Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Molecular systems carbon disulfide

In this study, molecular weight of the produced polymers will not be tracked over the course of the reaction. Thus, in order to simplify the model, chain transfer mechanisms will not be considered, along with side reactions, such as the production of carbon disulfide. Each of these reactions, as well as the molecular weight, plays a significant role in the iniferter polymerizations however, to simplify the system, it is essential to examine only the core reactions which contribute significantly to the mechanism. [Pg.54]

CASRN 12427-38-2 molecular formula C4ff6MnN2S4 FW 265.31 Chemical/Physical. When soil containing maneb was subjected to a stream of moist air, carbon disulfide was formed. Carbon disulfide was also formed when maneb was suspended in a O.IM phosphate buffer at pff 7.0 and air was drawn through the system. The rate of carbon disulfide was higher at neutral and acidic solutions but lower under alkaline conditions. When the air was replaced by nitrogen, no carbon disulfide was evolved. Decomposition products in the reaction vessel identified by TLC were ethylene thiourea, ethylene thiuram monosulfide, elemental sulfur, and trace amounts of ethylenediamine (ffylin, 1973). [Pg.1591]

Since two resonance lines at 39.0 and 47.7 ppm that correspond to those observed in the ttgg form and a resonance line at 49.0 ppm that corresponds to that in the tttt form are recognized in the gel spectrum, a coexistence of these two forms in the gel might be supposed. In an attempt to determine the possibility of the coexistence of the two forms in the gel, we measured the IR spectrum that is sensitive to the molecular conformation. The number of normal vibrational modes depends sensitively on the molecular conformation based on the selection rule of the symmetry species. Kobayashi et al. confirmed the vibrational modes assignable to the ttgg conformation in the IR spectrum for the gel from a sPP/carbon disulfide system [117]. However, since we used o-dichlorobenzene as solvent, we examined whether the gel structure depends on the solvent. [Pg.93]

The importance of selecting gravimetry instead of volumetry to measure liquid amounts in the pharmaceutical industry of liquid dosage forms is well illustrated by the volume contraction of water-ethanol and volume expansion of ethyl acetate-carbon disulfide liquid mixtures as well as a CS2-ethyl acetate system. The National Formulary (NF) diluted alcohol is a typical example of the volume nonadditivity of liquid mixtures [29], This solution is prepared by mixing equal volumes of alcohol [U.S. Pharmacopeia (USP)] USP and purified water (USP). The final volume of this solution is about 3% less than the sum of the individual volumes because of the contraction due to the mixing phenomenon [1], In addition, molecular interactions of surfactants in mixed monolayers at the air-aqueous solution interface and in mixed micelles in aqueous media also cause some contraction of volume upon mixing [30],... [Pg.325]

In the current study, special attention was given to confirming the presence of carbon disulfide in the headspace of Cheddar cheese, and conclusive mass spectral evidence was developed for this compound. The concentration of carbon disulfide varied widely in the samples analyzed for the methanethiol studies, and became quite abundant in the most-aged sample of cheese that contained the encapsulated methioninase system (Figure 6). This sample also contained a lower molecular weight sulfur compound which remains unidentified, but it was observed only in the cheese prepared with encapsulated methioninase. [Pg.303]

Figure 3(b) depicts the gel point of polystyrene-carbon disulfide systems and die plot at constant molecular weight shows good linearity. [Pg.56]

The Rot correlation produces a complex relaxation pattern that has to be addressed to the whole rotational dynamics inclusive of libralional and diffusive dynamics. This dynamics has been extensively studied by OKE experiments in simple molecular Uquids. For example, the liquid phases of benzene or carbon disulfide are particularly interesting systems. In fact, they can be considered symmetric-top rigid molecules (i.e., tbe molecular polarizabiUty has a cylindrical symmetry and all the vibrational modes have very high frequencies, not excitable by the laser pulses spectrum). Even in such simple molecular liquids, the interpretation of several dynamics is still open to debate [19,20,36] (see also Sect. 2.5.1). [Pg.86]


See other pages where Molecular systems carbon disulfide is mentioned: [Pg.658]    [Pg.227]    [Pg.109]    [Pg.246]    [Pg.109]    [Pg.40]    [Pg.791]    [Pg.367]    [Pg.658]    [Pg.246]    [Pg.437]    [Pg.6]    [Pg.566]    [Pg.156]    [Pg.55]    [Pg.1025]    [Pg.762]    [Pg.242]    [Pg.100]    [Pg.2926]    [Pg.31]    [Pg.22]    [Pg.8]    [Pg.427]    [Pg.326]    [Pg.78]    [Pg.400]   
See also in sourсe #XX -- [ Pg.180 ]




SEARCH



Carbon disulfid

Carbon disulfide

Carbon disulfides

Carbon system

Carbonate systems

© 2024 chempedia.info