Polystyrene ion exchange

Example 2 Chromatography of nitroaniline isomers. The elution order of the nitroaniline isomers was ortho, meta, and para in normal-phase liquid chromatography using H-butanol-w-hexane mixtures as the eluent, when the stationary phase material was either silica gel, alumina, an ion-exchanger, polystyrene gel, or octadecyl-bonded silica gel. The results indicate that the separation of these compounds can be performed on a range of different types of stationary phase materials if the correct eluent is selected. The best separation will be achieved by the right combination of stationary phase material and eluent.68... 

Diol-modified sfiica gel Cellulose-based ion exchangers Polystyrene-based ion exchangers Ammonium tungstophosphate Sfiica gel impregnated with paraffin, silicon, and plant oils Silanized silica gel impregnated with anionic and cationic surfactants... 

Diol-modified silica gel Cellulose-based ion exchangers Polystyrene-based ion exchangers Ammonium tungstophosphate... 

Figure 3. Potentiometric Titration of Ion-Exchanged Polystyrene Latexes, (a) latex A-2 (b) latex D-4.

Other experiments were carried out to determine if excess emulsifier can be seen in the electron micrographs of the latex dispersions. Earlier work (9) had shown that sodium lauryl sulfate in 10% concentration (based on polymer) could be detected as an amorphous contaminant in an un-ion-exchanged polystyrene latex. Much smaller concentrations of emulsifier, i.e., corresponding to surface saturation or less, could also be observed, but only after staining with uranyl acetate (10). In the present work, 400 g of the 176oX-dia-... 

Alternatively the ion exchanger may be a synthetic polymer, for example a sulphonated polystyrene, where the negative charges are carried on the —SO3 ends, and the interlocking structure is built up by cross-linking between the carbon atoms of the chain. The important property of any such solid is that the negative charge is static—a part of the solid—whilst the positive ions can move from their positions. Suppose, for example, that the positive ions are... 

Ion-exchange separations can also be made by the use of a polymer with exchangeable anions in this case, the lanthanide or actinide elements must be initially present as complex ions (11,12). The anion-exchange resins Dowex-1 (a copolymer of styrene and divinylben2ene with quaternary ammonium groups) and Amherlite IRA-400 (a quaternary ammonium polystyrene) have been used successfully. The order of elution is often the reverse of that from cationic-exchange resins. 

The organic and aqueous phases are prepared in separate tanks before transferring to the reaction ketde. In the manufacture of a styrenic copolymer, predeterrnined amounts of styrene (1) and divinylbenzene (2) are mixed together in the organic phase tank. Styrene is the principal constituent, and is usually about 90—95 wt % of the formulation. The other 5—10% is DVB. It is required to link chains of linear polystyrene together as polymerization proceeds. DVB is referred to as a cross-linker. Without it, functionalized polystyrene would be much too soluble to perform as an ion-exchange resin. Ethylene—methacrylate [97-90-5] and to a lesser degree trivinylbenzene [1322-23-2] are occasionally used as substitutes for DVB. 

Most ion exchangers in large-scale use are based on synthetic resins—either preformed and then chemically reacted, as for polystyrene, or formed from active monomers (olefinic acids, amines, or phenols). Natural zeolites were the first ion exchangers, and both natural and synthetic zeolites are in use today. 

TABLE 16-8 Self Diffusion Coefficients in Polystyrene-divinylbenzene Ion Exchangers... 

Ion-exchange Resins. An ion-exchange resin is made up of particles of an insoluble elastic hydrocarbon network to which is attached a large number of ionisable groups. Materials commonly used comprise synthetic ion-exchange resins made, for example, by crosslinking polystyrene to which has been attached non-... 

Ion exchange resins are also useful for demineralising biochemical preparations such as proteins. Removal of metal ions from protein solutions using polystyrene-based resins, however, may lead to protein denaturation. This difficulty may be avoided by using a weakly acidic cation exchanger such as Bio-Rex 70. 

Ion Exchange Resins - Spectra/Gel Ion Exchange resins are ion exchange media for use in low-pressure liquid chromatography. They are based on a polystyrene/divinylbenzene support and are available for both anion and cation exchange applications. This site will give you a reasonable... 

Organic traps contain isoporous, macroporous, or other specifically designed resins (such as reticulated, cross-linked polystyrene resins devoid of ionic function) and take up organics by a combination of ion exchange, adsorption, and other mechanisms. They typically are installed to precede the DI plant. 

A very similar idea is the use of ion exchanging polymers into which redox active ions can be incorporated by equilibration with an adherent solution. Sulfonated perfluoro polymers (Nafion), polyvinylsulfonic acid , and polystyrene... 

---