Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Integral intensities of the

The vibration frequencies of C-H bond are noticeably higher for gaseous thiazole than for its dilute solutions in carbon tetrachloride or tor liquid samples (Table 1-27). The molar extinction coefficient and especially the integrated intensity of the same peaks decrease dramatically with dilution (203). Inversely, the y(C(2jH) and y(C(5(H) frequencies are lower for gaseous thiazole than for its solutions, and still lower than for liquid samples (cf. Table 1-27). [Pg.61]

There is a degeneracy factor of two associated with a n orbital compared with the nondegeneracy of a (7 orbital, so that it might be expected that the integrated intensity of the second band system would be twice that of each of the other two. However, although the second band system is the most intense, other factors affect the relative intensities so that they are only an approximate guide to orbital degeneracies. [Pg.302]

Percent Crystallinity. For samples that consist of a mixture of crystalline and amorphous material, it is possible to determine the percent of crystallinity by measuring the integrated intensity of sharp Bragg reflections and the integrated intensity of the very broad regions due to the amorphous scattering. [Pg.380]

If we further assume that the vibrational wavefunctions associated with normal mode i are the usual harmonic oscillator ones, and r = u + 1, then the integrated intensity of the infrared absorption band becomes... [Pg.276]

Fig. 4.3. The change of the integral intensities of the components (a) and their widths (b) with p oc n (the broken lines belong to the broader component of the collapsed doublet). Fig. 4.3. The change of the integral intensities of the components (a) and their widths (b) with p oc n (the broken lines belong to the broader component of the collapsed doublet).
In a gas V2 oc V2zc/ o where V2 is the maximum strength of the interparticle interaction on collision. Hence / (0) as well as V2 oc 1 /z0 oc n increases with buffer gas density. The integral intensity of the forbidden line is... [Pg.145]

Katritzky, Topsom, and co-workers (14) have reported correlation of the integrated intensities of the 1600 cm" benzene skeletal vibration of substituted... [Pg.39]

In the spectrum of fully reductively [ C] methylated glycophorin A, the resonance at 42.8 p.p.m. must correspond to the N, N -di[ C]methylated, N-terminal amino acid residue. The ratio of the integrated intensities of the N, N -di[ C]methylLeu resonance to the N, N -di[ C]methyllysine resonances is 5 1, as expected. The integration values determined were valid, because the recycle times of spectra in Figs. 3B, 3C, and 3D were twice the spin-lattice relaxation-times (Tj values) of those of the di[ C]methyl carbon atoms, and also because the n.O.e. values of the N, N -di[ C]methyl and N, N -di[ C]methyl carbon atoms were equivalent. ... [Pg.181]

The concentration of surface sites was measured by the integral intensity of the CO absorbance band using the formula C [pmol/g] = A/Aq, where A is the integral intensity of the CO stretching band and Aq is the coefficient of the integral absorbance [6]. Concentrations are measured to within 20%. [Pg.88]

Catalyst Study. Equivalent amounts of p-phenylenebis(4,4-dimethyl-2-oxazol1n-5-one ) (2) and Jeffamine D-2000 (polyoxypropylenediamine from Texaco Chemical Co., amine equiv. weight 1023) were mixed with 5 mole % of the desired catalyst. The stirred mixture was heated at 240°C under argon for 30 minutes, then an additional 1.5 hours under vacuum (<1 torr) and collected. The amount of cyclization was estimated by 1H-NMR in CDC 13 by comparison of the Integrated intensities of the absorptions due to the gem-dimethyl substituents. These absorptions appeared at 1.39 ppm in the cyclic form and at 1.73 ppm in the open-chain form of the polymer (see Scheme 4). Results are listed in Table I. [Pg.120]

Fig. 4. Anaerobic titration of xanthine oxidase with xanthine at pH 8.2 with a reaction time of 2 min. at about 20°. The integrated intensity of the Rapid molybdenum EPR signals (in arbitrary units) is plotted against the number of moles of xanthine added per mole of active enzyme. Activity/A4jo for the enzyme samples used was 112 corresponding to an active enzyme content of 57%. Thus the molar ratios of xanthine/total xanthine oxidase have been multiplied by 1.76 to refer to the active form only. Some of the EPR spectra (recorded at about — 130° and 9.3 GHz) are reproduced to show the changes in signal type as the amount of xanthine is increased. (Data re-calculated from ref. 88, with intensities corrected for variations in tube diameter and enzyme concentration calculated in terms of active enzyme.)... Fig. 4. Anaerobic titration of xanthine oxidase with xanthine at pH 8.2 with a reaction time of 2 min. at about 20°. The integrated intensity of the Rapid molybdenum EPR signals (in arbitrary units) is plotted against the number of moles of xanthine added per mole of active enzyme. Activity/A4jo for the enzyme samples used was 112 corresponding to an active enzyme content of 57%. Thus the molar ratios of xanthine/total xanthine oxidase have been multiplied by 1.76 to refer to the active form only. Some of the EPR spectra (recorded at about — 130° and 9.3 GHz) are reproduced to show the changes in signal type as the amount of xanthine is increased. (Data re-calculated from ref. 88, with intensities corrected for variations in tube diameter and enzyme concentration calculated in terms of active enzyme.)...
Figure 7 Hydroperoxide index (HI) determined from mid-infrared spectroscopy (ratio of the integrated intensity of the 3,552 cm 1 band to the integrated intensity of the band at 2,010 cm-1) as a function of total hydroperoxide content measured by iodiometric titration. Figure 7 Hydroperoxide index (HI) determined from mid-infrared spectroscopy (ratio of the integrated intensity of the 3,552 cm 1 band to the integrated intensity of the band at 2,010 cm-1) as a function of total hydroperoxide content measured by iodiometric titration.
The integrated intensities of the fitted component peaks should then be related to the electron population of different valence states, subject to correction factors, according to the same equation used earlier for quantitative analysis of survey XPS spectra (Eq. 3) [10]. Because photoelectron KEs are similar throughout the valence band region, spectrometer-dependent factors and IMFP values can be assumed to be the same for all states, so that the equation simplifies to ... [Pg.107]

Fig. 12 Plot of the mean integrated intensity of the salicylic acid peaks as a function of the weight percent of salicylic acid in the hydrogel formulations. (O) Peak I contains lines with d-spacings of 3.58, 3.53, and 3.52 A ( ) peak II contains lines with d-spacings of 2.95,2.91, and 2.88 A. (Reproduced with permission of the copyright owner, Elsevier, from Ref. 58.)... Fig. 12 Plot of the mean integrated intensity of the salicylic acid peaks as a function of the weight percent of salicylic acid in the hydrogel formulations. (O) Peak I contains lines with d-spacings of 3.58, 3.53, and 3.52 A ( ) peak II contains lines with d-spacings of 2.95,2.91, and 2.88 A. (Reproduced with permission of the copyright owner, Elsevier, from Ref. 58.)...
Relation (3.1.25) for the integral intensity of the /th spectral line for s- and p-polarized radiation is conveniently expressed in terms of polarization vectors (3.3.3) ... [Pg.68]

The checkers used a 40-cm. spinning-band column. The product, n2bD 1.4237, was shown to be 98.9% pure by gas-liquid chromatography on a 6-ft. 20% fluorosilicone column. The retention time was 3.75 minutes with a flow rate of helium of 100 ml. per minute, and a column temperature of 125° with the injection port at 170°. The 19 F n.m.r. spectrum (56.4 MHz) consists of four lines of equal intensity centered at +3396 Hz from trichlorofluoromethane (internal) and two sets of two overlapping quartets centered at +4369 Hz and +4461 Hz, respectively. The integrated intensities of the three sets of fluorine resonances are 3 1 1. [Pg.60]

The percent conversion of the monomer to the polypeptide can be estimated by the quantity 100 (Aq - At) / Aq, where Aq and At are the integrated intensities of the ester band at the start and time t, respectively. At 40 °C, it tended to saturate at about 30 % for the Y-type films of L-NaphAla-C-i s, and L-PyrAla-G 8, although the conversion for the LB film of long-chain ester of alanine (L-Ala- Ci s) reached to 90 % [52]. This difference is considered to be due to a larger steric hindrance of the aromatic rings. [Pg.116]


See other pages where Integral intensities of the is mentioned: [Pg.724]    [Pg.1373]    [Pg.1539]    [Pg.80]    [Pg.144]    [Pg.133]    [Pg.114]    [Pg.515]    [Pg.627]    [Pg.39]    [Pg.186]    [Pg.267]    [Pg.492]    [Pg.492]    [Pg.495]    [Pg.534]    [Pg.538]    [Pg.515]    [Pg.7]    [Pg.293]    [Pg.172]    [Pg.192]    [Pg.263]    [Pg.204]    [Pg.198]    [Pg.57]    [Pg.58]    [Pg.81]    [Pg.117]    [Pg.308]    [Pg.304]    [Pg.95]    [Pg.308]    [Pg.312]   


SEARCH



Integrated intensity

Integrity intensity

Integrity of the

The Integral

© 2024 chempedia.info