Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Composites epoxy resin

In Figure 5.23 the finite element model predictions based on with constraint and unconstrained boundary conditions for the modulus of a glass/epoxy resin composite for various filler volume fractions are shown. [Pg.187]

BMI/Epoxy resins [COMPOSITE MATERIALS - POLYTffiR-MATRM - THERMOSETS] (Vol 7) Electrically charged membrane... [Pg.354]

A variety of materials has been proposed to modify the properties of asphaltic binders to enhance the properties of the mix (112), including fillers and fibers to reinforce the asphalt—aggregate mixture (114), sulfur to strengthen or harden the binder (115,116), polymers (98,117—121), mbber (122), epoxy—resin composites (123), antistripping agents (124), metal complexes (125,126), and lime (127,128). AH of these additives serve to improve the properties of the binder and, ultimately, the properties of the asphalt—aggregate mix. [Pg.373]

Tsai conducted experiments to measure the various moduli of glass-fiber-epoxy-resin composite materials [3-1]. The glass fibers and epoxy resin had a Young s modulus and Poisson s ratio of 10.6 x 10 psi (73 GPa) and. 22 and. 5 x 10 psi (3.5 GPa) and. 35, respectively. [Pg.160]

Figure 10 Influence of silane coupling agents on the strength of jute reinforced epoxy-resin composites at different moisture contents [12],... Figure 10 Influence of silane coupling agents on the strength of jute reinforced epoxy-resin composites at different moisture contents [12],...
Figure 14 Influence of fiber drying on the characteristic values of jute reinforced epoxy-resin composites [121. Figure 14 Influence of fiber drying on the characteristic values of jute reinforced epoxy-resin composites [121.
As soon as the Ar s were determined and the values of r s are found, the values of the adhesion coefficient A may be readily defined by using relation (27). The values of A s for the different fiber-volume contents studied are given in Table II for E-glass fiber-epoxy resin composites with different amounts of fillers, up to 70 percent 22 >. [Pg.178]

High molecular weight (HMW) epoxy resin compositions, 10 348 High molecular weight (MW) linear polymers, 23 733 High molecular weight... [Pg.436]

Fig. 2,10. Fiber strain and interfacial shear stress (IFSS) profiles along the fiber length for a heat-treated Kevlar 49 fiber-epoxy resin composite. At applied strains of (a) 0.60% (b) 1.90% and (c) 2,5%. After... Fig. 2,10. Fiber strain and interfacial shear stress (IFSS) profiles along the fiber length for a heat-treated Kevlar 49 fiber-epoxy resin composite. At applied strains of (a) 0.60% (b) 1.90% and (c) 2,5%. After...
Sato N., Kurauchi T., Sato, S. and Kamigaito O. (1986). Fracture mechanism of unidirectional carbon-fibre reinforced epoxy resin composites. J. Mater. Sci. 21, 1005-1010. [Pg.277]

Bader M.G., Bailey J.E. and Bell 1. (1973). The effect of fiber-matrix interface strength on the impact and fracture properties of carbon fiber-reinforced epoxy resin composites. J. Phys. D Appi. Phvs. 6, 572-586. [Pg.320]

Garg A.C. and Mai Y.W. (1988b). Failure prediction in toughened epoxy resins. Composites Sci. Technol. 31, 225-242. [Pg.322]

Patrikis. A.K., Andrews, M.C. and Young, R.J. (1994). Analysis of the single fiber pull-out test by the use of Raman spectroscopy part I Pull-out of aramid fibers from an epoxy resin. Composites Sci. Technol. 52, 387 396. [Pg.325]

Filler Vol% Filler Filler Epoxy Resin Composite... [Pg.334]

Use the data below for the erosive wear for alnmina particles impacting on a graphite-fiber-reinforced epoxy resin composite material to determine the four parameters Uf,Us,vi, and Vp in Eq. (P8.1). You may need to look up some additional data and make appropriate assumptions to solve this problem. You may also find a spreadsheet helpful for solving the fom equations with four unknowns. [Pg.850]

Hinrichs, R.J. Processing Science of Epoxy Resin Composites (1982) Industry Contract Review F33615-80-C5021, General Dynamics Convair Division, San Diego, Calif. Jan. 19... [Pg.206]

Interim Report, Processing Science of Epoxy Resin Composites (1981) Contract No. F33615-80-C-5021, 9/15/80-10/15/81, Air Force Materials Laboratory, Weright Patterson AFB, Ohio... [Pg.206]

Title Novel Sulfur-containing Phenolic Resin, Process for Preparing the Same, Phenol Derivatives Having Thioether Structure or Disulfide Structure, Process for Preparing the Same and Epoxy Resin Composition Adhesive... [Pg.67]

Shinohara et al. (3) prepared epoxy resin compositions, (IV). by epoxidizing 3,3 5,5 -tetramethyl-4,4 -dihydroxyldiphenyl methane and using these... [Pg.70]

Llopis et al. [37] Cola beverage Glucose oxidase (GOD)/ entrapped together with the mediator in the bulk of the biocomposite material Graphite and nonconducting epoxy resin composite electrode/ +0.3 V vs. Ag/AgCl Tetrathiafulvalene-tetracyanoquino-dimethane (TTF - TCNQ)... [Pg.262]

Haruomi, H. 2003. Epoxy resin composition and electrical/electronic part equipment. Jpn. Kokai Tokkyo Koho JP 2003096272. [Pg.234]

Kamikooryma, Y., Hirose, M., and Koshibie, S. 1994. Production of flame resistant epoxy resin composition. Jpn. Kokai Tokkyo Koho JP 06,107,914, 1994. [Pg.235]

See other pages where Composites epoxy resin is mentioned: [Pg.55]    [Pg.115]    [Pg.261]    [Pg.266]    [Pg.293]    [Pg.366]    [Pg.809]    [Pg.73]    [Pg.362]    [Pg.149]    [Pg.163]    [Pg.799]    [Pg.802]    [Pg.407]    [Pg.55]    [Pg.115]    [Pg.261]    [Pg.266]    [Pg.293]    [Pg.366]    [Pg.809]    [Pg.362]   
See also in sourсe #XX -- [ Pg.582 ]



SEARCH



Aramid fibre epoxy resin composites

Composite resin

Epoxy resins graphite fiber composites

Kevlar 49-epoxy resin composite

Polymer composite carbon fibre-epoxy resin

© 2024 chempedia.info