Fourth-order coherent Raman

Fourth-Order Coherent Raman Scattering at Buried Interfaces... 

Raman excitation. and I2s are the high-frequency and low-frequency components of the pump light pulse. A probe pulse of frequency 12 interacts with the coherence to present the optical response of the fundamental frequency 12 + C0fsl2. (c) Fourth-order coherent Raman scattering, the optical response of the second harmonic frequency 212 + co 2I2 is modulated by the vibrational coherence. 

Figure 6.2 A fourth-order coherent Raman spectrometer constructed with a Ti sapphire regenerative amplifier (Ti sapphire) and noncollinear optical parametric amplifier (NOPA).

The fourth-order coherent Raman spectrum of a liquid surface was observed by Fujiyoshi et al. [28]. The same authors later reported a spectrum with an improved signal-to-noise ratio and different angle of incidence [27]. A water solution of oxazine 170 dye was placed in air and irradiated with light pulses. The SH generation at the oxazine solution was extensively studied by Steinhurst and Owrutsky [24]. The pump and probe wavelength was tuned at 630 nm to be resonant with the one-photon electronic transition of the dye. The probability of the Raman transition to generate the vibrational coherence is enhanced by the resonance. The efficiency of SH generation is also enhanced. 

In the time-domain detection of the vibrational coherence, the high-wavenumber limit of the spectral range is determined by the time width of the pump and probe pulses. Actually, the highest-wavenumber band identified in the time-domain fourth-order coherent Raman spectrum is the phonon band of Ti02 at 826 cm. Direct observation of a frequency-domain spectrum is free from the high-wavenum-ber limit. On the other hand, the narrow-bandwidth, picosecond light pulse will be less intense than the femtosecond pulse that is used in the time-domain method and may cause a problem in detecting weak fourth-order responses. 

Successful applications of fourth-order coherent Raman scattering are presented. Interface-selective detection of Raman-active vibrations is now definitely possible at buried interfaces. It can be recognized as a Raman spectroscopy with interface selectivity. Vibrational sum-frequency spectroscopy provides an interface-selective IR spectroscopy in which the vibrational coherence is created in the IR resonant transition. The two interface-selective methods are complementary, as has been experienced with Raman and IR spectroscopy in the bulk. 

Although Raman spectroscopy does not employ absorption of infrared radiation as its fundamental principle of operation, it is combined with other infrared spectroscopies into a joint section. Results obtained with various Raman spectroscopies as described below cover vibrational properties of molecules at interfaces complementing infrared spectroscopy in many cases. A general overview of applications of laser Raman spectroscopy (LRS) as applied to electrochemical interfaces has been provided [342]. Spatially offset Raman spectroscopy (SORS) enables spatially resolved Raman spectroscopic investigations of multilayered systems based on the collection of scattered light from spatial regions of the samples offset from the point of illumination [343]. So far this technique has only been applied in various fields outside electrochemistry [344]. Fourth-order coherent Raman spectroscopy has been developed and applied to solid/liquid interfaces [345] applications in electrochemical systems have not been reported so far. 

To ensure interface-selective detection of the Raman-pumped vibrational coherence, one more incident electric field is required. A fourth-order optical response is thereby generated. The requirement is fulfilled by observing the second harmonic (SH) light generated at the interface, instead of the transmitted fundamental light. 

Ifourth(fd, 2 Q) was multiplied with a window function and then converted to a frequency-domain spectrum via Fourier transformation. The window function determined the wavenumber resolution of the transformed spectrum. Figure 6.3c presents the spectrum transformed with a resolution of 6cm as the fwhm. Negative, symmetrically shaped bands are present at 534, 558, 594, 620, and 683 cm in the real part, together with dispersive shaped bands in the imaginary part at the corresponding wavenumbers. The band shapes indicate the phase of the fourth-order field c() to be n. Cosine-like coherence was generated in the five vibrational modes by an impulsive stimulated Raman transition resonant to an electronic excitation. 

Plenary 16. N I Koroteev etal, e-mail address Koroteev ,nik.phys.msu.su (CARS/CSRS, CAHRS, BioCARS). A survey of the many applications of what we call the Class 11 spectroscopies from third order and beyond. 2D and 3D Raman imaging. Coherence as stored information, quantum information (the qubit ). Uses terms CARS/CSRS regardless of order. BioCARS is fourth order in optically active solutions. 

Coherent Raman effects originate in the third-order susceptibility fourth-rank tensor) which is the bulk version of the second molecular hyperpolarizability gufifi in (4.1). For the general non-... 

---