Extraction hydroxylamines

The largest proportion of the total Fe was removed by ammonium oxalate, which attacks the amorphic fraction of iron oxide in the sediments (23). Among the low pH extractants, hydroxylamine was the least efficient in extracting Fe. The difference between the extraction of Fe by acid and extraction by hydroxylamine was related to the crystallinity of the hydrous iron oxide. As pure iron oxides aged (and crystallized) in the laboratory, Fe solubility in hydroxylamine declined relative to solubility in acetic acid (Table III). In San Francisco Bay sediments, the ratio of hydroxylamine-soluble Fe to acetic acid-soluble Fe increased during the period of maximum runoff to the estuary (27) suggesting the proportion of the Fe in the sediments that was freshly precipitated varied seasonally. This was expected, since periods of heavy runoff are also times of maximum Fe movement from the watershed to the tributaries of the estuary ( ). 

Place 80 g, of hydroxylamine sulphate (or 68-5 g. of the hydrochloride), 25 g. of hydrated sodium acetate, and 100 ml. of water in a 500 ml. flask fitted with a stirrer and a reflux water-condenser, and heat the stirred solution to 55-60°. Run in 35 g (42 nil,) of -hexyl methyl ketone, and continue the heating and vigorous stirring for ij hours. (The mixture can conveniently be set aside overnight after this stage.) Extract the oily oxime from the cold mixture twice with ether. Wash the united ethereal extract once with a small quantity of water, and dry it with sodium sulphate. Then distil off the ether from the filtered extract, preferably using a distillation flask of type shown in Fig. 41 (p. 65) and of ca, 50 ml, capacity, the extract being run in as fast as the ether distils, and then fractionally distil the oxime at water-pump pressure. Collect the liquid ketoxime, b.p. 110-111713 mm. Yield, 30-32 g. 

Dissolve 5 g. of hydroxylamine hydrochloride in 10 ml. of water in a small conical flask and add a solution of 3 g. of sodium hydroxide in 10 ml. of water. Cool the solution in cold or ice water, and add 6 g. (7-6 ml.) of acetone slowly. Cool the flask, shake well, and leave overnight, during which time the oxime may crystallise out. If no crystals appear, cork the flask and shake vigorously when the acetoxime usually separates as colourless crystals. Filter the crystals at the pump, dry rapidly between filter paper (yield 2- 6 g.) and determine the m.p. (59°). Extract the filtrate with two 20 ml. portions of ether, and remove the solvent a further 0 - 5 g. of acetoxime (m.p. 60°) is obtained. Recrystallise from light petroleum, b.p. 40-60° CAUTION inflammable) to obtain the pure acetoxime, m.p. 60°. Acetoxime sublimes when left exposed to the air. 

In a 250 ml. conical flask mix a solution of 14 g. of sodium hydroxide in 40 ml. of water and 21 g. (20 ml.) of pure benzaldehyde (Section IV,115). Add 15 g. of hydroxylamine hydrochloride in small portions, and shake the mixture continually (mechanical stirring may be employed with advantage). Some heat is developed and the benzaldehyde eventually disappears. Upon coohiig, a crystalline mass of the sodium derivative separates out. Add sufficient water to form a clear solution, and pass carbon dioxide into the solution until saturated. A colourless emulsion of the a or syn-aldoxime separates. Extract the oxime with ether, dry the extract over anhydrous magnesium or sodium sulphate, and remove the ether on a water bath. Distil the residue under diminished pressure (Fig. 11,20, 1). Collect the pure syn-benzaldoxime (a-benzald-oxime) at 122-124°/12 mm. this gradually solidifies on cooling in ice and melts at 35°. The yield is 12 g. 

Method 2. Dissolve 20 0 g. of sahcylaldehyde in 30 ml. of rectified spirit, add a solution of 15 g. of hydroxylamine hydrochloride in 10 ml. of water, and render the mixture just alkahne with 10 per cent, sodium carbonate solution whilst coohng in ice. Allow to stand overnight. Acidify with acetic acid, distil off the alcohol under reduced pressiu e (water pump), dilute with twice the volume of water, and extract with two 50 ml. portions of ether. Dry the ethereal extract with anhydrous sodium or magnesium sulphate, distil off most of the ether, and allow the residue to crystaUise. RecrystallLse from chloroform - hght petroleum (b.p. 40-60°). The yield of sahcylaldoxime, m.p. 57°, is 12 g. 

Oximes, hydrazines and semicarbazones. The hydrolysis products of these compounds, t.e., aldehydes and ketones, may be sensitive to alkali (this is particularly so for aldehydes) it is best, therefore, to conduct the hydrolysis with strong mineral acid. After hydrolysis the aldehyde or ketone may be isolated by distillation with steam, extraction with ether or, if a solid, by filtration, and then identified. The acid solution may be examined for hydroxylamine or hydrazine or semicarbazide substituted hydrazines of the aromatic series are precipitated as oils or solids upon the addition of alkali. 

Aminoisoxazoles can be determined photometrically by reaction with sodium 1,2-naph-thoquinone-4-sulfonate and selective extraction of the resulting dye into CCI4 for absorbance measurements. This class of compound can be determined in the presence of sulfonamides, sulfanilamides, hydroxylamines and other select amines (74MI41610). 

Dissolved in alkali, extracted with ether (discarded), then the aqueous phase was acidified with hydroxylamine hydrochloride, and the nitro compound fractionally distd under reduced pressure. [Pearson and Dillon J Am Chem Soc 75 2439 1953.]... 

The conversion of cyclohexanone to cyclohexanone oxime is brought about by the use of hydroxylamine sulphate. The sulphuric acid is neutralised with ammonia to ammonium sulphate and this is separated from the oxime. In the presence of oleum the oxime undergoes the process known as the Beckmann rearrangement to yield the crude caprolactam. After further neutralisation with ammonia the caprolactam and further ammonium sulphate are separated by solvent extraction (Figure 18.7). 

To a solution of 20.8 g. (0.3 mole) of hydroxylamine hydrochloride and 20.6 g. (0.5 mole) of sodium hydroxide (98%) in 100 ml. of water is added 22.26 g. (0.25 mole) of ethyl carbamate. After 3 days at room temperature the solution is cooled in an ice bath and carefully neutralized with concentrated hydrochloric acid (Note 1). If necessary (Note 2), the solution is filtered and then extracted with ether the aqueous phase is evaporated on a water bath under reduced [iressurc as rapidly as possible at a temperature not aliove 50 60 . 

The pH of the mixture was adjusted to 7.5 by adding a saturated sodium bicarbonate solution. After being washed twice with diethyl ether, the reaction solution was acidified to pH 2 with dilute hydrochloric acid and extracted with ether. The ether solution containing the free penicillin was washed twice with water and then extracted with 50 ml of N potassium bicarbonate solution. After freeze drying of the obtained neutral solution, the potassium salt of o-azidobenzylpenicillin was obtained as a slightly colored powder (11.2 grams, 54% yield) with a purity of 55% as determined by the hydroxylamine method (the potassium salt of penicillin G being used as a standard). 

A mixture of 150 grams of 1-(3, 4 -dimethoxyphenyl)-2-propanone and 70 grams of hydroxylamine hydrochloride in 125 cc of water is stirred while a solution of 51.3 grams of sodium carbonate in 150 cc of water is added over the course of 15 minutes, and while maintaining the reaction mixture at 30°-40°C. The reaction mixture is stirred for an additional two and one-half hour period at room temperature, and is then diluted with an equal volume of water and extracted three times with 300 cc portions of ether. The combined ether extracts are washed with water, dried over anhydrous magnesium sulfate, and the... 

N sodium hydroxide solution (5 ml) is added to a stirred suspension of S-methyllsothiosemi-carbazide hydroiodide (2.33 g) and hydroxylamine hydrochloride (0.70 g) In water (6 ml) and stirred for 48 hours. The solution is evaporated In vacuo to provide 1 -amino-3-hydroxy-guanidine. One-third of the residue is dissolved in 16 ml of ethanol and 2,6-dichlorobenzalde-hyde (0.6 g) Is added to this solution. The reaction mixture is then stirred for 48 hours. The solution is then evaporated in vacuo and the residue dissolved in ether (30 ml) and in hydrochloric acid (30 ml). The aqueous phase is rendered alkaline with 2 N sodium carbonate solution and extracted with ether. The ether layer is dried with sodium sulfate and evaporated. 

The resulting mixture does not crystalize and is converted into a mixture of oximes by treatment of a solution of the mixture in 20 ml of ethanol with a solution of 1.8 g of hydroxylamine sulfate in 3 ml of water. 1.B g of sodium acetate In 5 ml of water is added, and the mixture is refluxed for 5 hours, then extracted with ethyl acetate, and the ethyl acetate solution is washed with a saturated aqueous sodium chloride solution and dried over Sodium sulfate. After evaporating the solvent, the residue is triturated with warm ether and 1.1 g of a crystalline oxime is obtained, MP 16B° to 171°C. 

Hydroxylamine, IV-benzoyl-lV-phenyl-in gravimetry, 1, 532 liquid-liquid extraction, 1, 544 Hydroxylamine, A -cinnamoyl-A -phenyl-liquid-liquid extraction, 1,544 Hydroxylamine, Ar,A -di-(-butyl-metal complexes, 2, 798 Hydroxylamine, Ay/V-diethyl-metal complexes, 2,798 Hydroxylamine, AAmethyl-metal complexes, 2,798 Hydroxylamine, A -2-naphthol-A -nitroso-ammonium salt — see Ncocupferron Hydroxylamine, A -nilrosophenyl-ammonium salt — see Cupferron Hydroxylamine ligands, 2, 101 Hydroxylamine oxido reductase, 6, 727 Hydroxylases molybdenum, 6,658,662 Hydroxylation arenes... 

Hardcastle JL, Compton RG (2001) The electroanalytical detection and determination of copper in heavily passivating media ultrasonically enhanced solvent extraction by N-benzoyl-N-phenyl-hydroxylamine in ethyl acetate coupled with electrochemical detection by sono-square wave stripping voltammetry analysis. Analyst 126 2025-2031... 

Use of nitrous acid to liberate a free keto-acid from its semicarbazone caused formation of hydrogen azide which was co-extracted into ether with the product. Addition of silver nitrate to precipitate the silver salt of the acid also precipitated silver azide, which later exploded on scraping from a sintered disc. The possibility of formation of free hydrogen azide from interaction of nitrous acid and hydrazine or hydroxylamine derivatives is stressed. 

During the preparation of an unspecified aldoxime, the ethanolic reaction mixture was extracted with ether and the extract was concentrated by vacuum distillation from a bath at 70-80°C. Towards the end of distillation violent decomposition occurred (probably of traces of unreacted hydroxylamine in the extract). 

The freeze-dried sediments were subjected to both a total dissolution and a selective extraction. The latter, as described in Chester Hughes (1967), is carried out in a hydroxylamine hydrochloride and acetic acid (HA) solution and designed to isolate reactive phases. With the exception of total Se, extracted metals were determined by the method described for porewaters. Total solid Se concentrations were measured by AAS with HG-FIAS (analysis ongoing). 

In 1983, Prasad et al.12 first reported the condensation of chloromethyl polystyrene with /V-hydroxyphthalimide to give the ester, hydrazinolysis of which yielded the desired resin-bound hydroxylamine. However, the sole purpose of this reagent was to react with, and hence extract ketones from, a complex steroidal mixture, and its use for the solid-phase synthesis of hydroxamic acids was not explored. Recently, the exploitation of the above solid-phase approach for the synthesis of hydroxamic acids was independently reported by three groups,7-9 all of which differ only in the method for the initial anchoring of TV-hydroxyphtha-limide to an 4-alkoxybenzyl alcohol functionalized polystyrene or trityl chloride polystyrene. Subsequent /V-deprotection was... 

Benzenesulphohydroxamic Acid.1—Hydroxylamine hydrochloride (10 g.) is boiled under reflux condenser with just enough methyl alcohol to dissolve it, and when still hot is decomposed by a solution of 3 g. of sodium in 60 c.c. of ethyl alcohol, which should not be added too quickly. After the mixture has been cooled, precipitated sodium chloride is removed at the pump and 8-5 g. of benzenesulphonyl chloride are then added in small portions to the solution of free hydroxylamine. Most of the alcohol is now removed by distillation from the water bath, the hydroxylamine hydrochloride which has separated is removed by filtration, and the filtrate is evaporated to dryness in vacuo at a moderate temperature. The residue is extracted three times with 15 c.c. portions of boiling absolute ether. Evaporation of the combined ethereal extracts in an open dish yields the benzene sulphohydroxamic acid in the form of a mass of crystalline plates which are digested with cold chloroform and filtered with suction. Yield 5-6 g. Melting point 126°. 

---