Conductive surfaces

Since scanning tunneling microscopy requires flat conducting surfaces, it is not surprising that most of its early application was to study inorganic materials [17, 19, 20, 29-34]. These studies include investigations of catalytic metal surfaces [24, 35-37], silicon and other oxides [21], superconductors [38], gold... 

STM Scanning tunneling microscopy [9, 19, 31] Tunneling current from probe scans a conducting surface Surface structure... 

Heatshield thickness and weight requirements are determined using a thermal prediction model based on measured thermophysical properties. The models typically include transient heat conduction, surface ablation, and charring in a heatshield having multiple sublayers such as bond, insulation, and substmcture. These models can then be employed for any specific heating environment to determine material thickness requirements and to identify the lightest heatshield materials. 

Surfaces. Essentially any electrically conductive surface can be electroplated, although special techniques may be required to make the surface electrically conductive. Many techniques ate used to metalline nonconductive surfaces. These are weU-covered ia the Hterature (3) and can range from coating with metallic-loaded paints or reduced-silver spray, to autocatalytic processes on tin—palladium activated surfaces or vapor-deposited metals. Preparation steps must be optimized and closely controlled for each substrate being electroplated. 

Propagating brush discharge Very high charging of nonconductive material, preferably in contact with a conductive surface MIE < 101... 

The maximum charge density on a flat, nonconductive surface is limited by the geometry with respect to conductive surfaces (C-2.5.3 through C-2.5.5)... 

Because STM measures a quantum-mechanical tunneling current, the tip must be within a few A of a conducting surface. Therefore any surface oxide or other contaminant will complicate operation under ambient conditions. Nevertheless, a great deal of work has been done in air, liquid, or at low temperatures on inert surfaces. Studies of adsorbed molecules on these surfaces (for example, liquid crystals on highly oriented, pyrolytic graphite ) have shown that STM is capable of even atomic resolution on organic materials. 

Chemical deposits of copper are applied to provide conducting surfaces on non-metallic materials. 

A very similar technique is atomic force microscope (AFM) [38] where the force between the tip and the surface is measured. The interaction is usually much less localized and the lateral resolution with polymers is mostly of the order of 0.5 nm or worse. In some cases of polymer crystals atomic resolution is reported [39], The big advantage for polymers is, however, that non-conducting surfaces can be investigated. Chemical recognition by the use of specific tips is possible and by dynamic techniques a distinction between forces of different types (van der Waals, electrostatic, magnetic etc.) can be made. The resolution of AFM does not, at this moment, reach the atomic resolution of STM and, in particular, defects and localized structures on the atomic scale are difficult to see by AFM. The technique, however, will be developed further and one can expect a large potential for polymer applications. 

Since the pioneering work of Rohrer and Binning,77 scanning tunelling microscopy (STM) has been used to image atomic-scale features of electrically conductive surfaces under ultra-high-vacuum but also at atmospheric pressure and in aqueous electrochemical environments. The ability of STM to image chemisorption and surface reconstruction is well... 

---