Diffusion, coefficients structure

Hundreds of MD simuladmi studies of pure RTIL solvents have been reported [75, 79, 80]. Accurate prediction of density, heat of vaporization, conductivity, viscosity, self-diffusion coefficients, structure factors, and crystal structure was reported [75, 80-83] for RTIL comprised of ions listed in Fig. 7.19, while other MD smdies [84] reported irai transport an order of magnimde slower than experiments. An order of magnitude slower prediction of RTIL transport cannot be fully attributed to the absence of polarization in the force field as mining off... 

Lateral density fluctuations are mostly confined to the adsorbed water layer. The lateral density distributions are conveniently characterized by scatter plots of oxygen coordinates in the surface plane. Fig. 6 shows such scatter plots of water molecules in the first (left) and second layer (right) near the Hg(l 11) surface. Here, a dot is plotted at the oxygen atom position at intervals of 0.1 ps. In the first layer, the oxygen distribution clearly shows the structure of the substrate lattice. In the second layer, the distribution is almost isotropic. In the first layer, the oxygen motion is predominantly oscillatory rather than diffusive. The self-diffusion coefficient in the adsorbate layer is strongly reduced compared to the second or third layer [127]. The data in Fig. 6 are qualitatively similar to those obtained in the group of Berkowitz and coworkers [62,128-130]. These authors compared the structure near Pt(lOO) and Pt(lll) in detail and also noted that the motion of water in the first layer is oscillatory about equilibrium positions and thus characteristic of a solid phase, while the motion in the second layer has more... 

Diffusion has often been measured in metals by the use of radioactive tracers. The resulting parameter, DT, is related to the self-diffusion coefficient by a correlation factor/that is dependent upon the details of the crystal structure and jump geometry. The relation between DT and the self-diffusion coefficient Dsclf is thus simply... 

The application of the above methods of calculation has shown that the quasi-diffusion of organic counterions is profundly affected by both the amount of the crosslinking agent in a crosslinked polyelectrolyte and the method of formation of the crosslinked structure [109-112]. Fig. 28 shows the dependence of diffusion coefficients for streptomycin ions on the amount of the crosslinking... 

Temperature gradients within the porous catalyst could not be very large, due to the low concentration of combustibles in the exhaust gas. Assuming a concentration of 5% CO, a diffusion coefficient in the porous structure of 0.01 cms/sec, and a thermal conductivity of 4 X 10-4 caI/sec°C cm, one can calculate a Prater temperature of 1.0°C—the maximum possible temperature gradient in the porous structure (107). The simultaneous heat and mass diffusion is not likely to lead to multiple steady states and instability, since the value of the 0 parameter in the Weisz and Hicks theory would be much less than 0.02 (108). 

Mechanisms of micellar reactions have been studied by a kinetic study of the state of the proton at the surface of dodecyl sulfate micelles [191]. Surface diffusion constants of Ni(II) on a sodium dodecyl sulfate micelle were studied by electron spin resonance (ESR). The lateral diffusion constant of Ni(II) was found to be three orders of magnitude less than that in ordinary aqueous solutions [192]. Migration and self-diffusion coefficients of divalent counterions in micellar solutions containing monovalent counterions were studied for solutions of Be2+ in lithium dodecyl sulfate and for solutions of Ca2+ in sodium dodecyl sulfate [193]. The structural disposition of the porphyrin complex and the conformation of the surfactant molecules inside the micellar cavity was studied by NMR on aqueous sodium dodecyl sulfate micelles [194]. 

The objective of most of the theories of transport in porous media is to derive analytical or numerical functions for the effective diffusion coefficient to use in the preceed-ing averaged species continuity equations based on the structure of the media and, more recently, the structure of the solute. 

This example will be of particular interest in our consideration of electrophoresis, and it is also of interest from the point of view of introducing anisotropy into the media structure. Figure 20 shows plots of the effective diffusion coefficient versus porosity for various... 

Obviously, the diffusion coefficient of molecules in a porous medium depends on the density of obstacles that restrict the molecular motion. For self-similar structures, the fractal dimension df is a measure for the fraction of sites that belong... 

Some micro- and mesoporous materials exhibit anisotropic pore structures, which may yield different values for the diffusivities in the three orthogonal spatial directions. In such systems, the self-diffusion should be described by a diffusion tensor rather than by a single scalar self-diffusion coefficient. By measuring over a... 

In order to verify the conditions of this averaging process, one has to relate the displacements during the encoding time - the interval A between two gradient pulses, set to typically 250 ms in these experiments - with the characteristic sizes of the system. Even in the bulk state with a diffusion coefficient D0, the root mean square (rms) displacement of n-heptane or, indeed, any liquid does not exceed several 10 5 m (given that = 2D0 A). This is much smaller than the smallest pellet diameter of 1.5 mm, so that intraparticle diffusion determines the measured diffusion coefficient (see Chapter 3.1). This intrapartide diffusion is hindered by the obstades of the pore structure and is thus reduced relative to D0 the ratio between the measured and the bulk diffusion coeffident is called the tortuosity x. More predsely, the tortuosity r is defined as the ratio of the mean-squared displacements in the bulk and inside the pore space over identical times ... 

---