Cycloadditions with pyrroles

This category corresponds to the construction of the carbocyclic ring by 2 + 4 cycloaddition with pyrrole-2,3-quinodimethane intermediates. Such reactions can be particularly useful in the synthesis of 5,6-disubstituted indoles. Although there are a few cases where a pyrrolequinodimethane intermediate is generated, the most useful procedures involve more stable surrogates. Both 1,5-di-hydropyrano[3,4-b]pyrrol-5(lf/)-ones[l] and l,6-dihyropyrano[4,3-b]pyrrol-6-(in)-ones[2] can serve as pyrrole-2,3-quinodimethane equivalents. The adducts undergo elimination of CO2. 

Indoles by cycloaddition with pyrrole-2,3-quinodimethane equivalents... 

More effective stabilization of the siloxyallyl cation was provided by a sulfur donor substituent and resulted in the generation of dienophUes, which could undergo [4+3] cycloadditions with pyrrole derivatives in high yields [19]. Enolsilane 56 in the presence of triflimide generated the corresponding sulfur-stabilized siloxyallyl cation 57, which reacted with A-nosyl pyrrole (R = = H) to afford cyclo-... 

Indoles are usually constructed from aromatic nitrogen compounds by formation of the pyrrole ring as has been the case for all of the synthetic methods discussed in the preceding chapters. Recently, methods for construction of the carbocyclic ring from pyrrole derivatives have received more attention. Scheme 8.1 illustrates some of the potential disconnections. In paths a and b, the syntheses involve construction of a mono-substituted pyrrole with a substituent at C2 or C3 which is capable of cyclization, usually by electrophilic substitution. Paths c and d involve Diels-Alder reactions of 2- or 3-vinyl-pyrroles. While such reactions lead to tetrahydro or dihydroindoles (the latter from acetylenic dienophiles) the adducts can be readily aromatized. Path e represents a category Iley cyclization based on 2 -I- 4 cycloadditions of pyrrole-2,3-quinodimcthane intermediates. 

Furan has the greater reactivity in cycloaddition reactions compared with pyrrole and thiophene the latter is the least reactive diene. However, A -substituted pyrroles show enhanced dienic character compared with the parent heterocycle. 

Pyrrole 1-oxides are known they undergo 1,3-dipolar cycloaddition with DMAD and with A-phenylmaleimide (80TL1833). 

An efficient synthesis of rigid tricyclic (5 5 5) nitrogen heterocycles 64 has been achieved via sequential and tandem Ugi/intramolecular Diels-Alder (IMDA) cycloaddition of pyrrole derivatives <2004JOC1207> and the trienes 477 were prepared by the acylaton of amines 475 with the anhydride 476. The amines 475 were in turn prepared starting from pyrrole-2-carbaldehyde. The triene 477 on heating in toluene at 80 °C for 15 h underwent the IMDA to afford the tricyclic compound 64 as a single diastereomer in quantitative yield. The sterically bulky N-substitutent on the triene 477 promoted cycloaddition under milder condition at 65 °C in toluene to provide the tricyclic compound 64 in quantitative yield (Scheme 108). 

Merlic demonstrated the direct, non-photochemical insertion of carbon monoxide from acylamino chromium carbene complexes 14 to afford a presumed chromium-complexed ketene 15 <00JA7398>. This presumed metal-complexed ketene leads to a munchnone 16 or munchnone complex which undergo dipolar cycloaddition with alkynes to yield the pyrroles 17 upon loss of carbon dioxide. 

Use has been made of the C-N cleavage in the conversion of the bicyclic tertiary amines, derived from the 4tc + 2tc cycloaddition of pyrroles and isoindoles with benzynes, into aromatic systems, e.g. naphthalen-l,4-imines and anthracen-9,10-imines yield naphthalenes and anthracenes with the extrusion of the nitrogen bridge [24] in yields which are higher than those obtained by standard oxidation procedures. 

A study of the regioselectivity of the 1,3-dipolar cycloaddition of aliphatic nitrile oxides with cinnamic acid esters has been published. AMI MO studies on the gas-phase 1,3-dipolar cycloaddition of 1,2,4-triazepine and formonitrile oxide show that the mechanism leading to the most stable adduct is concerted. An ab initio study of the regiochemistry of 1,3-dipolar cycloadditions of diazomethane and formonitrile oxide with ethene, propene, and methyl vinyl ether has been presented. The 1,3-dipolar cycloaddition of mesitonitrile oxide with 4,7-phenanthroline yields both mono-and bis-adducts. Alkynyl(phenyl)iodonium triflates undergo 2 - - 3-cycloaddition with ethyl diazoacetate, Ai-f-butyl-a-phenyl nitrone and f-butyl nitrile oxide to produce substituted pyrroles, dihydroisoxazoles, and isoxazoles respectively." 2/3-Vinyl-franwoctahydro-l,3-benzoxazine (43) undergoes 1,3-dipolar cycloaddition with nitrile oxides with high diastereoselectivity (90% de) (Scheme IS)." " ... 

Upon reaction of A -vinyliminophosphoranes (109) with aromatic isocyanates, vinylcarbodiimides (110) are formed, as shown in Scheme 47. Divi-nylcarbodiimides (111) can be obtained as side products (88CB271). With isonitriles the vinylcarbodiimides also afford pyrroles (112) via [4 + 1]-cycloaddition. Divinylcarbodiimide can also react via [4 -l- l]-cycloaddition with an isonitrile, whereupon an electrocyclic step of the initial diaza-1,3,5-trienes (113) follows. Finally, the pyrrolo[2,3-e]pyrazine 114 is obtained (88CB271). 

Although pyrroles do not generally participate in Diels-Alder reactions with olefinic dienophiles, the very reactive hexafluoro-Dewar benzene with pyrrole gives the 1 1 and 1 2 adducts, 27 and 28, both of which probably have all-ea o stereochemistry. Some other 7-azabicyclo-heptene derivatives have been obtained via cycloaddition reactions of 7-azaquadricyclanes (see Section II, F). 

M-substituted pyrroles 55 entered the Diels-Alder cycloaddition with 1-Me only under high pressure to give mixtures of endo- and exo-adducts 56 (the ratio was not determined) (Scheme 14) [301. 

H. R = COPh) has been prepared from the nitrile (99, R = Me) and benzoyl chloride followed by treatment with sodium hydrogen carbonate. This compound (98, R = R = Ph, R - Me, R = H, R = COPh) undergoes a 1,3- polar cycloaddition with dimethyl acetylene-dicarboxylate in boiling benzene during 10 minutes, yielding the pyrrole... 

Thiophene is present in the benzene fraction from the distillation of coal tar. As with pyrrole and furan, the same type of resonance forms contribute to its overall molecular constitution, and the compound is aromatic in character. There is a difference between thiophene and furan, however, because sulfur is less electronegative than oxygen. Thus, the chemistry of thiophene tends to be closer to that of pyrrole than to that of furan. For example, thiophene does not enter easily into [4 + 2] cycloaddition reactions and quite severe conditions, high pressure (15 bar) and a temperature of 100 C, are necessary in order to force a cycloaddition between it and maleic anhydride. 

Thioisomiinchnones prepared by classical methods (Section 5.1.3) have also been extensively used in [3-1-2] cycloadditions with olefinic dipolarophiles (145-148). In general, the initially formed cycloadducts are isolable. In some instances (Scheme 5.32), they extrude H2S to afford 2-pyridone derivatives of type 88 (148,149). In another example, the double extrusion of H2S and CO occurred to give a pyrrole derivative (150). 

In a series of papers, Laude and co-workers (144-149) examined 1,3-dipolar cycloaddition reactions of mtinchnone imines derived from Reissert compounds. For example, mtinchnone imine 241 undergoes a smooth intramolecular 1,3-dipolar cycloaddition with the tethered alkyne unit to afford pyrrole 242 after extrusion of HNCO (144). 

The auxihary acrylates 161 and 162 have been used in 1,3-dipolar cycloadditions with nitrile oxides. The camphor-derived acrylate 161 underwent a 1,3-dipolar cycloaddition with benzonitrile oxide with up to 56% de (Scheme 12.51) (263). The auxiliary in acrylate 162 is derived from naturally occurring L-quebrachitol, and provided an effective shielding of the re-face of the alkene in the reaction with benzonitrile oxide, as 90% de was obtained (273). Compound 163 was used in a reaction with the nitrone 1-pyrrole-1-oxide, and the reaction proceeded to give a complex mixture of products (274). 

Munchnones 298 obtained in situ by N-alkylation of 5(4/f)-oxazolones undergo 1,3-dipolar cycloaddition with dimethyl acetylenedicarboxylate to give Al-alkylpyr-roles 299. 1,3-Dipolar cycloaddition of munchnones with triphenylvinylphos-phonium bromides affords tri- and tetrasubstituted pyrroles 300. In this case, the interaction of the phosphonium group with the carbonyl group leads to high levels of regioselectivity (Scheme 7.99 Table 7.27, Fig. 7.29). ... 

The cycloaddition reactions of isoquinolinium species produce fused isoquinoline products. The Af-ylide of 53, formed with base addition, couples with alkenes <99S51> or imines <99T7279> to afford tricyclic products, such as 54. Pyrrole-fused isoquinolines result from the reaction between mUnchnone imine intermediates and a,yff-ethylenic esters <99EJOC297>. N-Arylimides undergo 1,3-dipolar cycloaddition with strained frani-cyclooctenes, as opposed to common cycloalkenes, to tdford the pyrazolidine-fused ring system <99H(50)353>. 

Potts and McKeough81 have shown that thieno[3,4-c]pyrroles (84) and thieno[3,4-c]pyrazoles (83) undergo 1,3-dipolar cycloadditions with certain dipolarophiles. Adducts from 84 in some cases eliminated hydrogen sulfide to give isoindoles. 

Wittig reactions with pyrrole-2-aldehyde led to the esters (79) which were cyclisized to 3a-azaazulen-4-ones (80).104,105 4-Methylene-3a-aza-azulenes (81) have been obtained from 80 with stabilized phos-phoranes.36 Reaction of dimethyl acetylenedicarboxylate with 81 could not be achieved. A similar cycloaddition was successful in the synthesis of cycl[3,3,3]azines (2) (Section V). 

N-Substituted pyrroles, furans and dialkylthiophenes undergo photosensitized [2 + 2] cycloadditions with carbonyl compounds to give oxetanes. Furan and benzophenone give the oxetane (192). The photochemical reaction of pyrroles with aliphatic aldehydes and ketones results in the regiospecific formation of 3-(l-hydroxyalkyl)pyrroles (e.g. 193), via an intermediate oxetane which undergoes rearrangement under the reaction conditions (79JOC2949). 

As with the alkyl and aryl derivatives of the pyrrolenines and indolenines, a tautomeric equilibrium has also been noted between the pentachloro-2//- and -3H- pyrroles, such that when the 2//-pyrrole, produced by chlorination of 2,3,4,5-tetrachloropyrrole or of 3,4-dichloromaleimide, is allowed to react with dienophiles, the adducts are those formed by cycloaddition with the 3H-pyrrole tautomer (Scheme 84) (80JOC435, 80JA7862, 81JOC3036). Cycloaddition with cyclopentadiene occurs on the 2H-pyrrole, which behaves as the dienophile. 

---