Engineering Societies Commission

The Engineering Societies Commission on Energy, Inc. Washington, July 1979, pp 49-60. 

Engineering Societies Commission on Energy, 444 North Capitol St., Washington, D.C. 20001... 

Another joint activity was a united address to Dutch government in 1912 on the rules with respect to patent agents, together with the engineering society KIVI. A joint commission was installed that prepared alternative regulations for patent agents. These were sent to Dutch government in 1916, but the action did not have the desired effect. ... 

Engineering and Technology Degrees. 1967/1968-. New York Engineering Workforce Commission of American Association of Engineering Societies. This annual report... 

The journal of the Packaging and Food Engineering Institution of the Chinese Mechanical Engineering Society is a technical journal, approved by the State Science and Technology Commission. Initiated in 1983, it... 

American Association of Engineering Societies, Engineering Workforce Commission, Professional Income ofEngineers 1998. 

P. J. D. and P. J.M. thank The UK Engineering and Physical Sciences Research Council, The European Commission, The Royal Society, ICI Paints, Unilever Research, Uniqema and Disperse Technologies for financial support. They acknowledge the considerable input and help of their colleagues, especially Dr. Paul Glover (University of Nottingham), Dr. Joe Keddie (University of Surrey) and Dr. Peter Aptaker (Laplacian Ltd.) in carrying out much of the work reviewed here. 

References Guidelines for Safe and Reliable Instrumented Protective Systems, American Institute of Chemical Engineers, New York, 2007 ISA TR84.00.04, Guidelines for the Implementation of ANSI/ISA 84.00.01-2004 (IEC 61511), Instrumentation, Systems, and Automation Society, N.C., 2005 ANSI/ISA 84.00.01-2004, Functional Safety Safety Instrumented Systems for the Process Industry Sector, Instrumentation, Systems, and Automation Society, N.C., 2004 IEC 61511, Functional Safety Safety Instrumented Systems for the Process Industry Sector, International Electrotechnical Commission, Geneva, Switzerland, 2003. 

SCO SCPC SD SEC SMR SNG SOFC SPE SRES SULEV SUV Synthetic crude oil Super-critical pulverised coal System dynamics US Securities and Exchange Commission Steam methane reformer Synthetic natural gas Solid-oxide fuel cell Society of Petroleum Engineers IPCC Special Report on Emissions Scenarios Super-ultra-low-emission vehicle Sport utility vehicle... 

Urszula Domahska has been professor. Faculty of Chemistry, Warsaw University of Technology since February 1995. She has been the Head of the Physical Chemistry Division since September 1991 and vice director of the Institute of Fundamental Chemistry (1988-1990). She had long-term scientific visits as visiting professor Laboratoire De Thermodynamique Ft D Analyse Chimique, University of Metz, France University of Turku, Finland Faculty of Science, Department of Chemistry, University of Natal, South Africa Department of Chemical Engineering, Louisiana State University, United States. Her interests have included such areas of physical chemistry as thermodynamics, especially thermodynamics of phase equilibria, VLE, LLE, SLE, high-pressure SLE, separation science, calorimetry, correlation and prediction of physical-chemical properties, and ionic liquids. She is a member of the Polish Chemical Society member of the Polish Association of Calorimetry and Thermal Analysis member of lUPAC Commission on Solubility member of International Association of Chemical Thermodynamics and scientific advisor at the Journal of Chemical Engineering Data. 

ISPE (2001), Baseline Pharmaceutical Engineering Guide Qualification Commissioning, International Society of Pharmaceutical Engineering, Tampa, FL. 

Pharmaceutical Inspection Co-operation Scheme (2003), Good Practices for Computerised Systems in Regulated GxP Environments, Pharmaceutical Inspection Convention, PI 011-1, Geneva, August. ISPE (2001), Qualification and Commissioning Baseline Guide, First Edition, International Society for Pharmaceutical Engineering (www.ispe.org). 

We thank the Wellcome Trust, the Science and Engineering Research Council, and the Commission for European Communities (BAP contract No. 0253UK) for support. P. J. Artymiuk acknowledges receipt of a Royal Society University Research Fellowship and G. C. Ford is a Wellcome Trust-Reader. Studies on recombinant ferritins were carried out in collaboration with A. Luzzago, G. Cesareni, S. Levi, P. Arosio, C. D. Thomas, and W. V. Shaw, and Mdssbauer spectroscopic studies with E. R. Bauminger and I. Nowik. 

The authors would like to thank Tim Weihs and Mark Teaford of Johns Hopkins University, Andy Joiner and Matthew Pickles of Unilever R D Port Sunlight and Marc Rosenblum of the New Jersey Dental School for their comments. Financial support for the research was provided by Unilever pic., the Royal Society (London), the Engineering and Physical Science Research Council (UK) and the New Jersey Commission on Higher Education. 

ISPE Baseline pharmaceutical engineering guides for new and renovated facilities. Volume 5. Commissioning and qualification, 1st ed. Tampa, Fl, International Society for Pharmaceutical Engineering, 2001. 

---