibited through formation of an inactive ferric nitrosyl complex MPO(NO) the rate constant kori is 1.07xlO6 M-1s-1 and the dissociation rate constant, kQff, is 10.8 s-1 (pH 7.0 phosphate buffer at 10 °C) (Scheme 9, pathway A). However, the inhibitory effects of NO are reduced in the presence of plasma levels of Cl- (100 mM) where on and kQ rate constants were determined to be 1.5 x 105 M-1s-1 and 22.8 s-1, respectively. The modulating effects of NO on MPO activity parallel that of O2 which accelerates activity by serving as a substrate for compound II and inhibits activity by acting as a ligand for MPO (Scheme 9, pathway B) (29). [Pg.242]

The syntheses, structures and properties of wide varieties of metal nitrosyl complexes have been well documented [4, 5, 20-23]. However, the bulk of the complexes reviewed previously are of academic interest and only a few of these metal nitrosyl complexes have been considered as biologically effective NO donors. It was observed that the metal nitrosyls with significant NO+ character are subject to attack from a variety of nucleophiles and have hypertensive properties. This could be due to the strong trans- labilizing effect of NO. In contrast, the metal nitrosyl compounds with the general formula [M(CN)5NO]n, where the NO ligand was either neutral (for M = Co) or anionic (for M = Cr) showed no vasodilatory effect [24]. [Pg.109]

Method (i) is a route commonly utilized in monometal nitrosyl complexes. The nitrosyl ligand may function as (formally) a three-electrop donor (NO+) with a linear bonding mode, or as (formally) a one-electron donor (NO ) with a bent (—120°) M-N-0 arrangement. Conversion of the M-NO system to a M-NO system has two effects. First, it increases the metal oxidation state by two second, it generates a vacant coordination site. The dinitrosyl cluster Os3(CO)8(NO)2, which has... [Pg.260]

In this paper author reported the reactivity of newly synthesized Co(III)-nitrosyls complexes with superoxide radical to follow nitric oxide dioxygenation. Two new Co(III)-nitrosyl complexes bearing N-tetramethylated cyclam (TMC) ligands, [(12-TMC)-Com(NO)]2+ (1) and [(13-TMC)Coin(NO)]2+ (2), were synthesized via [(TMC)Con(CH3CN)]2+ + NO(g) reactions. Spectroscopic and structural characterization showed that these compounds bind the nitrosyl moiety in a bent end-on fashion. Complexes 1 and 2 reacted with K02/2.2.2-ciyptand to produce [(12-TMC)Con(N02)]+ (3) and [(13-TMC)Con(N02)]+ (4), respectively these possess 0,0 -chelated nitrito ligands. [Pg.127]

As briefly alluded to, there are different classes of redox-active ligands in addition to the above mentioned ones. For example, we have seen in Chapter 5, Section 8, that azo-groups (in particular, 2-(phenylazo)pyr-imidine) are able to undergo two separate one-electron reduction processes. Conjugated polynitriles (mnt, tcne, tcnq) also constitute an important class of redox-active molecules and the electrochemical behaviour of their metal complexes has been reviewed.107 The same holds as far as alkyldithiocarbamates (Rdtc) and their metal complexes are concerned,108 or nitrosyl complexes in their possible NO+[NO fNO redox sequence.109 Thus, we would like to conclude the present Chapter by discussing a few less known redox non-innocent ligands. [Pg.371]

The Fe(II)-NO complexes of porphyrins 66-68) and heme proteins 24, 49, 53, 69-76) have been studied in detail by EPR spectroscopy, which allows facile differentiation between five-coordinate heme—NO and six-coordinate heme—NO(L) centers. However, only a few reports of the Mossbauer spectra of such complexes have been published 68, 77-82), and the only Fe(III)-NO species that have been studied by Mossbauer spectroscopy include the isoelectronic nitroprusside ion, [FeCCNlsCNO)] (7S), the five-coordinate complexes [TPPFe(NO)]+ 68) and [OEPFe(NO)]+ 82), and two reports of the nitro, nitrosyl complexes of iron(III) tetraphenylporphjrrins, where the ligand L is NO2 82, 83). [Pg.310]

Nitrosyl ligands have relatively poor fx-donor capabilities, but are excellent rr-acceptors. There are synthetic routes to nitrosyl complexes using NO gas, [NO][Bp4] or [NOJIPFg], hydroxyamine hydrochloride, HNO3, NaN02, or A -nitrosoamides. [Pg.363]


See other pages where Nitrosyl complexes ligand is mentioned: [Pg.124]    [Pg.175]    [Pg.231]    [Pg.250]    [Pg.193]    [Pg.87]    [Pg.275]    [Pg.37]    [Pg.42]    [Pg.77]    [Pg.185]    [Pg.603]    [Pg.206]    [Pg.209]    [Pg.219]    [Pg.246]    [Pg.109]    [Pg.118]    [Pg.169]    [Pg.173]    [Pg.125]    [Pg.125]    [Pg.125]    [Pg.72]    [Pg.336]    [Pg.34]    [Pg.394]    [Pg.2]    [Pg.225]    [Pg.226]    [Pg.350]    [Pg.363]    [Pg.363]    [Pg.376]   


SEARCH



Complexes containing nitrosyl or thionitrosyl ligands

Ligand structures nitrosyl complexes

Nitrosyl complexes

Nitrosyls complexes

© 2024 chempedia.info