Lead production environmental pollution from

Nuclear-physical methods ai e the basic ones in controlling environmental pollution which results from nucleai -power complexes and power plants work. Oil and gas production leads to the extraction of radio nuclides of natural origin in considerable amounts, which later spread from oil-slimes and water wastes in the neighborhoods of oil and gas producing entei prises. Similaidy, toxic and radioactive elements can pollute environment in case of mineral deposits extraction. 

From the FIA—MS overview spectrum, speculation that there can be more than just one structurally defined molecule type behind an observable signal i.e. the presence of isobaric compounds, cannot be excluded whenever one signal defined by the m/z-ratio is examined in FIA-MS spectra. Consequently, the information obtained by FIA-MS is quite limited whenever we deal with complex mixtures of environmental pollutants rather than the analysis of pure products or formulations with a known range of ingredients. LC separation is inevitable when mixtures of isomeric compounds should be identified with MS-MS. Therefore, in FIA-MS-MS special attention has to be paid to avoid the generation of mixed product ion spectra from isomeric parent compounds. This would block identification by library search and may lead to misinterpretations of product ion spectra because of the fragmentation behaviour observed. 

Several kinds of failures may compromise safety and productivity of industrial processes. Indeed, faults may affect the efficiency of the process (e.g., lower product quality) or, in the worst scenarios, could lead to fatal accidents (e.g., temperature runaway) with injuries to personnel, environmental pollution, and equipments damage. In the chemical process fault diagnosis area, the term fault is generally defined as a departure from an acceptable range of an observed variable or a parameter. Fault diagnosis (FD) consists of three main tasks fault detection, i.e., the detection of the occurrence of a fault, fault isolation, i.e., the determination of the type and/or the location of the fault, and fault identification, i.e., the determination of the fault profile. After a fault has been detected, controller reconfiguration for the self-correction of the fault effects (fault accommodation) can be achieved in some cases. 

A major aspect of research and development in industrial catalysis is the identification of catalytic materials and reaction conditions that lead to effective catalytic processes. The need for efficient approaches to facilitate the discovery of new solid catalysts is particularly timely in view of the growing need to expand the applications of catalytic technologies beyond the current chemical and petrochemical industries. For example, new catalysts are needed for environmental applications such as treatment of noxious emissions or for pollution prevention. Improved catalysts are needed for new fuel cell applications. The production of high-value specialty chemicals requires the development of new catalytic materials. Furthermore, new catalysts may be combined with biochemical processes for the production of chemicals from renewable resources. The catalysts required for these new applications may be different from those in current use in the chemical and petrochemical industries. 

This will enable early detection of any likely damage of the plant equipments which may ultimately result in a breakdown. Since this can lead to an accident, environmental pollution, deterioration in product quality, or damage to plant equipment corrective action shall be taken at the earliest. The process units may be operated at reduced load (and examined thoroughly from view glasses) if it is not possible to rectify the cause immediately. This is to check any false alarm or any undue panic. 

---