Dialdehydes, reduction

L-Mannitol does not occur naturally but is obtained by the reduction of L-mannose or L-mannonic acid lactone (80). It can be synthesized from the relatively abundant L-arabinose through the L-mannose and L-glucose cyanohydrins, conversion to the phenylhydrazines which are separated, liberation of L-mannose, and reduction with sodium borohydride (81). Another synthesis is from L-inositol (obtained from its monomethyl ether, quebrachitol) through the diacetonate, periodate oxidation to the blocked dialdehyde, reduction, and removal of the acetone blocking groups (82). 

Cyclohexylamine, hydroxylamine, semicarbazide, (p-nitrophenyl)hy-drazine and (2,4-dinitrophenyl)hydrazine, and isonicotinoylhydrazine gave derivatives (18) of the free dialdehyde. Reduction of the cyclohexylamine derivative occurred with elimination of a molecular proportion of amine, to give the heterocyclic compound (19). The above reactions proved the existence of an equilibrium between the dialdehyde and the hemialdal forms in solution. 

The Stephen s method allows the reduction of nitriles by stannous chloride in acid medium. If the amine chlorhydrate initially formed is hydrolyzed, the corresponding aldehyde is obtained (37, 91). Harington and Moggridge (37) have reduced 4-methyl-5-cyanothiazole by this method (Scheme 23). However, Robba and Le Guen (91) did not obtain the expected products with 4.5-dicyanothiazole and 2-methyl-4,5-dicyanothiazole. These compounds have been reduced with diisobutyl-aluminium hydride with very low yields (3 to 6%) (Scheme 24). In other conditions the reaction gives a thiazole nitrile aldehyde with the same yield as that of the dialdehyde. 

Morpholiaoglucopyranosides have beea syathesized from sucrose by selective lead tetraacetate oxidatioa of the fmctofuranosyl ring to a dialdehyde (6). This product was subjected to reductive amination with sodium borohydride and a primary amine such as benzylamine to produce the /V-henzy1morpho1ino derivative (7) (99). 

This procedure is representative of a new general method for the preparation of noncyclic acyloins by thiazol ium-catalyzed dimerization of aldehydes in the presence of weak bases (Table I). The advantages of this method over the classical reductive coupling of esters or the modern variation in which the intermediate enediolate is trapped by silylation, are the simplicity of the procedure, the inexpensive materials used, and the purity of the products obtained. For volatile aldehydes such as acetaldehyde and propionaldehyde the reaction Is conducted without solvent in a small, heated autoclave. With the exception of furoin the preparation of benzoins from aromatic aldehydes is best carried out with a different thiazolium catalyst bearing an N-methyl or N-ethyl substituent, instead of the N-benzyl group. Benzoins have usually been prepared by cyanide-catalyzed condensation of aromatic and heterocyclic aldehydes.Unsymnetrical acyloins may be obtained by thiazol1um-catalyzed cross-condensation of two different aldehydes. -1 The thiazolium ion-catalyzed cyclization of 1,5-dialdehydes to cyclic acyloins has been reported. 

Aldehyde 198 served as a key intermediate in a synthesis of the alkaloid ajmaline. The. Mannich aminomethylation transform triggers disconnection of two bonds in 198 to form dialdehyde 199, which by connective transform application can be converted to cyclopentene 200.58,59 The reduction in functional group reactivity and in structural complexity are both apparent by comparison of 198 and 200. 

Bell and Hall have incorporated an organometallic unit into a crown by using the ferrocenyl unit as part of the ring or as a third strand. The unit is incorporated either as the 1,1 -diformylferrocene or the corresponding acid. In the former case, the bis-imine is prepared and reduced to give the saturated crown (see structure 24). In the latter case, the acid is converted into its corresponding chloride and thence into the diamide by reaction with a diamine. Diborane reduction affords the saturated amino-crown. Structure 24 could be prepared by either of these methods but the dialdehyde approach was reported to be poor compared to the amide approach which afforded the product in ca. 60% yield . 

Macrocycles have been prepared by formation of macrocyclic imines as well as by using variations of the Williamson ether synthesis ". Typically, a diamine or dialdehyde is treated with its counterpart to yield the Schiff s base. The saturated macrocycle may then be obtained by simple reduction, using sodium borohydride, for example. The cyclization may be metal-ion templated. In the special case of the all-nitrogen macrd-cycle, 15, the condensation of diamine with glyoxal shown in Eq. (4.14), was unsuccess-ful ... 

Quite a number of mixed sulfur-nitrogen macrocycles have been prepared, but these have largely been by the methods outlined in Chaps. 4 and 5 for the respective heteroatoms. An alternative method, involves the formation of a Schiff base, followed by reduction to the fully saturated system, if desired. An interesting example of the Schiff base formation is found in the reaction formulated in (6.12). Dialdehyde 14 is added to ethylenediamine in a solution containing ferrous ions. Although fully characterized, the yield for the reaction is not recorded. To avoid confusion with the original literature, we note the claim that the dialdehyde [14] was readily prepared in good yield by reaction of the disodium salt of 3-thiapentane-l, 5-diol . The latter must be the dithiol rather than the diol. 

Though the dialdehyde-tropinone synthesis does not succeed when the dialdehyde is replaced by a diketone, Blount and Robinson have shown that 1-methyltropinone (XXXV) can be obtained by the interaction of the keto-aldehyde, laevulinaldehyde. Me. CO. CH. CH. CHO, with methylamine and calcium acetonedicarboxylate, and from this by reduction to 1-methyl- -tropine and benzoylation, 1-methyl tropacocaine (b.p. 210°/15 mm. picrate, m.p. 163-4°) has been prepared. 

As to the first point, tartronic dialdehyde (8) could, as has already been suggested (32), be oxidized by classical glycol cleavage to give three molar equivalents of formic acid (and no carbon dioxide) with the concomitant reduction of two (instead of three for the enol form) molar equivalents of periodate ... 

FIGURE 3 Scanning electron micrograph (1200x magnification) of the surface of a porous alumina particle coated with poly(diphenoxy-phosphazene). Surface nitration, reduction, and glutaric dialdehyde coupling immobilized enzyme molecules to the surface. (From Ref. 23.)... 

The reductive couphng of the chiral planar di(imine) 42, prepared from the corresponding chiral (il)-dialdehyde, in turn available as a single enantiomer by standard reactions, can lead to four stereoisomers. The use of... 

Johnson has developed two linear approaches to synthesize the C-nor-D-homosteroid skeleton (Scheme 2.2). In his first approach [21], tetralone 19, obtained from reduction of 2,5-dimethoxynaphthalene, was used as the source of the C,D-rings. The B- and A-rings were constructed by sequential Robinson annulations (19 —> 20 —> 21). The Cl 1,12 olefin was then introduced to provide 22. Ozonolysis of 22 followed by an aldol reaction of the resulting dialdehyde gave 23. Subsequent deformylation and deoxygenation afforded the cyclopamine skeleton 24. 

Cyclic ethers can also be formed in a fashion similar to that of the reactions described previously (Eq. 186),306,342 and also result from the reductive etherification of bis(trimethylsilylated) diols and dialdehydes (Eq. 187).343... 

Since aldehydes are notoriously polymerizable and difficult to manipulate, the products of periodate oxidation are oftentimes further oxidized, with hypohalite, to carboxylic acids, or are reduced to the corresponding alcohols. Oxidation has been more usually employed than reduction, since acids frequently form crystalline salts and other conveniently prepared derivatives. A process of oxidation of these aldehydic products by hypo-bromite, in the presence of barium carbonate or strontium carbonate, was developed and used extensively by Hudson and his coworkers.107 110 194-199,90s Their method can best be illustrated by an example the further oxidation of the dialdehyde, VI, shown previously (see p. 16) to be obtained by the oxidation of the methyl a-D-aldohexopyranosides. The isolation of... 

---