Conjugated diene, 1,2-addition

Besides butadiene, another important monomer for the synthetic elastomer industry is chloroprene, which is polymerized to the chemically resistant polychloroprene. It is made by chlorination of butadiene follow by dehydrochlorination. As with most conjugated dienes, addition occurs either 1,2 or 1,4 because the intermediate allyl carbocation is delocalized. The 1,4-isomer can be isomerized to the 1,2-isomer by heating with cuprous chloride. 

In general, the head-to-tail structure is the by far most predominant motif. The proportion of head-to-head structure is small and can only be determined experimentally in some specific cases. Further types of structural isomerism are found in polymeric conjugated dienes addition of a monomer to the chain end can occur in 1,2- and in 1,4-position. Moreover, in the case of nonsymmetric dienes, 3,4-addition is a further possibility ... 

Kambe found that the selectivity could be improved by the use of conjugated diene additives in the nickel-catalyzed cross-couplings of primary alkyl halides or tosylates with various Grignard reagents [19]. Phenylmagnesium bromide can be used for arylations of primary alkyl bromides with [NiCl2] as catalyst and... 

FIGURE 12.84 Two typical reactions of conjugated dienes addition to give an allyl cation and the Diels—Alder reaction. 

In the case of important elastomers formed by polymerisation of conjugated dienes, addition across one double bond can, by electron migration, cause movement of the second double bond. This results in either 1,2 or 1,4 addition across the four-carbon monomer (Figure 2.4). 

Diels-Alder reaction is the 1,4-addition of an alkene or alkyne (dienophile) across a conjugated diene. An example is the addition of pro-penal to buta-l,3-diene to give A -tetrahy-... 

Migration of a hydride ligand from Pd to a coordinated alkene (insertion of alkene) to form an alkyl ligand (alkylpalladium complex) (12) is a typical example of the a, /(-insertion of alkenes. In addition, many other un.saturated bonds such as in conjugated dienes, alkynes, CO2, and carbonyl groups, undergo the q, /(-insertion to Pd-X cr-bonds. The insertion of an internal alkyne to the Pd—C bond to form 13 can be understood as the c -carbopa-lladation of the alkyne. The insertion of butadiene into a Ph—Pd bond leads to the rr-allylpalladium complex 14. The insertion is usually highly stereospecific. 

Diacetoxylation of various conjugated dienes including cyclic dienes has been extensively studied. 1,3-Cyclohexadiene was converted into a mixture of isomeric l,4-diacetoxy-2-cyclohexenes of unknown stereochemistry[303]. The stereoselective Pd-catalyzed 1,4-diacetoxylation of dienes is carried out in AcOH in the presence of LiOAc and /or LiCI and beiizoquinone[304.305]. In the presence of acetate ion and in the absence of chloride ion, /rau.v-diacetox-ylation occurs, whereas addition of a catalytic amount of LiCl changes the stereochemistry to cis addition. The coordination of a chloride ion to Pd makes the cis migration of the acetate from Pd impossible. From 1,3-cyclohexadiene, trans- and ci j-l,4-diacetoxy-2-cyclohexenes (346 and 347) can be prepared stereoselectively. For the 6-substituted 1,3-cycloheptadiene 348, a high diaster-eoselectivity is observed. The stereoselective cij-diacetoxylation of 5-carbo-methoxy-1,3-cyclohexadiene (349) has been applied to the synthesis of dl-shikimic acid (350). 

Addition of several organomercury compounds (methyl, aryl, and benzyl) to conjugated dienes in the presence of Pd(II) salts generates the ir-allylpalladium complex 422, which is subjected to further transformations. A secondary amine reacts to give the tertiary allylic amine 423 in a modest yield along with diene 424 and reduced product 425[382,383]. Even the unconjugated diene 426 is converted into the 7r-allyllic palladium complex 427 by the reaction of PhHgCI via the elimination and reverse readdition of H—Pd—Cl[383]. 

In Grignard reactions, Mg(0) metal reacts with organic halides of. sp carbons (alkyl halides) more easily than halides of sp carbons (aryl and alkenyl halides). On the other hand. Pd(0) complexes react more easily with halides of carbons. In other words, alkenyl and aryl halides undergo facile oxidative additions to Pd(0) to form complexes 1 which have a Pd—C tr-bond as an initial step. Then mainly two transformations of these intermediate complexes are possible insertion and transmetallation. Unsaturated compounds such as alkenes. conjugated dienes, alkynes, and CO insert into the Pd—C bond. The final step of the reactions is reductive elimination or elimination of /J-hydro-gen. At the same time, the Pd(0) catalytic species is regenerated to start a new catalytic cycle. The transmetallation takes place with organometallic compounds of Li, Mg, Zn, B, Al, Sn, Si, Hg, etc., and the reaction terminates by reductive elimination. 

Several types of Pd-catalyzed or -promoted reactions of conjugated dienes via TT-allylpalladium complexes are known. The Pd(II)-promoted oxidative difunctionalization reactions of conjugated dienes with various nucleophiles is treated in Chapter 3, Section 4, and Pd(0)-catalyzed addition reactions of conjugated dienes to aryl and alkenyl halides in this chapter. Section 1.1.1. Other Pd(0)-catalyzed reactions of conjugated dienes are treated in this section. 

Section 10 10 Protonation at the terminal carbon of a conjugated diene system gives an allylic carbocation that can be captured by the halide nucleophile at either of the two sites that share the positive charge Nucleophilic attack at the carbon adjacent to the one that is protonated gives the product of direct addition (1 2 addition) Capture at the other site gives the product of conjugate addition (1 4 addition)... 

Section 10 11 14 Addition predominates when CI2 and Br2 add to conjugated dienes... 

Section 10 12 Conjugate addition of an alkene (the dienophile) to a conjugated diene gives a cyclohexene derivative in a process called the Diels-Alder reaction It is concerted and stereospecific substituents that are cis to each other on the dienophile remain cis m the product... 

This IS called direct addition ox 1 2 addition (The 1 and 2 do not refer to lUPAC locants but are used m a manner analogous to that employed m Section 10 10 to distin guish between direct and conjugate addition to conjugated dienes)... 

Addition (Section 6 1) Reaction in which a reagent X—Y adds to a multiple bond so that X becomes attached to one of the carbons of the multiple bond and Y to the other 1 2 Addition (Section 10 10) Addition of reagents of the type X—Y to conjugated dienes in which X and Y add to adja cent doubly bonded carbons... 

Addition (Section 10 10) Addition of reagents of the type X—Y to conjugated dienes in which X and Y add to the ter mini of the diene system... 

Diels-Alder reaction (Section 10 12) Conjugate addition of an alkene to a conjugated diene to give a cyclohexene denva tive Diels-Alder reactions are extremely useful in synthesis... 

Cyclopentadiene contains conjugated double bonds and an active methylene group and can thus undergo a Diels-Alder diene addition reaction with almost any unsaturated compound, eg, olefins, acetylene, maleic anhydride, etc. The number of its derivatives is extensive only the reactions and derivatives considered most important are discussed. 

As with addition of other electrophiles, halogenation of conjugated dienes can give 1,2- or 1,4-addition products. When molecular bromine is used as the brominating agent in chlorinated hydrocarbon solvent, the 1,4-addition product dominates by 7 1 in the case of butadiene. ... 

Reactions of trifluoroacetonitnle oxide with conjugated dienes also lead to regiospecific additions [36] (equation 36) Its addition to the strain-activated double... 

Figure 13.37 shows the UV spectrum of the conjugated diene cis,trans-, 3-cyc o-octadiene, measured in ethanol as the solvent. As is typical of most UV spectra, the absorption is rather broad and is often spoken of as a band rather than a peak. The wavelength at an absorption maximum is refened to as the X ax of the band. There is only one band in the UV spectrum of 1,3-cyclooctadiene its X ax is 230 ran. In addition to UV-VIS bands are characterized by their- absorbance (A), which is a measure of how much of the radiation that passes through the sfflnple is absorbed. To correct for concentration and path length effects, absorbance is converted to molar absorptivity (e) by dividing it by the concentration c in moles per liter and the path length I in centimeters. 

---