Magnesium chloride dihydrate

In the first place, it may be again noted that at a temperature above (point M) carnallite cannot exist. If, therefore, a solution of magnesium and potassium chlorides is evaporated at a temperature above this point, the result will be a mixture of potassium chloride and either magnesium chloride tetrahydrate or magnesium chloride dihydrate, according as the temperature is below or above 176°. The isothermal curve here consists of only two branches. 

Weigh 4.0 g of disodium dihydrogen EDTA dihydrate and 0.10 g of magnesium chloride hexahy-drate into a 1-L glass bottle. Add one pellet of NaOH and fill to approximately 1 L with water. Shake well. These ingredients will require some time to dissolve, so it is recommended that this solution be prepared one lab session ahead of its intended use. 

Potassium phosphate monobasic Magnesium sulfate heptahydrate Calcium chloride dihydrate Zinc sulfate heptahydrate Ferric sulfate heptahydrate Copper sulfate pentahydrate Cobalt(II) chloride hexahydrate Perchloric acid Potassium hydrocarbonate... 

The chemicals used in this study were sodium chloride, magnesium chloride, calcium chloride, potassium chloride, trichloroacetic acid (TCA), trifluoroacetic acid, a-d glucose, sodium citrate dihydrate, sodium hydrogen phosphate, hydrochloric acid, and iron (11) sulfote heptahydrate. These chemicals were purchased from Sigma (St. Louis, MO, USA). The HPLC grade solvent, acetonitrile was fivm J. T. Baker (Philipsburg NJ, USA). Water was distilled and deionized prior to use. 

Scavengers are usually added to arrest the p-methoxybenzyl carbocation before it can do any collateral damage. Typical combinations of Lewis acid and scavenger are trifluoroborane and triethylsilane tin(IV) chloride and benzene-thiol - catalytic amounts of tin(II) chloride dihydrate and ethanelhiol - catalytic amounts of trichloroalane and ethanethiol magnesium bromide etherate and dimethyl sulfide and trichloroborane and dimethyl sulfide [Scheme 4.188]. Cerium(III) chloride heptahydrate together with sodium iodide cleaves p-methoxybenzyl ethers in refluxing acetonitrile- as does iodine in refluxing methanol but in the latter case, isopropylidene acetals do not survive. ... 

Lithium fluoride Lithium hydroxide Lithium nitrate Magnesium chloride Magnesium oxalate dihydrate... 

BaClj 2H2O barium chloride dihydrate LiCl HjO lithium chloride monohydrate MgS04 7H2O magnesium sulfate heptahydrate Sr(N03)2 4H2O strontium nitrate tetrahydrate... 

Barium chloride dihydrate Lithium chloride monohydrate Magnesium sulfate heptahydrate Strontium nitrate tetrahydrate... 

BaCl2 2H2O Barium chloride dihydrate MgS04 7H2O Magnesium sulfate heptahydrate... 

Disodium hydrogen phosphate dihydrate (25.5 g), potassium dihydrogen phosphate (9.0 g), ammonium chloride (1.0 g) and sodium chloride (0.5 g) were dissolved in water and the volume adjusted to 900 mL. The solution was sterilized by autoclaving (121 °C, 20 min) and allowed to cool to room temperature. Magnesium sulfate (240.5 mg), kanamycin (50 mg), thiamine (10 mg) and glucose (5 g) were dissolved in water and adjusted to 100 mL volume. This mixture was sterilized by filtration through a 0.2 pm filter and added to the salt solution. 

In many of its chemical properties, radium is like the elements magnesium, caldum, strontium and barium, and it is placed in group 2, as is consistent with its 6s26pcls2 electron configuraUon. Its sulfate (Ksp — 4.2 a 10-1 ) is even more insoluble in water than barium sulfate, with which it is conveniently coprecipitated, Like barium and other alkaline earth metals, it forms a soluble chloride (X p = 0,4) and bromide, which can also be obtained as dihydrates, Radium also resembles the other group 2 elements in forming an insoluble carbonate and a very slightly soluble lodate (Xsp = 8.8 x 1(T10). 

---