High resistivity water

It is advisable to use Dl water in the gel tank. The author has successfully cast many large batches of UF membranes using tap water in the quench bath. However, this often results in membrane product which is discolored (iron oxide) and variable with the seasons as the tap water quality changes. Dl water with an 18Mfi resistivity is the best standard. However, it must be borne in mind that high resistivity water will result in faster leach rates of solvent from the gelling casting solution which may affect the pore size of the final membrane. 

E. Dejan, E. Laktionov, J. Sandeaux, R. Sandeaux, G. Pourcelly and C. Gavach, Electrodemineralization with ion-exchange textile for the production of high resistivity water, Desalination, 1997,114, 165-173. 

Commercial production of PVA fiber was thus started in Japan, at as early a period as that for nylon. However, compared with various other synthetic fibers which appeared after that period, the properties of which have continuously been improved, PVA fiber is not very well suited for clothing and interior uses because of its characteristic properties. The fiber, however, is widely used in the world because of unique features such as high affinity for water due to the —OH groups present in PVA, excellent mechanical properties because of high crystallinity, and high resistance to chemicals including alkah and natural conditions. 

PWRs operate differendy from BWRs. In PWRs, no boiling takes place in the primary heat-transfer loop. Instead, only heating of highly pressurized water occurs. In a separate heat-exchanger vessel, heat is transferred from the pressurized water circuit to a secondary water circuit that operates at a lower pressure and therefore enables boiling. Because of thermal transfer limitations, ultimate steam conditions in PWR power plants ate similar to those in BWR plants. For this reason, materials used in nuclear plant steam turbines and piping must be more resistant to erosion and thermal stresses than those used in conventional units. 

Poly(vinyl acetate) emulsions are excellent bases for water-resistant paper adhesives destined for use in manufacturing bags, tubes, and cartons. Glue-lap adhesives, which require moderate-to-high resistance to water, exemplify this type. When routine water resistance is required, a homopolymer vinyl acetate emulsion containing a ceUulosic protective coUoid is effective for most purposes. Next effective are emulsions containing fuUy hydrolyzed poly(vinyl alcohol) as a protective coUoid, foUowed by those containing partiaUy hydrolyzed poly(vinyl acetate). 

The chemical corrosion resistance of Zr 704 is slightly less than that of Zr 702 in some environments but Zr 704 is superior in high temperature, high pressure water, and steam. A softer version of Zr 705 is Zr 706, developed specifically for severe forming appUcations such as panel-type heat exchangers. 

Materials of Construction. Glass has excellent corrosion-resistance to wet or dry bromine. Lead is very usefiil for bromine service if water is less than 70 ppm. The bromine corrosion rate increases with concentrations of water and organics. Tantalum and niobium have excellent corrosion-resistance to wet or dry bromine. Nickel has usefiil resistance for dry bromine but is rapidly attacked by wet bromine. The fluoropolymers Kynar, Halar, and Teflon are highly resistant to bromine but are somewhat permeable. The rate depends on temperature, pressure, and stmcture (density) of fluoropolymer (63). 

Aluminum has high resistance to atmospheric conditions as well as to industrial fumes and vapors and fresh, brackish, or salt waters. Many mineral acids attack aluminum, although the metal can be used with concentrated nitric acid (above 82 percent) and glacial acetic acid. Aluminum cannot be used with strong caustic solutions. 

Cork compositions 250 Low cost. Truly compressible materials which permit substantial deflections with negligible side flow. Conform well to irregular surfaces. High resistance to oils good resistance to water, many chemicals. Should not be used with inorganic acids, alkalies, oxidizing solutions, live steam. 

---