Ethanol substitution reaction

As we ve just seen nucleophilic ring opening of ethylene oxide yields 2 substituted derivatives of ethanol Those reactions involved nucleophilic attack on the carbon of the ring under neutral or basic conditions Other nucleophilic ring openings of epoxides like wise give 2 substituted derivatives of ethanol but either involve an acid as a reactant or occur under conditions of acid catalysis... 

These effects can be attributed mainly to the inductive nature of the chlorine atoms, which reduces the electron density at position 4 and increases polarization of the 3,4-double bond. The dual reactivity of the chloropteridines has been further confirmed by the preparation of new adducts and substitution products. The addition reaction competes successfully, in a preparative sense, with the substitution reaction, if the latter is slowed down by a low temperature and a non-polar solvent. Compounds (12) and (13) react with dry ammonia in benzene at 5 °C to yield the 3,4-adducts (IS), which were shown by IR spectroscopy to contain little or none of the corresponding substitution product. The adducts decompose slowly in air and almost instantaneously in water or ethanol to give the original chloropteridine and ammonia. Certain other amines behave similarly, forming adducts which can be stored for a few days at -20 °C. Treatment of (12) and (13) in acetone with hydrogen sulfide or toluene-a-thiol gives adducts of the same type. 

Rate data are also available for the solvolysis of l-(2-heteroaryl)ethyl acetates in aqueous ethanol. Side-chain reactions such as this, in which a delocalizable positive charge is developed in the transition state, are frequently regarded as analogous to electrophilic aromatic substitution reactions. In solvolysis the relative order of reactivity is tellurienyl> furyl > selenienyl > thienyl whereas in electrophilic substitutions the reactivity sequence is furan > tellurophene > selenophene > thiophene. This discrepancy has been explained in terms of different charge distributions in the transition states of these two classes of reaction (77AHC(21)119>. 

The real world of Sn reactions is not quite as simple as the discussion has so far suggested. The preceding treatment in terms of two clearly distinct mechanisms, SnI and Sn2, implies that all substitution reactions will follow one or the other of these mechanisms. This is an oversimplification. The strength of the dual mechanism hypothesis and its limitations are revealed by these relative rates of solvolysis of alkyl bromides in 80% ethanol methyl bromide, 2.51 ethyl bromide, 1.00 isopropyl bromide, 1.70 /er/-butyl bromide, 8600. Addition of lyate ions increases the rate for the methyl, ethyl, and isopropyl bromides, whereas the tert-butyl bromide solvolysis rate is unchanged. The reaction with lyate ions is overall second-order for methyl and ethyl, first-order for tert-butyl, and first- or second-order for the isopropyl member, depending upon the concentrations. Similar results are found in other solvents. These data show that the methyl and ethyl bromides solvolyze by the Sn2 mechanism, and tert-butyl bromide by the SnI mech-... 

Another remarkable reaction is the nucleophilic substitution of the chlorine by alkoxy or sulfido groups using the alcohol or the thiol and the weak base Na2C03 in situ. For example, in the case of ethanol, the reaction proceeds in 12 h at reflux Eq. (23), Table 3. 

Scheme 11.6 gives some examples of the various substitution reactions of aryl diazonium ions. Entries 1 to 6 are examples of reductive dediazonization. Entry 1 is an older procedure that uses hydrogen abstraction from ethanol for reduction. Entry 2 involves reduction by hypophosphorous acid. Entry 3 illustrates use of copper catalysis in conjunction with hypophosphorous acid. Entries 4 and 5 are DMF-mediated reductions, with ferrous catalysis in the latter case. Entry 6 involves reduction by NaBH4. 

For carbon-carbon bond-formation purposes, S 2 nucleophilic substitutions are frequently used. Simple S 2 nucleophilic substitution reactions are generally slower in aqueous conditions than in aprotic organic solvents. This has been attributed to the solvation of nucleophiles in water. As previously mentioned in Section 5.2, Breslow and co-workers have found that cosolvents such as ethanol increase the solubility of hydrophobic molecules in water and provide interesting results for nucleophilic substitutions (Scheme 6.1). In alkylations of phenoxide ions by benzylic chlorides, S/y2 substitutions can occur both at the phenoxide oxygen and at the ortho and para positions of the ring. In fact, carbon alkylation occurs in water but not in nonpolar organic solvents and it is observed only when the phenoxide has at least one methyl substituent ortho, meta, or para). The effects of phenol substituents and of cosolvents on the rates of the competing alkylation processes... 

Methanol-water and ethanol-water are commonmixed solvents for nucleophilic substitution reactions. 

Thiadiazolines and thiadiazolium salts can undergo a thermally promoted rearrangement to yield 2-guanidinoben-zothiazoles. Thus the thiadiazoline 42 when heated in ethanol at reflux affords the benzothiazole 43 (Equation 11). There is evidence to suggest that this could be an electrophilic aromatic substitution reaction but a free radical mechanism was also proposed <2003SC2053>. 

Rate constants for the liquid-phase, second-order, aromatic substitution reaction of 2-chloroquinoxaline (2CQ) with aniline in ethanol (inert solvent) were determined at several temperatures by Patel (1992). The reaction rate was followed by means of a conductance cell (as a BR). Results are as follows ... 

Acetyl chloride must always be stored under anhydrous conditions, because it readily reacts with moisture and becomes hydrolysed to acetic acid. On the other hand, if one wanted to convert ethyl chloride into ethanol, this nucleophilic substitution reaction would require hydroxide, with its negative charge a better nucleophile than water, and an elevated temperature (see Section 6.3.2). It is clear, therefore, that the carbonyl group is responsible for the increased reactivity, and we must implicate... 

A number of syntheses of pioglitazone have been disclosed (Arita and Mizuno, 1992 Fischer et al., 2005 Les et al., 2004 Meguro and Fujita, 1986, 1987 Momose et al., 1991 Prous and Castaner, 1990 Saito et al., 1998). Two related syntheses (Fischer et al., 2005 Les et al., 2004) of pioglitazone hydrochloride are described in Scheme 8.2. The tosylate of 2-(5-ethylpyridin-2-yl)ethanol (16), formed in situ with tosyl chloride, was displaced by 4-hydroxybenzaldehyde (17) by means of benzyltributylammonium chloride and NaOH to give 4-[2-(5-ethylpyridin-2-yl)ethoxy]benzaldehyde (20). Condensation of 20 with thiazolidine-2,4-dione in basic medium afforded 5-[-4-[2-(5-ethylpyridin-2-yl)ethoxy]benzylidene]thiazolidine-2,4-dione (21). Finally, this compound was hydrogenated to provide pioglitazone (2). Alternatively, a nucleophilic aromatic substitution reaction... 

The conditions used for substitution reactions by the SN2 mechanism very often lead to elimination. The reaction of 2-bromopropane with sodium ethoxide in ethanol provides a good example ... 

In view of the mechanism suggested above for the ethanol-sodium reaction, it seems likely that reduction of aromatic compounds by solutions of alcohols and alkali metals in liquid ammonia proceeds by a general mechanism involving a steady-state concentration of ammonium ion. Krapcho and Bothner-By (29) observed that the reduction of benzene and several substituted benzenes in lithium-alcohol-ammonia solutions,... 

Kinetic studies of the substitution reaction of 2-chloro-l-methylpyridinium iodide with phenoxides are consistent with the SnAt mechanism, with rate-determining nucleophilic attack.38 The effects of a variety of ring substituents on the reactivities of 2-fluoro- and 2-chloro-pyridines in reactions with sodium ethoxide in ethanol have been examined. The results were discussed in terms of the combination of steric, inductive, and repulsive interactions.39 Substitution in 2,4,6-trihalopyridines normally occurs preferentially at the 4-position. However, the presence of a trialkylsilyl group at the 3-position has been shown to suppress reaction at adjacent positions, allowing substitution at the 6-position.40 Methods have been reported for the introduction and removal of fluorine atoms for polyfluoropyridines. Additional fluorine atoms were introduced by metallation, chlorination, and then fluorodechlorination, while selective removal of fluorine was achieved by reduction with either metals or complex hydrides or alternatively by substitution by hydrazine followed by dehydrogena-tion-dediazotization.41... 

---