Heat deflection/distortion temperature softening point

Various thermal material properties (as opposed to thermal stability. Chapter 9) are discussed in Chapter 16. These include coefficient of expansion, melting temperature, Vicat softening point, heat deflection/distortion temperature by thermomechanical analysis, also brittleness temperature, minimum filming temperature, delamination temperature, meltflow index, heat of volatilisation, thermal conductivity, specific heat and ageing in air. 

Two particular test methods have become very widely used. They are the Vicat softening point test (VSP test) and the heat deflection temperature under load test (HDT test) (which is also widely known by the earlier name of heat distortion temperature test). In the Vicat test a sample of the plastics material is heated at a specified rate of temperature increase and the temperature is noted at which a needle of specified dimensions indents into the material a specified distance under a specified load. In the most common method (method A) a load of ION is used, the needle indentor has a cross-sectional area of 1 mm, the specified penetration distance is 1 mm and the rate of temperature rise is 50°C per hour. For details see the relevant standards (ISO 306 BS 2782 method 120 ASTM D1525 and DIN 53460). (ISO 306 describes two methods, method A with a load of ION and method B with a load of SON, each with two possible rates of temperature rise, 50°C/h and 120°C/h. This results in ISO values quoted as A50, A120, B50 or B120. Many of the results quoted in this book predate the ISO standard and unless otherwise stated may be assumed to correspond to A50.)... 

To enhance the resistance to heat softening his-phenol A is substituted by a stiffer molecule. Conventional bis-phenol A polycarbonates have lower heat distortion temperatures (deflection temperatures under load) than some of the somewhat newer aromatic thermoplastics described in the next chapter, such as the polysulphones. In 1979 a polycarbonate in which the bis-phenol A was replaced by tetramethylbis-phenol A was test marketed. This material had a Vicat softening point of 196 C, excellent resistance to hydrolysis, excellent resistance to tracking and a low density of about l.lg/cm-. Such improvements were obtained at the expense of impact strength and resistance to stress cracking. 

A very popular test method for measuring the softening point of plastics is the temperature of deflection under load test, also known as the heat distortion or HDT test, standardized in ISO 75 [138]. The standard is now published in three parts. Part 1 covering general principles. Part 2 for plastics and ebonite, and Part 3 for reinforced plastics. Part 3 will not be considered further in this chapter. 

Two particular test methods have become very widely used. These are the Vicat softening point test and the test widely known as the heat distortion temperature test (also called the deflection temperature under load test). In the Vicat softening point test a sample of polymer is heated at a specified rate temperature increase and the temperature is noted at which a needle of specified dimensions indents into the polymer a specified distance under a specified load. 

---