Impedance linearity

The realized experiments and the obtained results showed that measures by eddy currents present a linear relation between the evolution of the cementation thickness character and the impedance variation. 

Operational amplifier. A linear, high-gain DC voltage or current amplifier with high input impedance, low output impedance, and the capability of producing a bipolar output from a bipolar input. 

There are important figures of merit (5) that describe the performance of a photodetector. These are responsivity, noise, noise equivalent power, detectivity, and response time (2,6). However, there are several related parameters of measurement, eg, temperature of operation, bias power, spectral response, background photon flux, noise spectra, impedance, and linearity. Operational concerns include detector-element size, uniformity of response, array density, reflabiUty, cooling time, radiation tolerance, vibration and shock resistance, shelf life, availabiUty of arrays, and cost. 

If the cross-sectional area of the product remains relatively constant but the product layer cracks during growth and so does not impede the access of the gaseous reactairts aird products to the reacting solid, then a linear rate law is observed... 

Generally the material response stress versus particle velocity curves in Fig. 8.6 are nonlinear and either a graphical or more complicated analytic method is needed to extract a spall strength, Oj, from the velocity or stress profile. When behavior is nominally linear in the region of interest a characteristic impedance (Z for the window and for the sample) specify material... 

Both polymers are linear with a flexible chain backbone and are thus both thermoplastic. Both the structures shown Figure 19.4) are regular and since there is no question of tacticity arising both polymers are capable of crystallisation. In the case of both materials polymerisation conditions may lead to structures which slightly impede crystallisation with the polyethylenes this is due to a branching mechanism, whilst with the polyacetals this may be due to copolymerisation. 

Physical tests of film impedance using an a.c. bridge have also been recommended, although the correlation with corrosion resistance is necessarily empirical. Film impedance increases at an approximately linear rate with sealing time and film thickness. 

Impedance Some of the errors arising from the use of linear polarisation resistance led to interest and development in a.c. systems.An early development used a fixed a.c. frequency and a commercial instrument was produced in the UK. Inaccuracies still occurred, however, and were due to the electrode impedance which is fequency dependent. Electrode reactions have a capacitance component, in addition to resistance, resulting in a requirement to measure the impedance. However, the total impedance comprises values for the reaction, solution, diffusion and capacitance. Measurements at different frequency are more reliable, particularly where high solution resistances occur. Simplifications for industrial monitoring have been developed consisting of two measurements, i.e. at a high (10 kHz) and low frequency (0-1 Hz). The high-frequency measurement can identify the... 

The hot-ER test refers to measuring the impedance of a separator while the temperature is linearly increased this technique was first used by Laman et al. [5]. Figure 4 shows actual measurements for some Celgard membranes [20], The single-layer materials exhibit a sharp rise in impedance near their respective melting points the impedance goes back down after a maximum value has been reached. 

The electrical double layer at Hg, Tl(Ga), In(Ga), and Ga/aliphatic alcohol (MeOH, EtOH) interfaces has been studied by impedance and streaming electrode methods.360,361 In both solvents the value ofis, was independent of cei (0.01 < cucio4 <0.25 M)and v. The Parsons-Zobel plots were linear, with /pz very close to unity. The differential capacity at metal nature, but at a = 0,C,-rises in the order Tl(Ga) < In(Ga) < Ga. Thus, as for other solvents,120 343 the interaction energy of MeOH and EtOH molecules with the surface increases in the given order of metals. The distance of closest approach of solvent molecules and other fundamental characteristics of Ga, In(Ga), Tl(Ga)/MeOH interfaces have been obtained by Emets etal.m... 

The BiDER/DMSO + LiC104 interface has been studied by impedance and a very well-developed diffuse layer minimum has been observed, with ,niB independent of cyao/75 The capacitance dispersion was no greater than 2 to 3% in the region -1.5 E< -0.3 V (SCE in H20). Linear Parsons-Zobel plots with/pz very close to unity were obtained, Q was independent of cya0j. 

The electrical double layer at BiDER/PrOH and BiDER/2-PrOH interfaces with the addition of various electrolytes (LiC104> Lil, LiSCN, KSCN) has been studied using impedance.691-693 The Emj was independent of cei and v. A weak dependence of C on v has been found at cucio4 < 0- 1 M and at a > -0.03 C m 2, and the equilibrium differential capacitance C o has been obtained by linear extrapolation of C vs. tu,/2 to co1/2 = 0. Parsons-Zobel plots at a = 0 are linear, with/pz = 1.01 0.01. The values of cf have been obtained according to Grahame and Soder-... 

---