Furans as Substrates

5-Phenyl-2,3-dihydro-2,3-furandione (36) reacted with a, a -diaminomaleoni-trile in refluxing dioxane during 1 h to give 5-oxo-6-phenacyl-4,5-dihydro-2,3-pyrazinedicarbonitrile (37) in 68% yield several p-substituted-phenacyl analogues were made similarly in comparable yields.935 

---

The secochamigrane sesquiterpene laureacetal-C (215) provides a fitting introduction to the synthetic applications available to the intramolecular furan-carbonyl photocycloaddition. Initial investigations by Schreiber and Hoveyda used 3-substituted furans as substrates, and many of these were available themselves through the intermolecular photoaldol reaction (Section 2.4.5). ° For example, irradiation of... 

Rahm et al. describes the formylation of anisole (50% isolated yield) and alkylated benzenes in fair yield using acetone cyanohydrin (Eq 1.19). Similar to the Gattermann reaction no formylation is obtained with pyrrole and only traces of aldehydes were observed with phenol and furane as substrates. 

As we found that furan and thiophene substituted oximes can be used as substrates for the INOC reactions (Eq. 5) [29b] similarly, furan substituted nitro alkane 134 is also a good substrate for INOC reactions (Eq. 13) [40]. The furfuryl derivative 134, prepared via Michael addition of furfuryl alcohol to 4-methoxy- -nitrostyrene, was subsequently transformed without isolation of the intermediate nitrile oxide 135 to the triheterocyclic isoxazoline 136 as a 5 1 mixture of isomers in high yield. 

Dehydrobenzene or benzyne 158 can be trapped by all manner of species. 1,2-Dehydro-o-carborane 159 has been shown to undergo many of the same reactions as its two-dimensional relative, 1,2-dehydrobenzene. Although dehydroaromatic molecules can be formed in a variety of ways, synthetic pathways to 1,2-dehydro-o-carborane are quite limited. An effective procedure reported so far78 first forms the dianion by deprotonation of o-carborane with 2 equiv. of butyllithium. Precipitated dilithium carborane is then treated with 1 equiv. of bromine at 0°C to form the soluble bromo anion 160. Thermolysis of 160 with anthracene, furan, and thiophene as substrates leads to the adducts 161-164.79 80 1,2-Dehydro-o-carborane reacts with norbomadiene to give both homo 2+4 and 2+2 addition, leading to three products 165-167, in a 7 1 ratio79. An acyclic diene, 2,3-dimethyl-... 

The reaction between the copper derivative of pentafluorobenzene and chloracetyl chloride (ammonia as base) produces a little of the highly stable furan 8, an unusual result that has been regarded very tentatively as a Feist-Benary reaction with Cf,F5COCH2Cl as substrate.48... 

Katritzky and his colleagues have used equilibrium proto nation to estimate the aromaticity of furan and similar heterocycles using 2,5-di-tert-butylfuran as substrate in sulfuric acid. In agreement with the foregoing discussion, the furan does not behave as a Hammett (i.e., oxygen) base but as a carbon base similar to azulene. On Reagan s Hc scale, the furan gave n = 1.22, correspond-... 

Along with some disubstituted furan 59, mono-arylation product 58 was isolated when 2-chloro-3,6-diethylpyrazine (57) and furan were refluxed in the presence of Pd(Ph3P)4 and KOAc. In the case of 2-chloro-3,6-dimethylpyrazine (23) and thiophene, monothienylpyrazine 60 was the sole product. When 2-chloro-3,6-diisobutylpyrazine was used as substrate, 9% of the disubstituted thiophene was detected. Analogous to the couplings with furan and thiophene, the heteroaryl... 

The use of cyclic alkenes as substrates or the preparation of cyclic structures in the Heck reaction allows an asymmetric variation of the Heck reaction. An example of an intermolecular process is the addition of arenes to 1,2-dihydro furan using BINAP as the ligand, reported by Hayashi [23], Since the addition of palladium-aryl occurs in a syn fashion to a cyclic compound, the 13-hydride elimination cannot take place at the carbon that carries the phenyl group just added (carbon 1), and therefore it takes place at the carbon atom at the other side of palladium (carbon 3). The normal Heck products would not be chiral because an alkene is formed at the position where the aryl group is added. A side-reaction that occurs is the isomerisation of the alkene. Figure 13.20 illustrates this, omitting catalyst details and isomerisation products. 

Similarly, 4-(furan-2-ylmethylene)-2-phenyl-1 -substituted-5(477)-imidazolones 820, evaluated as antibacterial and antifungal agents, have been synthesized from the 4-(furan-2-yhnethylene)-2-phenyl-5(4//)-oxazolone 819 (Scheme 7.253). ° Using 4-arylmethylene-2-phenyl-5(4//)-oxazolones as substrates and 2-amino-5-methyl-l,3,4-thiadiazoles as nucleophiles the synthesis of the corresponding... 

Cyclopentadienes, 1,3-cyclohexadienes, 1,3-cycloheptadienes, as well as furan and aklyl-substituted furans, have been investigated as substrates of photosensitized oxygenation reactions, while aromatic compounds such as anthracenes and tetracenes as well as aryl-substituted carbo-and heterocyclic pentadienes were studied in direct and indirect (photosensitized) photooxygenation reactions. 

With many heterocycles as substrates, radical substitutions can be successfully carried out under the conditions of phase-transfer Gomberg-Bachmann reactions [145]. Again, as above, mainly aryl and heteroaryl halides have recently been used as precursors for heterobiaryl compounds. A study including the arylation of a large number of heterocycles in the presence of tributyltin hydride and catalytic benze-neselenol led to the results that mostly biaryl products are obtained from nitrogen-containing heterocycles, whereas furan and thiophene gave partially dearomatized compounds [155]. 

Z)-Enynols can also be employed as substrates when ruthenium or iridium catalysts are used <2006ASC1671>. Furan-2-acetic esters are obtained by a Pd(n)-catalyzed oxidative cyclization-alkoxycarbonylation of (Z)-enynols <1999JOC7693>. In analogy, 2-furan-2-ylacetamides are obtained in an aminocarbonylation with secondary amines (Equation 22) <2006S4247>. 

A Pd-catalyzed oxidative cyclization of phenols with oxygen as stoichiometric oxidant in the noncoordinating solvent toluene has been developed for the synthesis of dihydrobenzo[ ]furans (Equation 136). Asymmetric variants of this Wacker-type cyclization have been reported by Hayashi and co-workers employing cationic palladium/2,2 -bis(oxazolin-2-yl)-l,l -binaphthyl (boxax) complexes <1998JOC5071>. Stoltz and co-workers have reported ee s of up to 90% when (—)-sparteine is used as a chiral base instead of pyridine <2003AGE2892, 2005JA17778>. Attempts to effect such a heteroatom cyclization with primary alcohols as substrates, on the other hand, led to product mixtures contaminated with aldehydes and alkene isomers, which is in contrast to the reactions with the Pd(ii)/02 system in DMSO <1995TL7749>. 

This protocol could be directly applied in the addition of 2 silyloxy furans to keti mines and the generation of a quaternary chiral center. Using electronically highly activated a ketoimine esters 24 as substrates, the same chiral silver phosphine catalyst (10mol%) as previously used in reactions with aldimines delivered the desired Mannich products in good yields, good diastereoselectivity, and up to 94% ee (Table 5.3) [9]. 

Furans have occasionally been used as substrates for pyrimidine syntheses which involve acyclic intermediates as in most of the other ring structures used in the construction of the pyrimidine ring . In the furan example shown (Scheme 92), A(-butylisomaleimide was reacted with trimethylsilyl azide, when the A 3-butyluracil (579) was formed after simple removal of the A(l-silyl group <72JOC1738>. 

Clay-catalyzed Diels-Alder reactions were thoroughly investigated by Laszlo and co-workers. Of particular interest are reactions with furans [14] or acrolein [15] as substrate catalyzed by iron(III)-exchanged KIO montmorillonite. Some represen-... 

The first carbon addition to allenes catalyzed by gold was described by Hashmi and was the addition of furans to allenones, a reaction that is discussed as a conjugate addition to carbonyls. Then the annulation of 2-allenyl indoles was described (equation 111)and an enantioselective version was later developed for terminal allenes. Then Nelson described the cyclization of an N-substituted pyrrol in the synthesis of (—)-Rhazinilam (equation 112). In that case, gold notably improved the yields and selectivities obtained with Pd(II) or Ag(l), and gave complete retention of the chiral information of the allene. The most recent report is on the hydroarylations of allenes with gold-covered substituted benzenes as substrates. ""... 

The term carbocyclic nucleoside [181] is used to describe a group of compounds structurally related to nucleosides in which the furanose ring has been replaced by a cyclopentane ring. A consequence of this substitution is an enhancement of the metabolic stability of the carbocyclic nucleosides, which are not subjected to the action of nucleoside phosphorylases and hydrolases that cleave normal nucleosides. However, from the conformational point of view the tetrahydro-furan and cyclopentane rings are similar. Thus, carbocyclic nucleosides may act as substrates or inhibitors of the enzymes that activate (kinases) and transform nucleosides and nucleotides in living cells and incorporate them into DNA. Most approaches to the synthesis of carbocyclic nucleosides begin with the construction of the nucleic acid base from a functionalized cyclopentylamine, which with some exceptions is obtained as a racemic mixture. The medicinal chemistry of carbocyclic nucleosides, as well as the synthesis of the intermediate cyclopentylamines have been reviewed [181]. This section deals only with work published after that review, directly related with anti-AIDS research. 

---