Joint fabrication

The peel strength of soldered lap joint specimens was also not affected by irradiation. For example, the initial peel strength of a lap joint, fabricated from the 43 kg (95 lb) MR-TU, No. 25 tinplate, and the... 

Piping design, materials, joint fabrication, examination, and inspection shall be in accordance with ANSI/ASME B31.3. 

Figure 7. Comparison of a conventional hip joint fabricated from cobalt alloys with a joint design using carbon-fiber-reinforced composites tailored to meet specific local stress requirements (18) ...

For Pq2 > Pq2(M) (see Figure 6.11), an oxide skin is formed at the metal surface, inhibiting the movement of the triple line. Because this phenomenon is very important in the processing of interfaces in multimaterials or in brazed-joint fabrication, it will be discussed in detail in this sub-section. 

Fig. 14. Comparison of tensile load bearing capacities of co-cured single lap joint (fabricated under 0.7 MPa manufacturing pressure) calculated from the two failure criteria with experimental results.

Similar studies were carried out by Brown and Trollope (1970), Brown (1970), Einstein and Hirschfeld (1973), Yaji (1984), Arora (1987), Singh and Dev (1988) and Sharma (1989) and Roy (1993) which covers a wide range of data on rocks and rock like materials namely POP, different kinds of sandstone, granite and gypsum plaster with parallel and unparallel joints with different joint fabric at different confining pressures. Another objective of the paper is to compare the results of the study with the published woiks in this regard. 

No need for naked flames or high energy input during joint fabrication... 

Composite materials, like adhesives, are permeable to water. Moisture can therefore diffuse to the adherend/adhesive interface, which is a problem more in initial joint fabrication when a heat-cured adhesive is employed than when the joint is in service. Thus the moisture content of the composite at the time of joining should be low (say 1%) or else moisture may be drawn to the interface by... 

The use of Thermal spray processes to deposit thick layers, extending to typically 50 xm and with a surface roughness (Ra) of many micrometres, of Ti6A14V onto the same alloy has been demonstrated to be effective by a number of workers. Invariably, joints fabricated with PS pie-treated adherends perform very well in comparable durability trials, including those carried out at temperatures of 400 °C and greater. PS pre-treated adherends can give improved durability performance compared to CAA and similar results to the SHA process. 

Solving Eq. 5.10 for w fives tte optimum width of plate to give minimum fabrication cost for the shell as a function of joint fabrication cost, Cu, and shell thickness, /. This equation is plotted in Fig. 5.5 for convenience. 

The other important observation from the same era was made by Gettings and Kinloch using SSIMS (94J. When studying the fracture surfaces of adhesive joints fabricated using various silane-based primers, they were able to draw a direct correlation between good joint durability and the presence of an mtz = 100+ ion in the SSIMS spectrum at the failure surface (Fig. 13). The ion was attributed to an Fe-O-Si covalent bond and was present only for the... 

A jointed fabrication is one in which two or more components are held in position ... 

Offline injection mass flow. First, it is obvious that users are interested in low quantities of effluent water to be disposed off. It is also claimed that offline water effluent transported up to the exhaust during offline washing may wet and soak into the expansion joint fabric (or also in recuperator compensator). Thereupon... 

B.V. Cockeram, Flexural Strength and Shear Strength of Silicon Carbide to Sihcon Carbide Joints Fabricated by a Molybdenum Diffusion Bonding Technique, J. Am. Ceram. Soc., 88, 1892-99 (2005)... 

---