Crushing hazards

During development, crane operations occur in windy areas and introduce lifting and crush hazards while large components or heavy pieces of equipment are moved. 

Can a person be caught in, on, or between something (e.g., pinching or crushing hazards) ... 

Employers must train each employee assigned to work on or near the equipment ( authorized personnel ) in how to recognize struck-by and pinch/crush hazard areas posed by the rotating superstructure, as well as the meaning behind the markings used. 

Falls, struck-by, and crushing hazards are just a few of the dangers that employees face when it comes to the use of heavy mechanical equipment during site preparation. Employers and employees should examine the work environment to detect any unsafe or unhealthfully conditions, practices, or equipment, and take corrective action before someone gets injured or killed. 

Section 5(a)1 of the Occupational Safety and Health Act of 1970 The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushing hazards from steel rack units ... 

Salts pH of hydrolysed solutions of, 431 Samples crushing and grinding of, 155 dissolution of, 110, 801 weighing of, 76, 110 see also Analysed samples Sampling 150 errors in, 153 hazards of, 155 of gases, 153 of liquids, 153 of solids, 153... 

The zirconium sponge thus obtained is highly pyrophoric. The industrial practice is to condition this sponge by the controlled admittance of air-argon mixtures at around 50 °C. Such a treatment results in the formation of a thin, protective oxide film on the sponge this eliminates any major fire hazard in subsequent handling and crushing operations. 

High-permeability passive perimeter gas control systems entail the installation of highly permeable (relative to the surrounding soil) trenches or wells between the hazardous waste site and the area to be protected (Figure 16.6). The permeable material offers conditions more conductive to gas flow than the surrounding soil, and provides paths of flow to the points of release. High-permeability systems usually take the form of trenches or wells excavated outside the site, then backfilled with a highly permeable medium such as coarse crushed stone. 

Division of Rohm and Haas Co., and the compound was found to be slightly more sensitive to detonation by impact than the commercial explosive RDX. This point should be kept constantly in mind. When the crystals are handled as a slurry or are wet with solvent, the hazard is considerably reduced. On the other hand, the dry perchlorate should be handled with great care and should never be crushed, rubbed, or pushed through a narrow opening. 

Spill/Leak Disposal Isolate the incident scene dress in proper personal protective equipment (see above) do not allow contact with any materials, liquid or gas stop and/or control leak or hazard if possible to do so and control water - use water spray to control vapor and any vapor cloud. Contain product and keep phosgene from entering sewers, streams, or water intakes. Dike surface flow, and depending on the temperature, try to neutralize the product for disposal using agricultural lime (slaked lime), crushed limestone, or soda ash, or sodium bicarbonate. 

Dibromoethane can enter your body after you eat or drink contaminated food and water. It can also enter your body through your skin when you bathe or swim in contaminated water. The 1,2-dibromoethane inside tiny soil particles may enter your body if you crush or eat contaminated soil. The chemical can enter your nose and lungs when you breathe air that contains 1,2-dibromoethane or when you shower with water that is contaminated. Near hazardous waste sites or near areas that once were farmed, the most likely way that you will be exposed is by drinking contaminated groundwater. 

Pearson, F., "Removal of Copper from Acidic Water in a Flume Packed with Crushed Limestone, Proceedings of Hazardous Materials Management Conference and Exposition, Disneyland Hotel, April 5-7, 1988, Sponsored by Association of Bay Area Governments, Oakland, Calif, pp. 431-441, 1988. 

An experimental test to verify the absence of significant concentration gradients inside the catalyst pellet is based on the inverse proportional relation between the effectiveness factor and the pellet diameter for strong internal diffusion limitations. Hence, a measured rate which is independent of the pellet size indicates that internal diffusion limitations can be neglected. Care should be taken to avoid artifacts. External heat transfer effects also depend on pellet size and for exothermic reactions might compensate the internal diffusion limitations. If the catalyst pellet consists of a support with an non-uniformly distributed active phase, crushing and sieving to obtain smaller pellets is hazardous. 

This test is the key to success of any stabilization method for treatment of hazardous waste. Because the waste is crushed and leached using acidic water, the actual leaching of the contaminants depends on their solubility. Thus, as in the case of CBPC formation discussed in Chapters 4-6, solution chemistry plays a major role in stabilization. For this reason, we review the solution chemistry of the hazardous contaminants before we proceed to the actual stabilization. 

---