Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Contamination dried

The concentration that could possibly b attained in the river due to contaminated dry lagoon soil (Cw ) was then calculated. [Pg.278]

G.M- Lukszewski, Australians stMining-MetProc 1968, No 228, 6l 70(Eng) CA 70, 98402a (1969) (Reactions of ANFO expl with mineral sulfides were investigated. It was found that ANFO expls were unstable in hot sulfide-rich ore body matrixes. When a sulfide-contaminated dry ANFO was heated to 125— 140° a very violent exothermic reaction took place, but reactivity was increased on incorporating 1—2% water traces of SOq)... [Pg.594]

Low-Level Waste Low-level waste (LLW) consists of contaminated dry trash, paper, plastics, protective clothing, organic liquids such as liquid scintillation samples, and the like. LLW is produced by any facility that handles radioactive materials such as nuclear power plants, medical facilities, colleges, and so forth. In the United States, commercial LLW is sent to one of three disposal sites (Barnwell, South Carolina, Richland, Washington, and Clive, Utah). Due to the limited size of these sites (and similar disposal sites through the world) and steeply escalating costs for waste disposal, the primary goal of LLW treatment prior to disposal is volume reduction, either by incineration or compaction, followed... [Pg.489]

Cleaning Up The pot residue from the reaction is combined with the sodium hydroxide wash and neutralized with sodium Ccu-bonate. The pot residue from the distillation of the product is combined with the acetone used to wash out the apparatus and placed in the organic solvents container. If the sodium sulfate is dry, it can be placed in the nonhazardous solid waste container. If it is wet with organic solvents, it must be placed in the hazardous solid waste container for solvent-contaminated drying agent. [Pg.154]

Two soil systems were considered contaminated dry and wetted soil. Pure supercritical carbon dioxide was able to remove phenol from both systems equally effectively. For the contaminated dry soil, both entrainers increased the distribution coefficient of phenol. However, methanol was by far the most effective. The presence of 2 mol % methanol (based on carbon dioxide) provided almost complete removal of the phenol from the soil. This is probably due to an increase in the polarity of the supercritical phase with the addition of methanol (li). The benzene/carbon dioxide mixture doubled the distribution coefficient, which can be attributed to structural similarities between the benzene and the phenol. [Pg.474]

Listeria monocytogenes is a ubiquitous micro-organism and therefore may contaminate dry cured ham during the production phase. The technology used in production poses a few hurdles such as salting and dehydration, which prevent the germ from growing. [Pg.230]

The foils, ribbons, stripes and wires were recrystallized in vacuum or in air at temperatures higher tan 800°C. The supported platinum catalysts were prepared from aqueous tetrammin nitrate to avoid chlorine contamination, dried (lh/70°C)and calcined (21i/500°C) in air. Dispersion D was determined by... [Pg.276]

Two-phase density calculations require some bookkeeping, as shown in Table 18.1. This table describes mixture composition by its overall contaminant concentration, c, the water concentration of the diluting air, q, and the degrees of condensation (a, a ) for contaminant and water vapor, respectively. The mole budget provides useful ratios, e.g., the overall degree of condensation ( ( , = a - c + a - q (1 — c). When the terms in the right-hand column are normalized by the contents of each phase, we obtain gas-phase concentrations (x, Xa Xw) [mole mole" ] of contaminant, dry air, and humidity, respectively, and liquid-phase concentrations (X, X ) [mole mole" ]. These concentrations are related by =... [Pg.408]

FIGURE 24-2 "Wet glycol may contaminate dry glycol because of a leaking heat exchanger. [Pg.217]

Solid carbon dioxide (dry ice) has a temperature of-109.3°F ( 78.5°C) at 1 atmosphere and must be protected during storage with thermal insulation in order to minimize loss through sublimation. Dry ice should be stored in well-insulated storage containers, preferably in a cool, nonconfined, or ventilated area. Protection from airborne dust and insects should be provided since carbon dioxide vapors naturally attract insects, which will suffocate and contaminate dry ice storage. [Pg.307]

Tissues should be handled gently and wound edges protected from contamination, drying, abrasion, or crushing. [Pg.129]


See other pages where Contamination dried is mentioned: [Pg.78]    [Pg.9]    [Pg.38]    [Pg.277]    [Pg.161]    [Pg.469]    [Pg.84]    [Pg.70]    [Pg.213]    [Pg.55]    [Pg.86]    [Pg.63]    [Pg.332]    [Pg.277]    [Pg.316]    [Pg.259]    [Pg.356]    [Pg.144]   
See also in sourсe #XX -- [ Pg.43 ]

See also in sourсe #XX -- [ Pg.43 ]




SEARCH



© 2024 chempedia.info