Lead-acid battery uninterruptible power systems

Flaving had over 150 years of technical development behind them, lead-acid batteries can be custom-tailored to specific applications, such as those requiring deep discharge cycles (e.g., where the batteries are used as the sole power source for electrical equipment) and for battery backup uses such as in large uninterruptible power supply systems in data centers. Moreover, lead-acid cells not only have low internal resistance but also experience no memory effect as do some more exotic cell designs, such as NiCads. This enables these cells to produce enormous currents and have a moderately long, predictable life.1... 

The value of backup power is as much as three to four times the value of primary power on a kilowatt basis. For example, the lifecycle cost of the backup power systems found at the base of a cell tower, which now consists of a bank of lead acid batteries and a diesel or natural gas fired combustion engine, is between 3000 and 4000 per kW. Critical power facilities for data processing centers and the like are also in this cost range. The simple fact is that customers need electricity and will pay a considerable insurance premium to obtain assurance of uninterruptible power. In the case of cellular phone service providers, their federal FCC license may be at risk if they are unable to demonstrate adequate operating capability in the event of grid outages. 

Lead acid batteries have been used for more than 130 years in many different applications including automotive and various traction duties and also telecommunication systems and uninterruptible power supphes (UPS). The last two groups constitute the major part of the so-called stationary battery sector, and the lead-acid battery has proved to be a very reliable system for these appUcations. 

Grid independent power 1-5 kW E.g. small Uninterruptible power supply, UPS, small remote stationary systems (energy supply for signaling or weather stations) Generator driven by ICE Lead acid battery Noise, Emissions... 

Lead-acid batteries are also used for emergency power in uninterruptible power systems (UPS), telecommunications back-up systems, and safety equipment in critical applications such as hospitals and nuclear power plants. Stationary or standby battery designs and recharge profiles vary according to the specific system requirements. Large battery strings are connected in series to deliver up to several hundred volts. 

Stationary battery (cell) — Rechargeable -> batteries designed to be located at a fixed place. Stationary batteries are used mainly for uninterruptible power supplies (UPS) and standby applications. These cells are usually designed for high reliability and very long -> cycle life under shallow depth of discharge (DOD) conditions. The common chemical systems utilized for the production of stationary batteries are the -> lead-acid and -> nickel-cadmium batteries. Less common, and more futuristic is the - sodium-sulfur battery designed for KW and... 

A lead battery is an accumulator in which the electrodes consist primarily of lead, while a diluted sulfuric acid is used as an electrolyte. The lead is used in the form of bivalent and quadrivalent compounds (PbS04 and Pb02) and as a porous lead sponge for active masses, as well as in the form of lead-antimony or lead-calcium alloys for grids in lead batteries. The level of use of lead batteries in the portable appliance market is low. The main areas of application are starter and drive batteries as well as for uninterrupted power supply to stationary systems. 

---