Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Luminescence behavior model

Photoinduced electron transfer from eosin and ethyl eosin to Fe(CN)g in AOT/heptane-RMs was studied and the Hfe time of the redox products in reverse micellar system was found to increase by about 300-fold compared to conventional photosystem [335]. The authors have presented a kinetic model for overall photochemical process. Kang et al. [336] reported photoinduced electron transfer from (alkoxyphenyl) triphenylporphyrines to water pool in RMs. Sarkar et al. [337] demonstrated the intramolecular excited state proton transfer and dual luminescence behavior of 3-hydroxyflavone in RMs. In combination with chemiluminescence, RMs were employed to determine gold in aqueous solutions of industrial samples containing silver alloy [338, 339]. Xie et al. [340] studied the a-naphthyl acetic acid sensitized room temperature phosphorescence of biacetyl in AOT-RMs. The intensity of phosphorescence was observed to be about 13 times higher than that seen in aqueous SDS micelles. [Pg.173]

Scheme in illustrates a possible model for the luminescence behavior of p- PS consistent with the observed quenching phenomena. The luminescence emission is gated by a surface hole trap which is in communication with the valence band and has a pH dependent energy. This surface site is hypothesized to provide a site of non-radiative recombination. The deprotonated state must exist in the bandgap so that recombination of photoexcited electrons can bypass the radiative band-to-band transition, while the protonated state is expected to lie below the valence band edge. [Pg.89]

The stability of the polypyridyl rhenium(I) compounds mentioned above stimulated applications of this coordination chemistry. Thus, new heterotopic bis(calix[4]arene)rhenium(I) bipyridyl receptor molecules have been prepared and shown to bind a variety of anions at the upper rim and alkali metal cations at the lower rim. A cyclodextrin dimer, which was obtained by connecting two permethylated /3-cyclodextrins with a bipy ligand, was used for the preparation of a luminescent rhenium(I) complex. The system is discussed as a model conipound to study the energy transfer between active metal centers and a bound ditopic substrate. The fluorescence behavior of rhenium(I) complexes containing functionalized bipy ligands has been applied for the recognition of glucose. ... [Pg.359]

Models for the emitting excited state are reviewed, particularly with regard to the effects of molecular structure on excited state behavior. Data are tabulated for known emitting complexes. While a wide variety of luminescent ruthenium(II) complexes cannot be designed at present, some guidelines are beginning to emerge. [Pg.1]

Devoisselle JM, Begu S, Toume-Peteilh C, Desmettre T, Mordon S. In vivo behavior of long-circulating liposomes in blood vessels in hamster inflammation and septic shock models use of intravital fluorescence microscopy. Luminescence 2001, 16, 73-78. [Pg.109]

Some other polymers of the same type with valence (I) were also prepared (Fig. 17). They exhibit almost the same structure, except that halides are replaced by diphosphine ligands (diphos) such as bis(diphenylphosphino) butane (dppb), bis(diphenylphosphino)pentane (dpppen), and bis(diphenyl-phosphino)hexane (dpph).36,40 Again a model complex, compound 25, was studied as reference (Fig. 17). The electronic spectra exhibit an absorption band near 480 nm. These coordination materials are not luminescent at room temperature but are luminescent in solution in butyronitrile at low temperature (i.e., 77 K). Density functional theory (DFT) calculations showed that luminescence arises from a da-da triplet excited state. In these polymers, the nature of the phosphine ligand has a crucial effect on absorption and emission bands. Such behavior is explained by the increase in electronic density on the... [Pg.60]

For supramolecular assemblies, intramolecular processes may quench the emission of A to a degree which depends on the relative efficiency of the process when compared with emission. It is often useful to compare the photophysical and chemical behavior of the supramolecular species, e.g. A -L-B, with an appropriate model compound, for instance, AH, which contains the photochemically active component, A, in the absence of any units capable of interacting with A. For example, from luminescence lifetime measurements, the rate of electron transfer may be estimated by comparing the excited-state lifetime of the mononuclear model complex, tModei, with that of the supramolecular species, rsupra, by using the following equation ... [Pg.57]

Weller and Zachariasse thoroughly investigated exciplex formation and luminescence for donor acceptor systems in THF [18]. A particularly interesting result from their work came from an examination of the temperature dependence of radiative charge recombination between 9,10-dimethylanthracene anion (DMA") and TPTA+ in THF [19]. They found that both exciplex emission and fluorescence from DMA were observed in solution at low temperature (ca. —50°C). As the solution temperature is raised, the excimer emission decreases in relative intensity, and at room temperature the emission is nearly completely DMA fluorescence. The monomer-to-exciplex emission intensity ratio as a function of temperature follows Arrhenius kinetic behavior and yields an activation barrier that is nearly the same as the energy gap between the exciplex and the DMA states. Thus, their model consisted of reaction of the solvent-separated ions to form an intimate emissive ion pair which could dissociate to yield the singlet anthracene derivative. [Pg.394]

CdS clusters of narrow size distribution were studied by Eychmuller et al. [63], In this case a rather narrow luminescence band can be observed near the absorption band. The decay kinetics of this excitonic luminescence is multiexponential with a typical lifetime on the order of nanoseconds, much longer than the expected exciton lifetime. The temperature dependence of the excitonic luminescence shows complex behavior. Again, the authors use the three-level thermal equilibrium model to explain the data. The excitonic luminescence is identified as delayed luminescence occurring by detrapping of trapped electrons. Furthermore, they invoke the concept... [Pg.202]


See other pages where Luminescence behavior model is mentioned: [Pg.396]    [Pg.129]    [Pg.51]    [Pg.86]    [Pg.21]    [Pg.697]    [Pg.173]    [Pg.303]    [Pg.33]    [Pg.381]    [Pg.58]    [Pg.423]    [Pg.223]    [Pg.48]    [Pg.226]    [Pg.101]    [Pg.580]    [Pg.137]    [Pg.304]    [Pg.33]    [Pg.301]    [Pg.316]    [Pg.316]    [Pg.314]    [Pg.433]    [Pg.5432]    [Pg.355]    [Pg.30]    [Pg.41]    [Pg.21]    [Pg.2225]    [Pg.3078]    [Pg.119]    [Pg.366]    [Pg.259]    [Pg.125]    [Pg.29]    [Pg.276]    [Pg.257]    [Pg.333]    [Pg.9]   
See also in sourсe #XX -- [ Pg.88 ]




SEARCH



Behavior model

Behavioral model

Luminescence behavior

© 2024 chempedia.info