CSA

To search for the forms of potentials we are considering here simple mechanical models. Two of them, namely cluster support algorithm (CSA) and plane support algorithm (PSA), were described in details in [6]. Providing the experiments with simulated and experimental data, it was shown that the iteration procedure yields the sweeping of the structures which are not volumetric-like or surface-like, correspondingly. While the number of required projections for the reconstruction is reduced by 10 -100 times, the quality of reconstruction estimated quantitatively remained quite comparative (sometimes even with less artefacts) with that result obtained by classic Computer Tomography (CT). 

Fig. 1. Two spatial views of the restored image of the object using 4 projections and CSA...

Chemical shift anisotropy (CSA) 2 Reorientation of the CSA principal axis Increases with the square of the magnetic field [13]... 

The cross-correlation effects between the DD and CSA interactions also influence the transverse relaxation and lead to the phenomenon known as differential line broadening in a doublet [40], cf Figure Bl.13.8. There is a recent experiment, designed for protein studies, that I wish to mention at tire end of this section. It has been proposed by Pervushin etal [4T], is called TROSY (transverse relaxation optimized spectroscopy) and... 

However, because of chemical shielding anisotropy (CSA) and quadnipolar and dipolar effects, the Lamior... 

Many grades of acetal are accepted under the component acceptance program of the Canadian Standards Association (CSA) and are Hsted in the... 

Cambridge Scientific Abstracts (CSA) Electricite de Erance (EDE) Environment Canada Elsevier Science PubUshers EIZ Kadsmhe... 

Canada CSA, Standards Council of Canada, 2000 Argentia Road, Suite 2-401, Mississauga, Ontario. 

Certified testing and approval for control-valve devices used in hazardous locations is normally procured by the manufacturer of the device. The manufacturer often goes to a third party laboratory for testing and certification. Applicable approval standards are available from CSA, CENELEC, EM, SAA, and UL. 

The topology is going to be an isolated, multiple output flyback converter that must meet the safety requirements of UT, CSA, and VDE. These considerations affect the design of the final packaging, transformer, and voltage feedback designs. 

This is going to be a eurrent-mode eontrolled half-bridge topology. It will have soft-start to minimize the start-up surge of the system. The power supply must meet UL, CSA, and VDE safety regulations. 

This eonverter is going to be able to pass UL, CSA, and VDE safety requirements, whieh will affeet the design approaeh that is taken. It will operate between the frequeneies of 1 MHz at the minimum speeified load and no less than 200 kHz at the maximum speeified load. 

---