Cyclooctadienes 1.5- Cyclooctadiene

The cyclohexadiene derivative 130 was obtained by the co-cyclization of DMAD with strained alkenes such as norbornene catalyzed by 75[63], However, the linear 2 1 adduct 131 of an alkene and DMAD was obtained selectively using bis(maleic anhydride)(norbornene)palladium (124)[64] as a cat-alyst[65], A similar reaction of allyl alcohol with DMAD is catalyzed by the catalyst 123 to give the linear adducts 132 and 133[66], Reaction of a vinyl ether with DMAD gives the cyclopentene derivatives 134 and 135 as 2 I adducts, and a cyclooctadiene derivative, although the selectivity is not high[67]. 

A hydrocarbon that contains two double bonds is called an alkadiene, and the rela tionship between the double bonds may be described as isolated conjugated or cumu lated Isolated diene units are those m which two carbon-carbon double bond units are separated from each other by one or more sp hybridized carbon atoms 1 4 Pentadiene and 1 5 cyclooctadiene have isolated double bonds... 

Conjugated dienes are those m which two carbon-carbon double bond units are con nected to each other by a single bond 1 3 Pentadiene and 1 3 cyclooctadiene contain conjugated double bonds... 

FIGURE 13 38 The ir ir transition in as trans 1 3 cyclooctadiene involves exci tation of an electron from the highest occupied molec ular orbital (HOMO) to the lowest unoccupied molecu lar orbital (LUMO)... 

HOMO-LUMO energy difference in ethylene is greater than that of cis trans 1 3 cyclooctadiene... 

Bis(bexacbIorocycIopentadieno)cycIooctane. The di-Diels-Alder adduct of hexachlorocyclopentadiene [77 7 ] and cyclooctadiene (44) is a flame retardant having unusually good thermal stabiUty for a chlotinated aUphatic. In fact, this compound is comparable ia thermal stabiUty to brominated aromatics ia some appHcations. Bis(hexachlorocyclopentadieno)cyclooctane is usedia several polymers, especially polyamides (45) and polyolefins (46) for wire and cable appHcations. Its principal drawback is the relatively high use levels required compared to some brominated flame retardants. 

Borabicyclo [3.3.1] nonane [280-64-8], 9-BBN (13) is the most versatile hydroborating agent among dialkylboranes. It is commercially available or can be conveniendy prepared by the hydroboration of 1,5-cyclooctadiene with borane, followed by thermal isomerization of the mixture of isomeric bicychc boranes initially formed (57,109). 

Catalytic Asymmetric Hydroboration. The hydroboration of olefins with catecholborane (an achiral hydroborating agent) is cataly2ed by cationic rhodium complexes with enantiomericaHy pure phosphines, eg, [Rh(cod)2]BE4BINAP, where cod is 1,5-cyclooctadiene and BINAP is... 

The dimerization of isoprene has been accompHshed by methods other than heating. Thus isoprene has been dimerized by uv radiation in the presence of photosensitizers to give a complex mixture of cyclobutane, cyclohexene, and cyclooctadiene derivatives (36,37). Sulfuric acid reportedly... 

The photosensitized dimerization of isoprene in the presence of henzil has been investigated. Mixtures of substituted cyclobutanes, cyclohexenes, and cyclooctadienes were formed and identified (53). The reaction is beheved to proceed by formation of a reactive triplet intermediate. The energy for this triplet state presumably is obtained by interaction with the photoexcited henzil species. Under other conditions, photolysis results in the formation of a methylcydobutene (54,55). 

The reaction of a mixture of 1,5,9-cyclododecatriene (CDT), nickel acetylacetonate [3264-82-2], and diethylethoxyalurninum in ether gives red, air-sensitive, needle crystals of (CDT)Ni [12126-69-1] (66). Crystallographic studies indicate that the nickel atom is located in the center of the 12-membered ring of (CDT)Ni (104). The latter reacts readily with 1,5-cyclooctadiene (COD) to yield bis(COD) nickel [1295-35-8] which has yellow crystals and is fairly air stable, mp 142°C (dec) (20). Bis(COD)nickel also can be prepared by the reaction of 1,5-COD, triethylaluminum, and nickel acetylacetonate. 

Use of HRh(CO)[P(CgH )2]3 as the catalyst and an excess of triphenylphosphine improves the y P ratio. For example, reaction of triethoxysilane with allylamine of equivalent moles at 150°C for 10 h, yields the y-form product ia more than 70% and the y P ratio is 26. Compared with this, when H2PtCl3 is used as the catalyst, the y P ratio is 4 (41). Furthermore, when Rh[(p.-P(C3H3)2-(cyclooctadiene)]2 is used as the catalyst, the yield of y-form product is selectively increased to 92% and that of P-form product is decreased to 1.1% (42). 

A fascinating series of cyclodimeri2ation or cyclotrimeri2ation reactions was first observed in the labs of Wilke to produce 1,5-cyclooctadiene... 

A novel route to azelaic acid is based on butadiene. Butadiene is dimerized to 1,5-cyclooctadiene, which is carbonylated to the monoester in the presence of an alcohol. Hydrolysis of this ester foUowed by a caustic cleavage step produces azelaic acid in both high yield and purity (56). 

The property of chirality is determined by overall molecular topology, and there are many molecules that are chiral even though they do not possess an asymmetrically substituted atom. The examples in Scheme 2.2 include allenes (entries 1 and 2) and spiranes (entries 7 and 8). Entries 3 and 4 are examples of separable chiral atropisomers in which the barrier to rotation results from steric restriction of rotation of the bond between the aiyl rings. The chirality of -cyclooctene and Z, -cyclooctadiene is also dependent on restricted rotation. Manipulation of a molecular model will illustrate that each of these molecules can be converted into its enantiomer by a rotational process by which the ring is turned inside-out. ... 

---