Inspection tools

Inspect tools regularly. If a tool shocks, smokes, smells, or sparks, do not use it. 

Chapter IV Guide for Inspection of Refinery Equipment—Inspection Tools... 

Callister, W. G., Corrosion Monitoring by Non-Destructive Testing as an Inspection Tool and Means of Loss Prevention , Bull. Inst. Corrosion Science and Tech. Issue 52, pp 2-12, August (1975)... 

It is not the intent of this chapter to review in detail the types of inspection tools, techniques, and procedures. Recent American Petroleum Institute publications, available at moderate costs, do an excellent job in that respect. 

The inspection of piping is very well covered in the practical American Petroleum Institutes (API) Recommended Practice 574, Inspection of Piping, Tubing, Valves, and Fittings. [20] The recommended practice addresses the description of piping components, causes of deterioration, frequency of inspection, inspection tools, inspection procedures, and record keeping. 

TABLE 363 Example checklist of test facility selection and inspection tools prior to scheduling audit... 

Very small scratches are not seen by a defect inspection tool. A conformal etch process such as a wet etch using dilute HF will enlarge the small scratches and make them visible under the defect inspection tool. The longer the etch process, the more visible the scratches become as shown in Fig. 17.6. The etch process was conducted step by step to reveal more and more of the level II and possibly some level I scratches. 

The copper surface roughness can be a problem for the defect inspection tools. When the sensitivity of the defect inspection tool is increased in order to detect smaller defects, the tool may view copper roughness as a defect. The real defects may be lost in the crowd. In order not to miss the smaller defects, it is important to lower the copper surface roughness as much as possible during... 

Following the grinding or CMP process, the oxide thickness was measured by the conventional measurement tool using optical interference and the planarity was characterized by the profilometer. For the defect analysis, the defect inspection tool based on light scattering and AFM was used. 

AWIS-SQM It is viewed as a next-generation multifunchonal inspection tool can be used in a 200 mm or 300 mm wafer has multifunctional inspection capability and is mainly used in measurement of particle, haze, and nanotopography. 

In addition, important knowledge has been gained from the expert evaluations conducted on the materials and the components, after 100 000 hours of operation in real use conditions. Likewise, the methodology developed to extend plant lifetime, and the development of special inspection tools have resulted in significant progress for R D and greatly increased expertise from which the entire nuclear programme will benefit. 

Weeki Discuss location of safety lock, tags and procedures Demonstrate correct lifting Inspect tools for damage or worn surfaces Review an HMIS label on a product in your cell... 

The purpose of the project evaluation tree is to provide a relatively simple, straightforward, and efficient method of performing an in-depth evaluation or analysis of a project or operation. It is best suited for performing operating hazard analysis and accident analysis. It can also be a valuable review and inspection tool. If adequate information is available, PET analysis may be helpful in performing preliminary hazard analysis, subsystem hazard analysis, and system hazard analysis. 

Regularly inspect tools, cords, grounds, and accessories. 

Review appropriate safety procedures and PPE considerations. Inspect tools and ensure all PPE meets safety standards. 

---