Cycloaddition reactions high-pressure

When the reaction is carried out on l-acetyl-3-piperidinoindole, the tricyclic intermediate corresponding to (255) can be isolated (78AHC(23)263, 80JOC462). Enhanced yields of benz-azepines are reported by carrying out the cycloadditions under high pressures (80H(14)1959, 81H(16)1367). 

With trifluoromethyl kclones. cycloaddition requires high pressure " however, with highly reactive siloxybutadienes and 2,2.2-trifluoroacetophenone (5) the reaction occurs readily under mild conditions and provides, after desilylation, a tetrahydropyranone. e.g. formation of 6. ... 

Finally, Chataigner and Piettre [100] also developed a multicomponent domino [4+2]/[3+2] cycloaddition under high pressure of 3-nitroindole 177, ethoxyethene 178, and acrylates 141 (Scheme 12.72). The starting material was consumed in 24 h at room temperature, and the formed cycloadduct 179 was isolated in 83% yield and a diastereomeric ratio of 55 45. This domino reaction can be extended to the use of 3-nitropyrroles instead of nitroindoles at 1.6 GPa and 50 °C to afford diastereomeric nitrosoacetals. 

Preparation of a s-cannabidiol by Minuti [72] was effected by the synthesis of 6a-cyano-tetrahydro-6H-benzo[c] chromen-6-ones 198 based on the Diels-Alder cycloaddition under high pressure of 3-cyano-coumarins 196 and 1,3-butadienes 197 (Scheme 48). Cycloadditions carried out at the atmospheric pressure gave the same adducts in significantly lower yields, but at the high temperature (150 °C). The cycloadduct 198a was subsequently converted to cis-cannabidiol in two reaction steps. 

Vinylpyrazoles fail to undergo cycloaddition reactions under conditions used for vinylfurans and vinylthiophenes. l-Phenyl-4-vinylpyrazole (78) and 1-phenyl-5-vinylpyrazole (79) (Figure 2.10) react only with strong dienophiles under pressure and at high temperatures [78-80]. 

The use of ultrasonic (US) radiation (typical range 20 to 850 kHz) to accelerate Diels-Alder reactions is undergoing continuous expansion. There is a parallelism between the ultrasonic and high pressure-assisted reactions. Ultrasonic radiations induce cavitation, that is, the formation and the collapse of microbubbles inside the liquid phase which is accompanied by the local generation of high temperature and high pressure [29]. Snyder and coworkers [30] published the first ultrasound-assisted Diels-Alder reactions that involved the cycloadditions of o-quinone 37 with appropriate dienes 38 to synthesize abietanoid diterpenes A-C (Scheme 4.7) isolated from the traditional Chinese medicine, Dan Shen, prepared from the roots of Salvia miltiorrhiza Bunge. 

The thermal instability of 37 reduces its applicability with poorly reactive dienes such as vinylcyclohexene and its derivatives 38, unless high pressure (HP) is employed. Ultrasound is not only effective in promoting the cycloaddition of 37 with 38, but sometimes also improves the regioselectivity. Some data are illustrated in Table 4.8 and compared with cycloadditions in refluxing benzene and under high pressure. The reactions of 37 with reactive dienes such as cyclopentadiene and l-(trimethylsiloxy)-1,3-butadiene give a good yield of type D adducts under mild conditions, while with less reactive dienes, such as isoprene and butadiene, poor results are obtained. 

An interesting example of accelerating a reaction when high pressure is applied is the synthesis of a series of highly functionalized 4a,5,8,8a-tetrahy-dro-l,4-naphthalenediones 10 by cycloaddition of p-benzoquinone (8) with a variety of electron-poor dienic esters 9 at room temperature (Equation 5.2) reported by Dauben and Baker [6]. Using conventional methods, these heat-sensitive cycloadducts are difficult to synthesize free of the isomeric hydroquin-ones. When the reactions were carried out under thermal conditions, the primary cycloadducts were mostly converted into the corresponding hydroqui-nones. 

Cycloaddition reactions of (E)-l-acetoxybutadiene (18a) and (E)-l-methoxy-butadiene (18b) with the acrylic and crotonic dienophiles 19 were studied under high pressure conditions [9] (Table 5.1). Whereas the reactions of 18a with acrylic dienophiles regioselectively and stereoselectively afforded only ortho-enJo-adducts 20 in fair to good yields, those with crotonic dienophiles did not work. Similar results were obtained in the reactions with diene 18b. The loss of reactivity of the crotonic dienophiles has been ascribed to the combination of steric and electronic effects due to the methyl group at the )S-carbon of the olefinic double bond. 

The different ratios of 52/53 produced by cycloadditions performed at atmospheric and high pressure, and the forma tion of the unusual trans adducts 53, have been explained by the facts that (i) Diels-Alder reactions under atmospheric pressure are thermodynamically controlled, and (ii) the anti-endo adducts 52 are converted into the short-lived syn-endo adducts 54 which tautomerize (via a dienol or its aluminum complexes) to 53. The formation of trans compounds 53 by induced post-cycloaddition isomerization makes the method more flexible and therefore more useful in organic synthesis. 

Whereas tropones usually act as dienes in cycloaddition reactions (Section 5.4), tricarbonyl (tropone) iron 59 displays a reactivity that is almost identical to that of a normal enone. High pressure cycloadditions of 59 with 1-oxygen substituted dienes 60 gave the desired cycloadducts 61 in good to excellent yields (Equation 5.9). The subsequent decomplexation of the cycloadducts has been accomplished by treatment with CAN [20]. 

Cycloaddition reactions of the simple alkyl and aryl aldehydes 65 with (E)-l-methoxy-1,3-butadiene (18b) under high pressure conditions afforded adducts 66 and 67 in reasonable to good yields [2g, 23]. A marked preference for the c applying pressure enforces cnJo-addition (Scheme 5.5). Using mild Lewis-acid catalysts [24], such as Eu(fod)3, Yb(fod)3, or Eu(hfc)3, in combination with pressure, allows good results to be obtained with the added advantage of reducing the pressure to 10 kbar [25] (Scheme 5.5). 

More functionalized 5,6-dihydro-2H-pyran-derivatives 71 and 72 have been prepared [26] by cycloaddition of 1 -methoxy-3-trialkylsilyloxy-1,3-butadienes 69 with t-butylglyoxylate (70) (Scheme 5.6). Whereas thermal reactions did not occur in good yields because of the decomposition of the cycloadducts, application of pressure (10 kbar) allowed milder conditions to be used, which markedly improved the reaction yields. The use of high pressure also gives preferentially en Jo-adduct allowing a stereocontrolled synthesis of a variety of substituted 5,6-dihydro-2H-pyran-derivatives, which are difficult to prepare by other procedures. 

Enantiomers (M)- and (P)-helicenebisquinones [32] 93 have been synthesized by high pressure Diels-Alder reaction of homochiral (+)-(2-p-tolylsulfo-nyl)-l,4-benzoquinone (94) in excess with dienes 95 and 96 prepared from the common precursor 97 (Scheme 5.9). The approach is based on the tandem [4 + 2] cycloaddition/pyrolitic sulfoxide elimination as a general one-pot strategy to enantiomerically enriched polycyclic dihydroquinones. Whereas the formation of (M)-helicene is explained by the endo approach of the arylethene toward the less encumbered face of the quinone, the formation of its enantiomeric (P)-form can be the result of an unfavourable interaction between the OMe group of approaching arylethene and the sulfinyl oxygen of 94. 

The study of high pressure cycloaddition reactions of tropone (125) with maleic anhydride and norbornene allowed the reaction activation volumes to be measured and showed that they are large, negative and solvent-dependent (Scheme 5.17) [43a]. 

Azulene quinones [49b] are compounds related to the family of tropones and are considered to possess great biological and physiological potential. Several polycyclic compounds have been prepared by high pressure (3kbar, PhCl, 130°C, 15h) Diels-Alder reaction of 3-bromo-l,5-azulene quinone (137) and 3-bromo-l,7-azulene quinone (138) with several dienophiles. The cycloadditions were regioselective and afforded cycloadducts in reasonable to good yields (Scheme 5.20). 

High-pressure cycloaddition reactions of 3-bromo-1,5-azulenequinone and 3-bromo-1,7-azulenequinone with dienophiles [68]... 

The Diels-Alder reaction can be greatly enhanced by high pressure (Chapter 5) but the effect of pressure is generally weaker in aqueous medium than in organic solvent. Results of high pressure-mediated Diels-Alder reactions of furans and acrylates in water and dichloromethane are reported in Table 6.6 [32]. In aqueous medium the cycloadditions occur with lower yields and less diastereoselectivity than in dichloromethane and, in some cases, addition-substitution reactions were observed. 

The reaction of furan with 2,5-dihydrothiophene-3,4-dicarboxylic anhydride is remarkable (Scheme 6.19). Furan is a poor diene and requires high pressure to affect cycloadditions [39]. On the other hand, high temperatures are forbidden because cycloaddition products derived from furan undergo cycloreversion under these conditions. In 5.0m LP-DE, the Diels-Alder reaction of furan with 2,5-dihydrothiophene-3,4-dicarboxylic anhydride proceeds at room temperature and atmospheric pressure in 9.5 h with 70 % yield and with the same diastereos-electivity found when the reaction is carried out under high pressure [40]. 

Takeshita H., Mori A., Tian G. R. Carbon-Carbon Double Bond Formation by Means of High-Pressure Cycloaddition-Retro-Diels-Alder Reaction Between 2,3-Bis(Methoxycarbonyl)-7-Oxanorbornadiene and Dienes Yuki Gosei Kagaku Kyo-kaishi 1990 48 132-143... 

---