Endo group

An unusual nucleophilic substitution of the endo group in an annulated cyclopropylamine was shown to be the consequence of an isomerization process combined with two nucleophilic substitution steps. 

Note that trawj-substituents in the allylidene moiety were transformed to exo groups in the product and cw-substituents to endo groups. The rearrangement also worked well with carbonyl or enol ether substituents thus enabling functionality to be introduced into either ring of the product bicyclodecanes. 

Beyond this, in general, with such different groups (e.g., phenyl together with p-cyano or p-bromophenyl), it was always the endo group that migrated selectively (note Scheme... 

Endo group (Section 13.10B) A group on a bicyclic compound that is on the same side (syn) as the longest bridge in the compound. 

Theoretical work by the groups directed by Sustmann and, very recently, Mattay attributes the preference for the formation of endo cycloadduct in solution to the polarity of the solvent Their calculations indicate that in the gas phase the exo transition state has a lower energy than the endo counterpart and it is only upon introduction of the solvent that this situation reverses, due to the difference in polarity of both transition states (Figure 1.2). Mattay" stresses the importance of the dienophile transoid-dsoid conformational equilibrium in determining the endo-exo selectivity. The transoid conformation is favoured in solution and is shown to lead to endo product, whereas the cisoid conformation, that is favoured in the gas phase, produces the exo adduct This view is in conflict with ab initio calculations by Houk, indicating an enhanced secondary orbital interaction in the cisoid endo transition state . 

The effect of ligands on the endo-exo selectivity of Lewis-acid catalysed Diels-Alder reactions has received little attention. Interestingly, Yamamoto et al." reported an aluminium catalyst that produces mainly exo Diels-Alder adduct. The endo-approach of the diene, which is normally preferred, is blocked by a bulky group in the ligand. 

Unique chemistry is associated with the cyclopentenone all five carbon atoms can be functionalized, and the endo-methyl groups of the acetonide assure clean stereoselective addition of the alkenylcopper reagent from the convex side. The use of the acetonide group to control enolate regioselectivity and to mask alcohols should be generally applicable. 

The 7, i5-unsaturated alcohol 99 is cyclized to 2-vinyl-5-phenyltetrahydro-furan (100) by exo cyclization in aqueous alcohol[124]. On the other hand, the dihydropyran 101 is formed by endo cyclization from a 7, (5-unsaturated alcohol substituted by two methyl groups at the i5-position. The direction of elimination of /3-hydrogen to give either enol ethers or allylic ethers can be controlled by using DMSO as a solvent and utilized in the synthesis of the tetronomycin precursor 102[125], The oxidation of the optically active 3-alkene-l,2-diol 103 affords the 2,5-dihydrofuran 104 in high ee. It should be noted that /3-OH is eliminated rather than /3-H at the end of the reac-tion[126]. 

The intramolecular reaction oF allcenes with various O and N functional groups offers useful synthetic methods for heterocycles[13,14,166]. The reaction of unsaturated carboxylic acids affords lactones by either exo- or endo-cyclization depending on the positions of the double bond. The reaction of sodium salts of the 3-alkenoic acid 143 and 4-alkenoic acid 144 with Li2PdCl4 affords mostly five-membcrcd lactones in 30-40% yields[167]. Both 5-hexe-noic acid (145) and 4-hexenoic acid (146) are converted to five- or six-mem-bered lactones depending on the solvents and bases[168]. Conjugated 2,4-pentadienoic acid (147) is cyclized with Li2PdCl4 to give 2-pyrone (148) in water[i69]. 

Based on the above-mentioned stereochemistry of the allylation reactions, nucleophiles have been classified into Nu (overall retention group) and Nu (overall inversion group) by the following experiments with the cyclic exo- and ent/n-acetales 12 and 13[25], No Pd-catalyzed reaction takes place with the exo-allylic acetate 12, because attack of Pd(0) from the rear side to form Tr-allyl-palladium is sterically difficult. On the other hand, smooth 7r-allylpalladium complex formation should take place with the endo-sWyWc acetate 13. The Nu -type nucleophiles must attack the 7r-allylic ligand from the endo side 14, namely tram to the exo-oriented Pd, but this is difficult. On the other hand, the attack of the Nu -type nucleophiles is directed to the Pd. and subsequent reductive elimination affords the exo products 15. Thus the allylation reaction of 13 takes place with the Nu nucleophiles (PhZnCl, formate, indenide anion) and no reaction with Nu nucleophiles (malonate. secondary amines, LiP(S)Ph2, cyclopentadienide anion). 

The reactions of trialkylboranes with bromine and iodine are gready accelerated by bases. The use of sodium methoxide in methanol gives good yields of the corresponding alkyl bromides or iodides. AH three primary alkyl groups are utilized in the bromination reaction and only two in the iodination reaction. Secondary groups are less reactive and the yields are lower. Both Br and I reactions proceed with predominant inversion of configuration thus, for example, tri( X(9-2-norbomyl)borane yields >75% endo product (237,238). In contrast, the dark reaction of bromine with tri( X(9-2-norbomyl)borane yields cleanly X(9-2-norbomyl bromide (239). Consequentiy, the dark bromination complements the base-induced bromination. 

Endo adducts are usually favored by iateractions between the double bonds of the diene and the carbonyl groups of the dienophile. As was mentioned ia the section on alkylation, the reaction of pyrrole compounds and maleic anhydride results ia a substitution at the 2-position of the pyrrole ring (34,44). Thiophene [110-02-1] forms a cycloaddition adduct with maleic anhydride but only under severe pressures and around 100°C (45). Addition of electron-withdrawiag substituents about the double bond of maleic anhydride increases rates of cycloaddition. Both a-(carbomethoxy)maleic anhydride [69327-00-0] and a-(phenylsulfonyl) maleic anhydride [120789-76-6] react with 1,3-dienes, styrenes, and vinyl ethers much faster than tetracyanoethylene [670-54-2] (46). 

Loss of a second molecule of water occurs on heating (1) (106,107), (2), or (3) (108) with concentrated sulfuric or hydrochloric acid forming 1,4 3,6-dianhydro-D-glucitol (isosorbide) (5). Mannitol and iditol anhydrize under similar conditions to isomannide (6) and isoidide (7), respectively. In (6), both hydroxyl groups are oriented toward each other (endo) ia (7), both are oriented away from each other (exo) and ia isosorbide (5), one hydroxyl is endo and the other exo. XyUtol loses two moles of water to form l,3 2,5-dianhydrox5litol (109). 

Another standard test, which is much simpler and more convenient, is the membrane filter technique. A suitable volume of sample is filtered through a sterile, 0.45-p.m membrane filter. The filter is placed in a petri dish containing a specific growth medium (M-Endo nutrient broth, M-Endo medium) and incubated for 24 h at 35°C. If after this time the colonies show the characteristic green sheen, this is taken as positive evidence for the presence of the coliform group (see Water, sewage). 

---