Copper ions, reactions

Probably because of the rate problem, the very active and highly specific copper-ion reactions apparently have not yet found useful application in paraffin oxidation processes. This further illustrates the requirement that a viable catalyst... 

Kuwabara M, Yoon C, Goyne TE, Thederahn T, Sigman DS. Nuclease activity of 1,10-phenanthroline-copper ion reaction with CGCGAATTCGCG and its complexes with netropsin and EcoRl. Biochemistry. 1986 25 7401-7408. 

Evans and co-workers investigated the effect of a number of -symmetric bis(oxazoline) ligands on the copper(II)-catalysed Diels-Alder reaction of an N-acyloxazolidinone with cyclopentadiene. Enantiomeric excesses of up to 99% have been reported (Scheme 3.4). Evans et al." suggested transition state assembly 3.7, with a square planar coordination environment around the central copper ion. In this scheme the dienophile should be coordinated predominantly in an cisoid fashion in... 

Interestingly, the rate constants for Diels-Alder reaction of the ternary complexes with 3.9 are remarkably similar. Only with 2,2 -bipyridine and 1,10-phenanthroline as ligands, a significant change in reactivity is observed. It might well be that the inability of these complexes to adopt a planar geometry hampers the interaction between the copper ion and the dienophile, resulting in a decrease of the rate of the catalysed Diels-Alder reaction. 

Fortunately, in the presence of excess copper(II)nitrate, the elimination reaction is an order of magnitude slower than the desired Diels-Alder reaction with cyclopentadiene, so that upon addition of an excess of cyclopentadiene and copper(II)nitrate, 4.51 is converted smoothly into copper complex 4.53. Removal of the copper ions by treatment with an aqueous EDTA solution afforded in 71% yield crude Diels-Alder adduct 4.54. Catalysis of the Diels-Alder reaction by nickel(II)nitrate is also... 

In this section the catalytic efficiency of Co(DS)2, Ni(DS)2, Cu(DS)2 andZn(DS)2 micelles as well as the effect of CTAB and C12E7 on the copper-ion catalysed Diels-Alder reaction between 5.1 and 5.2 is described... 

The enhanced binding predicts a catalytic potential for these solutions and prompted us to investigate the influence of the different types of micelles on the rate of the copper-ion catalysed reaction. Table 5.5 summarises the results, which are in perfect agreement with the conclusions drawn from the complexation studies. 

In contrast to the situation in the absence of catalytically active Lewis acids, micelles of Cu(DS)2 induce rate enhancements up to a factor 1.8710 compared to the uncatalysed reaction in acetonitrile. These enzyme-like accelerations result from a very efficient complexation of the dienophile to the catalytically active copper ions, both species being concentrated at the micellar surface. Moreover, the higher affinity of 5.2 for Cu(DS)2 compared to SDS and CTAB (Psj = 96 versus 61 and 68, respectively) will diminish the inhibitory effect due to spatial separation of 5.1 and 5.2 as observed for SDS and CTAB. 

The effects of these ligands on the second-order rate constants for the Cu (ligand) catalysed reaction of Ic with 2 are modest In contrast, the effects on IC2 are more pronounced. The aliphatic Oramino acids induce an approximately two-fold reduction of Iv relative to for the Cu" aquo ion. For the square planar coordinated copper ions this effect is expected on the basis of statistics. The bidentate ligands block half the sites on the copper centre. 

In contrast to SDS, CTAB and C12E7, CufDSjz micelles catalyse the Diels-Alder reaction between 1 and 2 with enzyme-like efficiency, leading to rate enhancements up to 1.8-10 compared to the reaction in acetonitrile. This results primarily from the essentially complete complexation off to the copper ions at the micellar surface. Comparison of the partition coefficients of 2 over the water phase and the micellar pseudophase, as derived from kinetic analysis using the pseudophase model, reveals a higher affinity of 2 for Cu(DS)2 than for SDS and CTAB. The inhibitory effect resulting from spatial separation of la-g and 2 is likely to be at least less pronoimced for Cu(DS)2 than for the other surfactants. 

Apparently the alkoxy radical, R O , abstracts a hydrogen from the substrate, H, and the resulting radical, R" , is oxidized by Cu " (one-electron transfer) to form a carbonium ion that reacts with the carboxylate ion, RCO - The overall process is a chain reaction in which copper ion cycles between + 1 and +2 oxidation states. Suitable substrates include olefins, alcohols, mercaptans, ethers, dienes, sulfides, amines, amides, and various active methylene compounds (44). This reaction can also be used with tert-huty peroxycarbamates to introduce carbamoyloxy groups to these substrates (243). 

The potentiometric micro detection of all aminophenol isomers can be done by titration in two-phase chloroform-water medium (100), or by reaction with iodates or periodates, and the back-titration of excess unreacted compound using a silver amalgam and SCE electrode combination (101). Microamounts of 2-aminophenol can be detected by potentiometric titration with cupric ions using a copper-ion-selective electrode the 3- and... 

The potential of the reaction is given as = (cathodic — anodic reaction) = 0.337 — (—0.440) = +0.777 V. The positive value of the standard cell potential indicates that the reaction is spontaneous as written (see Electrochemical processing). In other words, at thermodynamic equihbrium the concentration of copper ion in the solution is very small. The standard cell potentials are, of course, only guides to be used in practice, as rarely are conditions sufftciendy controlled to be called standard. Other factors may alter the driving force of the reaction, eg, cementation using aluminum metal is usually quite anomalous. Aluminum tends to form a relatively inert oxide coating that can reduce actual cell potential. 

A voltaic cell produces electrical energy through spontaneous redox chemical reactions. When zinc metal is placed in a solution of copper sulfate, an electron transfer takes place between the zinc metal and copper ions. The driving force for the reaction is the greater attraction of the copper ions for electrons ... 

When dezincification occurs in service the brass dissolves anodically and this reaction is electrochemically balanced by the reduction of dissolved oxygen present in the water at the surface of the brass. Both the copper and zinc constituents of the brass dissolve, but the copper is not stable in solution at the potential of dezincifying brass and is rapidly reduced back to metallic copper. Once the attack becomes established, therefore, two cathodic sites exist —the first at the surface of the metal, at which dissolved oxygen is reduced, and a second situated close to the advancing front of the anodic attack where the copper ions produced during the anodic reaction are reduced to form the porous mass of copper which is characteristic of dezincification. The second cathodic reaction can only be sufficient to balance electrochemically the anodic dissolution of the copper of the brass, and without the support of the reduction of oxygen on the outer face (which balances dissolution of the zinc) the attack cannot continue. 

Copper metal can reduce silver ions to metallic silver The copper is oxidized to copper ions according to the reaction... 

Now consider reaction (11). Since zinc releases electrons to copper ion, we know that we must add it to our list at the top ... 

At the zinc electrode, zinc ions pass into solution, leaving an equivalent negative charge on the metal. Copper ions are deposited at the copper electrode, rendering it positively charged. By completing the external circuit, the current (electrons) passes from the zinc to the copper. The chemical reactions in the cell are as follows ... 

Fast sulphon black F ( C.I.26990). This dyestuff is the sodium salt of 1-hydroxy-8-( 2-hydroxynaphthylazo) -2- (sulphonaphthylazo) -3,6-disulph onic acid. The colour reaction seems virtually specific for copper ions. In ammoniacal solution it forms complexes with only copper and nickel the presence of ammonia or pyridine is required for colour formation. In the direct titration of copper in ammoniacal solution the colour change at the end point is from magenta or [depending upon the concentration of copper(II) ions] pale blue to bright green. The indicator action with nickel is poor. Metal ions, such as those of Cd, Pb, Ni, Zn, Ca, and Ba, may be titrated using this indicator by the prior addition of a reasonable excess of standard copper(II) solution. 

A salt bridge serves as an ionconducting connection between the two half-cells. When the external circuit is closed, the oxidation reaction starts with the dissolution of the zinc electrode and the formation of zinc ions in half-cell I. In half-cell II copper ions are reduced and metallic copper is deposited. The sulfate ions remain unchanged in the aqueous solution. The overall cell reaction consists of an electron transfer between zinc and copper ions ... 

The reaction with ammonia or amines, which undoubtedly proceeds by the SnAt mechanism, is catalyzed by copper and nickel salts, though these are normally used only with rather unreactive halides. This reaction, with phase-transfer catalysis, has been used to synthesize triarylamines. Copper ion catalysts (especially cuprous oxide or iodide) also permit the Gabriel synthesis (10-61) to be... 

Effects of current density(I) on the recovery of copper in the reactor can be seen in Fig. 5. As can be seen, the value of R increased gradually with increasing ciurent density, since the mass transfer rate of copper ion is proportional to the current density. Effects of amount of fluidized particles on the recovery of copper can be seen in Fig. 6. Note that the addition of a small amount of fluidized particles (W=1.0wt.%) to the reactor could increase the copper recovery up to 10 25%. It has been mderstood that the contacting of fluidized solid particles with the cathode plate could clean the siuface as well as decrease the diffusion layer of copper ion, which results in the increases of reaction rate and current efficiency, thus, the recovery of copper could be increased. 

When a strip of zinc metal is added to a solution of copper(II) sulfate, the blue color slowly fades, and the zinc metal is replaced by copper metal (Figure 4-13). As copper ions in the solution are reduced to copper metal, zinc atoms are oxidized to Zn cations. This is an example of a metal displacement reaction, in which a metal ion in solution (Cu ) is displaced by another metal (Zn) by means of a redox reaction. Figure 4-13 also shows molecular views of this displacement reaction. 

Zinc metal displaces copper ions from aqueous solution. The blue color signals the presence of copper ions. The color fades and copper metal appears as the reaction proceeds. 

Many other metal displacement reactions can be visualized, but not all of them occur. Some metals are oxidized readily, but others are highly resistant to oxidation. Likewise, some metal cations are highly susceptible to reduction, but others resist reduction. Zinc displaces copper ions from aqueous solutions, but copper will not replace zinc ions, because Cu is easier to reduce than Zn . Zinc will not displace ions, because... 

---