Ethyl acetate preparation

The hydrolysis of ethyl acetate, prepared by the reaction of ethylene with acetic acid under pressure (154), and the hydrolysis of the ethyl ester of chlorosulfonic acid (155) have been considered and found to be of Httie industrial importance. 

Solutions of lithio ethyl acetate prepared by this method are stable indefinitely at —78°, but decompose rapidly if allowed to reach room temperature. 

Separation of 2,4-dinitrophenylhydrazones. The solutions are prepared by dissolving 10 mg of each of the 2,4-dinitrophenylhydrazones of acetone, butan-2-one and hexan-3-one (or hexan-2-one) in 0.5 ml of ethyl acetate. Prepare a flexible silica gel sheet of dimensions 20 x 5 cm in the manner already described and apply c. 0.5 pi of each of the three solutions to give the marker spots of a diameter of between 2 and 3 mm. A mixed spot is conveniently obtained by loading sequentially to the same area further 0.5 pi aliquot portions of each of the solutions and allowing the solvent to evaporate completely between each addition. 

A Claisen condensation of ethyl acetate prepares acetoacetic ester. 

Ethyl acetate, prepared industrially from acetaldehyde and catalytic amounts of aluminum ethoxide, contains acetic acid, ethanol, and water as impurities. 100 g of ethyl acetate dissolves 3.3 g of water at 25° the azeotrope contains 8.5% of water. 

Ethyl acetate prepared in this way may contain as impurities alcohol, acetic acid, water, and ether. Alcohol is removed by shaking the ester with a saturated aqueous solution of calcium chloride, acetic acid by treatment with a solution of sodium carbonate, and water by distillation after allowing the ester to stand some hours in contact with anhydrous calcium chloride. If ether is present it must be removed by fractional distillation. 

It is readily prepared by the action of metallic sodium on dry ethyl acetate. The reaction, which occurs only in the presence of a trace of ethanol, is complex, but may be considered (in effect) as a condensation of two molecules of ethyl acetate under the influence of sodium ethoxide, the sodium derivative of the enol form being thus obtained. Clearly, only a trace of ethanol is thus initially... 

Ethyl acetoacetate may be prepared by the action of sodium upon dry ethyl acetate and decomposition of the resulting sodio compound with dilute acetic acid. Most samples of ethyl acetate contain some ethyl alcohol and it is usually assumed that sodium ethoxidc is the condensing agent ... 

This is an alternative experiment to the actual preparation of the ester and will give the student practice in conducting a distillation under diminished pressure. Commercial ethyl acetoacetate generally contains inter alia some ethyl acetate and acetic acid these are removed in the following procedure. 

Picrates are usually prepared by mixing solutions of equivalent quantities of the two components in the minimum volume of rectified spirit and allowing to cool the derivative separates in a crystalline condition. It is filtered off, washed with a little ether, and pressed on a porous tUe. If the picrate is stable, it is recrystaUised from alcohol, ethyl acetate or ether. 

The foUowing are typical experimental details for the preparation of naphthalene picrate. Dissolve 0 -1 g. of naphthalene and 0-2 g. of picric acid separately in the minimum volume of hot rectified spirit (about 2 ml.), mix the solutions and allow to cool. FUter and wash with 2 ml. of alcohol. RecrystaUise from hot alcohol, ethyl acetate or ether. 

In a 500 ml. wide-mouthed reagent bottle place a cold solution of 25 g. of sodium hydroxide in 250 ml. of water and 200 ml. of alcohol (1) equip the bottle with a mechanical stirrer and surround it with a bath of water. Maintain the temperature of the solution at 20-25°, stir vigorously and add one-half of a previously prepared mixture of 26-5 g. (25 -5 ml.) of purebenzaldehyde (Section IV,115) and 7 -3 g. (9-3 ml.) of A.R. acetone. A flocculent precipitate forms in 2-3 minutes. After 15 minutes add the remainder of the benzaldehyde - acetone mixture. Continue the stirring for a further 30 minutes. Filter at the pump and wash with cold water to eliminate the alkali as completely as possible. Dry the solid at room temperature upon filter paper to constant weight 27 g. of crude dibenzalacetone, m.p. 105-107°, are obtained. Recrystallise from hot ethyl acetate (2-5 ml. per gram) or from hot rectified spirit. The recovery of pure dibenzalacetone, m.p. 112°, is about 80 per cent. 

The preparation of benzoylacctone Is another example of the acylation of a ketone (acetophenone) by ethyl acetate to a p diketone (Claisen condensation compare preceding Section) ... 

Indanedioiie (III) may also be prepared by condensation of diethyl phthalate (V) with ethyl acetate in the presence of sodium ethoxide the resulting sodium 1 3-indanedione-2-carboxylic ester (VI) upon warming with sulphuric acid yields (HI). 

Ethyl phenylethylmalonate. In a dry 500 ml. round-bottomed flask, fitted with a reflux condenser and guard tube, prepare a solution of sodium ethoxide from 7 0 g. of clean sodium and 150 ml. of super dry ethyl alcohol in the usual manner add 1 5 ml. of pure ethyl acetate (dried over anhydrous calcium sulphate) to the solution at 60° and maintain this temperature for 30 minutes. Meanwhile equip a 1 litre threenecked flask with a dropping funnel, a mercury-sealed mechanical stirrer and a double surface reflux condenser the apparatus must be perfectly dry and guard tubes should be inserted in the funnel and condenser respectively. Place a mixture of 74 g. of ethyl phenylmalonate and 60 g. of ethyl iodide in the flask. Heat the apparatus in a bath at 80° and add the sodium ethoxide solution, with stirring, at such a rate that a drop of the reaction mixture when mixed with a drop of phenolphthalein indieator is never more than faintly pink. The addition occupies 2-2 -5 hoius continue the stirring for a fiuther 1 hour at 80°. Allow the flask to cool, equip it for distillation under reduced pressure (water pump) and distil off the alcohol. Add 100 ml. of water to the residue in the flask and extract the ester with three 100 ml. portions of benzene. Dry the combined extracts with anhydrous magnesium sulphate, distil off the benzene at atmospheric pressure and the residue under diminished pressure. C ollect the ethyl phenylethylmalonate at 159-160°/8 mm. The yield is 72 g. 

Owing to the instability of a-halogenoaldehydes it is occasionally preferable to use more stable derivatives, such as enol acetate prepared according to Bedoukian s method (204) and a-bromoacetals (4, 8, 10, 16, 22, 67, 101, 426). An advantage is said to be in the yield however, this appears to be slight. The derivatives react in the same sense as the aldehydes themselves, that is, the acetal group as the more polarized reacts first and enters the C-4 position. It is likely that the condensation and cyclization occur by direct displacement of alkoxide ions. Ethyl-a,/3-dihalogeno ethers (159, 164, 177, 248) have also been used in place of the free aldehydes in condensation with thioamides. 

Ethanol (industrial solvent used in preparation of ethyl acetate unleaded gasoline additive)... 

Other acetyl chloride preparations include the reaction of acetic acid and chlorinated ethylenes in the presence of ferric chloride [7705-08-0] (29) a combination of ben2yl chloride [100-44-7] and acetic acid at 85% yield (30) conversion of ethyUdene dichloride, in 91% yield (31) and decomposition of ethyl acetate [141-78-6] by the action of phosgene [75-44-5] producing also ethyl chloride [75-00-3] (32). The expense of raw material and capital cost of plant probably make this last route prohibitive. Chlorination of acetic acid to monochloroacetic acid [79-11-8] also generates acetyl chloride as a by-product (33). Because acetyl chloride is cosdy to recover, it is usually recycled to be converted into monochloroacetic acid. A salvage method in which the mixture of HCl and acetyl chloride is scmbbed with H2SO4 to form acetyl sulfate has been patented (33). 

A typical process for the preparation of a 94.8% ethyl acrylate—5.2% acryUc acid copolymer as an approximately 39% solution in ethyl acetate is given... 

Dimenhydrinate. Dimenhydrinate [523-87-5] (Dramamine) (18) is a white crystalline, odorless powder that melts between 102 and 107°C. It is sparingly soluble in water, freely soluble in ethanol and chloroform, and sparingly soluble in diethyl ether. Dimenhydrinate is prepared by combining dimethylaminoethyl ben2hydryl ester with 8-ch1orotheophy11ine and refluxing in an isopropyl alcohol solution. The crystalline precipitate of dimenhydrinate that forms on cooling is collected by filtration, washed with cold ethyl acetate, and dried. 

Polyesters. Polyesters containing carbonate groups have been prepared from this diol (see Polycarbonates) (99). Films of this polymer, formed from an acetone or ethyl acetate solution, exhibit exceUent adhesive properties. 

Norethindrone may be recrystakhed from ethyl acetate (111). It is soluble in acetone, chloroform, dioxane, ethanol, and pyridine slightly soluble in ether, and insoluble in water (112,113). Its crystal stmcture has been reported (114), and extensive analytical and spectral data have been compiled (115). Norethindrone acetate can be recrystakhed from methylene chloride/hexane (111). It is soluble in acetone, chloroform, dioxane, ethanol, and ether, and insoluble in water (112). Data for identification have been reported (113). The preparation of norethindrone (28) has been described (see Fig. 5). Norethindrone acetate (80) is prepared by the acylation of norethindrone. Norethindrone esters have been described ie, norethindrone, an appropriate acid, and trifiuoroacetic anhydride have been shown to provide a wide variety of norethindrone esters including the acetate (80) and enanthate (81) (116). 

Other preparative routes iaclude hydrogenation of succinonitdle in the presence of methylamine and hydrogenation of solutions of maleic or succinic acid and methylamine (82,83). Properties are Hsted in Table 3. l-Meth5i-2-pyrrohdinone is completely miscible with water, lower alcohols, lower ketones, ether, ethyl acetate, chloroform, and benzene. It is moderately soluble in aUphatic hydrocarbons and dissolves many organic and inorganic compounds. 

Stannous Chloride Dihydrate. A white crystalline soHd, stannous chloride dihydrate is prepared either by treatment of granulated tin with hydrochloric acid followed by evaporation and crystallisation or by reduction of a stannic chloride solution with a cathode or tin metal followed by crystallisation. It is soluble in methanol, ethyl acetate, glacial acetic acid, sodium hydroxide solution, and dilute or concentrated hydrochloric acid. It is soluble in less than its own weight of water, but with much water it forms an insoluble basic salt. 

Stannous Oxalate. Stannous oxalate, Sn(C20 (mol wt 206.71, dec 280°C, sp gr 3.56 at 18°C), is a white crystalline powder, is soluble in hot concentrated hydrochloric acid and mixtures of oxaHc acid and ammonium oxalate, and is insoluble in water, toluene, ethyl acetate, dioctyl phthalate, THF, isomeric heptanes, and acetone (171). It is prepared by precipitation from a solution of stannous chloride and oxaHc acid and is stable indefinitely. 

---