Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Halides transition-metal complexes

A variety of routes is available for the preparation of metal-thionitrosyl complexes. The most common of these are (a) reaction of nitride complexes with a sulfur source, e.g., elemental sulfur, propylene sulfide or sulfur halides, (b) reaction of (NSC1)3 with transition-metal complexes, and (c) reaction of [SN]" salts with transition-metal complexes. An example of each of these approaches is given in Eq. 7.1,... [Pg.123]

A variety of complexes of the thionyl imide anion [NSO] with both early and late transition-metal complexes have been prepared and structurally characterized. Since both ionic and covalent derivatives of this anion are readily prepared, e.g., K[NSO], McsMNSO (M = Si, Sn) or Hg(NSO)2, metathetical reactions of these reagents with transition-metal halide complexes represent the most general synthetic method for the preparation of these complexes (Eq. 7.10 and 7.11). ... [Pg.135]

As one would expect, in those cases in which the ionic liquid acts as a co-catalyst, the nature of the ionic liquid becomes very important for the reactivity of the transition metal complex. The opportunity to optimize the ionic medium used, by variation of the halide salt, the Lewis acid, and the ratio of the two components forming the ionic liquid, opens up enormous potential for optimization. However, the choice of these parameters may be restricted by some possible incompatibilities with the feedstock used. Undesired side reactions caused by the Lewis acidity of the ionic liquid or by strong interaction between the Lewis acidic ionic liquid and, for example, some oxygen functionalities in the substrate have to be considered. [Pg.222]

Acidic chloroaluminate ionic liquids have already been described as both solvents and catalysts for reactions conventionally catalyzed by AICI3, such as catalytic Friedel-Crafts alkylation [35] or stoichiometric Friedel-Crafts acylation [36], in Section 5.1. In a very similar manner, Lewis-acidic transition metal complexes can form complex anions by reaction with organic halide salts. Seddon and co-workers, for example, patented a Friedel-Crafts acylation process based on an acidic chloro-ferrate ionic liquid catalyst [37]. [Pg.225]

Metal complex-organic halide redox initiation is the basis of ATRP. Further discussion of systems in this context will be found in Section 9.4, The kinetics and mechanism of redox and photoredox systems involving transition metal complexes in conventional radical polymerization have been reviewed by Bam ford. [Pg.104]

Two commonly used synthetic methodologies for the synthesis of transition metal complexes with substituted cyclopentadienyl ligands are important. One is based on the functionalization at the ring periphery of Cp or Cp metal complexes and the other consists of the classical reaction of a suitable substituted cyclopentadienyl anion equivalent and a transition metal halide or carbonyl complex. However, a third strategy of creating a specifically substituted cyclopentadienyl ligand from smaller carbon units such as alkylidynes and alkynes within the coordination sphere is emerging and will probably find wider application [22]. [Pg.101]

The general mechanism of coupling reactions of aryl-alkenyl halides with organometallic reagents and nucleophiles is shown in Fig. 9.4. It contains (a) oxidative addition of aryl-alkenyl halides to zero-valent transition metal catalysts such as Pd(0), (b) transmetallation of organometallic reagents to transition metal complexes, and (c) reductive elimination of coupled product with the regeneration of the zero-valent transition metal catalyst. [Pg.483]

Transition metal complexes that are easy to handle and store are usually used for the reaction. The catalytically active species such as Pd(0) and Ni(0) can be generated in situ to enter the reaction cycle. The oxidative addition of aryl-alkenyl halides can occur to these species to generate Pd(II) or Ni(II) complexes. The relative reactivity for aryl-alkenyl halides is RI > ROTf > RBr > RC1 (R = aryl-alkenyl group). Electron-deficient substrates undergo oxidative addition more readily than those electron-rich ones because this step involves the oxidation of the metal and reduction of the organic aryl-alkenyl halides. Usually... [Pg.483]

Neutral transition-metal complexes that are not fully coordinatively saturated possess nucleophile metal centers capable of coordinating to electrophiles. On the other hand, group-IIIB halides serve as typical electron-pair acceptors and are, therefore, able to interact coordinatively with basic metal complexes. [Pg.55]

Neutral carboranes and boranes react with transition-metal complexes forming metallocarboranes or metalloboranes, respectively. However, most metallocarboranes and metalloboranes are prepared from transition-metal halides and anionic carborane and borane species ( 6.5.3.4) or by reacting metal atoms and neutral boranes and carboranes. These reactions are oxidative addition reactions ( 6.5.3.3). [Pg.82]

Divinylborane-transition-metal complexes ( 6.5.3.1) are accessible from metal halides and divinylboranes with simultaneous reduction by (t -Cp)2Co, e.g. ... [Pg.102]

It is the only example of a free, persistent phosphirenylium ion, and also, only one stable transition-metal complex of this species was published [78,79]. Quantum chemical calculations [80,81] indicated that in the halogeno-phosphirenes the P-X bonds already possesses a high ionic character and can be described as interactions between phosphirenylium and halide ions. The aromatic character of the phosphirenylium ion was shown to be based on a three-centre two-electron bond of 7i-type and the resonance energy was assessed by calculation to 38 kcal/mol. Before the generation of 32, substituted phosphirenylium ions were... [Pg.89]

A60. J. P. Candlin, K. A. Taylor, and D. T. Thompson, "Reactions of Transition-Metal Complexes. Elsevier, Amsterdam, 1968. A review of types of reactions of metal complexes (e.g., substitution, combination, redox) reactions with various reagents (e.g., hydrocarbons, halides, carbon monoxide, and isonitrile) and preparation of new stabilised organic systems (e.g., metallocenes, carbenes). Intended for research workers, consequently written at a fairly high level, with emphasis on organometallics. A61. H. J. Keller, NMR-Untersuchungen an Komplexverbindungen. Springer, Berlin, 1970. Expansion of review article 37.1. [Pg.448]

Like all controlled radical polymerization processes, ATRP relies on a rapid equilibration between a very small concentration of active radical sites and a much larger concentration of dormant species, in order to reduce the potential for bimolecular termination (Scheme 3). The radicals are generated via a reversible process catalyzed by a transition metal complex with a suitable redox manifold. An organic initiator (many initiators have been used but halides are the most common), homolytically transfers its halogen atom to the metal center, thereby raising its oxidation state. The radical species thus formed may then undergo addition to one or more vinyl monomer units before the halide is transferred back from the metal. The reader is directed to several comprehensive reviews of this field for more detailed information. [Pg.20]

The mechanism of the reaction of secondary alkyl halides with low-valent transition metal complexes is considerably more complex, and radical processes have been clearly identified in some cases (13, 14). [Pg.259]

Similarly, it was also found that radical polymerization was induced in the Ni(CO)3(PPh3)/CBrCl3 redox system [155]. This complex is soluble in the polymerization medium, and the polymerization proceeded in a homogeneous system. This redox iniferter system has been intensively developed to the recent successful living radical polymerization using transition-metal complexes in combination with alkyl halides by several independent research groups (see Sect. 6.2). [Pg.95]

Ge—metal bonds can be built in analogy as described for Ge—C bonds by the reaction of organolithium compounds with metal halides. With trans-dichlorobis(triethylphosphine)platinum(II), new germyl transition metal complexes were synthesized (equation 36)41. [Pg.548]

Water-soluble transition-metal complexes have been used recently for transfer hydrogenolysis of halocarbons. Paetzold and Oehme [110] have realized the reductive dehaiogenation of allyl or benzyl halides in the presence of [(phosphine) 2PdCl2] complexes with sulfonated phosphines as ligands (e.g., Ph2P(CH2)3S03K) by... [Pg.527]

Electrochemical methods are available for the direct dehalogenation of organic halides to a limited extent fluorides and monochlorides are generally not reducible [1], In the presence of transition-metal complexes as mediators (Med), however, the electrolysis of halocarbons (RX) can be performed more effectively and selectively under various conditions [155-158]. Mediated electroreduction is most efficient when the electron transfer step E° (Med/Med -) is more negative than E° (RX/RX -) [157] (cf. Section 18.4.1). [Pg.532]

In general, correlation corrections are larger for a holes than for ir holes. It is not unusual for these differential correlation effects to change the predicted order of final states. Heterocyclic organic molecules with nitrogen-centered, nonbonding electrons are not alone in this respect. Organometallics, transition metal complexes, and clusters of metal oxides and metal halides also require this kind of theoretical interpretation. [Pg.145]

Organic electroreductive coupling reactions using transition-metal complexes as catalysts have been widely investigated. Reviews on the subject have been published [89, 90]. The method involving the most common transition-metal complexes (nickel, cobalt, palladium) appears to be a useful tool to synthetize heterocycles from organic halides via radical intermediates. Nickel catalyst precursors are nickel(II) salts that are cathodically reduced either to nickel(I) or to nickel(O) and cobalt catalyst... [Pg.361]


See other pages where Halides transition-metal complexes is mentioned: [Pg.326]    [Pg.326]    [Pg.430]    [Pg.326]    [Pg.326]    [Pg.430]    [Pg.203]    [Pg.456]    [Pg.114]    [Pg.53]    [Pg.86]    [Pg.92]    [Pg.461]    [Pg.326]    [Pg.327]    [Pg.277]    [Pg.308]    [Pg.48]    [Pg.185]    [Pg.127]    [Pg.181]    [Pg.223]    [Pg.227]    [Pg.251]    [Pg.122]    [Pg.513]    [Pg.520]    [Pg.70]   
See also in sourсe #XX -- [ Pg.2 , Pg.5 , Pg.6 ]




SEARCH



Complex metal halide

From complex transition metal anions and halides

Halide complexation

Halides complex

Halides transition-metal

Halides transition-metal complex anion

Metal halide-complexed

Transition metal halides complex Lewis acid reagent

Transition metals, alkyl halide complexes

© 2024 chempedia.info