Condensation reactions, kinetics

Frost Damage Vaporization/ Condensation Reaction kinetics Vaporization Convect. Temperature Frost damage ... 

At the limit of extremely low particle densities, for example under the conditions prevalent in interstellar space, ion-molecule reactions become important (see chapter A3.51. At very high pressures gas-phase kinetics approach the limit of condensed phase kinetics where elementary reactions are less clearly defined due to the large number of particles involved (see chapter A3.6). 

For very fast reactions, the competition between geminate recombmation of a pair of initially fomied reactants and its escape from the connnon solvent cage is an important phenomenon in condensed-phase kinetics that has received considerable attention botli theoretically and experimentally. An extremely well studied example is the... 

Polyesters were initially discovered and evaluated ia 1929 by W. H. Carothers, who used linear aliphatic polyester materials to develop the fundamental understanding of condensation polymerisation, study the reaction kinetics, and demonstrate that high molecular weight materials were obtainable and could be melt-spun iato fibers (1 5). 

FIG. 23-1 Heat transfer to stirred tank reactors, a) Jacket, (h) Internal coils, (c) Internal tubes, (d) External heat exchanger, (e) External reflux condenser. if) Fired heater. (Walas, Reaction Kinetics for Chemical Engineers, McGraw-Hill, 1959). 

Chapters 1 and 2. Most C—H bonds are very weakly acidic and have no tendency to ionize spontaneously to form carbanions. Reactions that involve carbanion intermediates are therefore usually carried out in the presence of a base which can generate the reactive carbanion intermediate. Base-catalyzed condensation reactions of carbonyl compounds provide many examples of this type of reaction. The reaction between acetophenone and benzaldehyde, which was considered in Section 4.2, for example, requires a basic catalyst to proceed, and the kinetics of the reaction show that the rate is proportional to the catalyst concentration. This is because the neutral acetophenone molecule is not nucleophihc and does not react with benzaldehyde. The much more nucleophilic enolate (carbanion) formed by deprotonation is the reactive nucleophile. 

The study of PF polymerization is far more difficult than that of methylolation due to the increased complexity of the reactions, the intractability of the material, and a resulting lack of adequate analytical methods. When dealing with methylolation, we saw that every reactive ring position had its own reaction rate with formaldehyde that varied with the extent of prior reaction of the ring. Despite this rate sensitivity and complexity, all reactions kinetics were second-order overall, first-order in phenol reactive sites and first-order in formaldehyde. This is not the case with the condensation reactions. 

Scheme 10. Mechanislic possibililies for PF condensalion. Mechanism a involves an SN2-like attack of a phenolic ring on a methylol. This attack would be face-on. Such a mechanism is necessarily second-order. Mechanism b involves formation of a quinone methide intermediate and should be Hrst-order. The quinone methide should react with any nucleophile and should show ethers through both the phenolic and hydroxymethyl oxygens. Reaction c would not be likely in an alkaline solution and is probably illustrative of the mechanism for novolac condensation. The slow step should be formation of the benzyl carbocation. Therefore, this should be a first-order reaction also. Though carbocation formation responds to proton concentration, the effects of acidity will not usually be seen in the reaction kinetics in a given experiment because proton concentration will not vary.

Alkaline co-condensation to yield commercial resins and the products of reaction obtained thereof [93,94] as well as the kinetics of the co-condensation of mono methylol phenols and urea [104,105] have also been reported [17]. Model reactions in order to prove an urea-phenol-formaldehyde co-condensation (reaction of urea with methylolphenols) are described by Tomita and Hse [98,102, 106] and by Pizzi et al. [93,104] (Fig. 1). 

For the kinetically controlled formation of 1,3-disubstituted tetrahydro-P-carbolines, placing both substituents in equatorial positions to reduce 1,3-diaxial interactions resulted in the cw-selectivity usually observed in these reactions." Condensation reactions carried out at or below room temperature in the presence of an acid catalyst gave the kinetic product distribution with the cw-diastereomer being the major product observed, as illustrated by the condensation of L-tryptophan methyl ester 41 with benzaldehyde. At higher reaction temperatures, the condensation reaction was reversible and a thermodynamic product distribution was observed. Cis and trans diastereomers were often obtained in nearly equal amounts suggesting that they have similar energies."... 

As outlined in Chapter 1, polymerisation reactions can be classified as either condensation or addihon processes, the basis of the classification suggested by W. H. Carothers in 1929. More useful, however, is the classification based on reaction kinetics, in which polymerisation reactions are divided into step and chain processes. These latter categories approximate to Carothers condensation and addition reactions but are not completely synonymous with them. 

Chemical vapor deposition processes are complex. Chemical thermodynamics, mass transfer, reaction kinetics and crystal growth all play important roles. Equilibrium thermodynamic analysis is the first step in understanding any CVD process. Thermodynamic calculations are useful in predicting limiting deposition rates and condensed phases in the systems which can deposit under the limiting equilibrium state. These calculations are made for CVD of titanium - - and tantalum diborides, but in dynamic CVD systems equilibrium is rarely achieved and kinetic factors often govern the deposition rate behavior. 

Magnetic field effects on the reaction kinetics or yields of photochemical reactions in the condensed phase have been studied [20-23]. They have proved powerful for verifying the mechanism of photochemical reactions including triplet states. Previously, we obtained photogenerated triplet biradicals of donor-acceptor linked compounds, and found that the lifetimes of the biradicals were remarkably extended in the presence of magnetic fields up to 1T [24]. It has been reported that Cgo and its derivatives form optically transparent microscopic clusters in mixed solvents [25,26]. The clustering behavior of fullerene (C o) is mainly associated with the strong three-dimensional hydrophobic interactions between the C o units. Photoinduced... 

The aldol reaction can be applied to dicarbonyl compounds in which the two groups are favorably disposed for intramolecular reaction. Kinetic studies on cyclization of 5-oxohexanal, 2,5-hexanedione, and 2,6-heptanedione indicate that formation of five-membered rings is thermodynamically somewhat more favorable than formation of six-membered rings, but that the latter is several thousand times faster.170 A catalytic amount of acid or base is frequently satisfactory for formation of five- and six-membered rings, but with more complex structures, the techniques required for directed aldol condensations are used. 

One method of solving the kinetics dilemma is well known in coordination chemistry that is, start with a labile metal ion and render it inert during the course of the synthetic reaction. We have accomplished this in the case of zirconium(IV) by starting with tetrakis(salicylaldehydo)zirconium(IV), which is quite labile, and polymerization with 1,2,4,5-tetraaminobenzene in a Schiff-base condensation reaction in situ (6). The polymeric product contains a "double-headed" quadridentate ligand, which is much more inert to substitution. However, 1,2,4,5-tetraaminobenzene has become very expensive. Therefore, the synthesis of a zirconium polymer with 3,3, 4,4 -tetraaminobiphenyl (commercially 3,3 -diami nobenzidine) with zirconium salicylaldehyde, Zr(sal)4 (7) has been undertaken as shown below ... 

Freeder, B. G. et al., J. Loss Prev. Process Ind., 1988, 1, 164-168 Accidental contamination of a 90 kg cylinder of ethylene oxide with a little sodium hydroxide solution led to explosive failure of the cylinder over 8 hours later [1], Based on later studies of the kinetics and heat release of the poly condensation reaction, it was estimated that after 8 hours and 1 min, some 12.7% of the oxide had condensed with an increase in temperature from 20 to 100°C. At this point the heat release rate was calculated to be 2.1 MJ/min, and 100 s later the temperature and heat release rate would be 160° and 1.67 MJ/s respectively, with 28% condensation. Complete reaction would have been attained some 16 s later at a temperature of 700°C [2], Precautions designed to prevent explosive polymerisation of ethylene oxide are discussed, including rigid exclusion of acids covalent halides, such as aluminium chloride, iron(III) chloride, tin(IV) chloride basic materials like alkali hydroxides, ammonia, amines, metallic potassium and catalytically active solids such as aluminium oxide, iron oxide, or rust [1] A comparative study of the runaway exothermic polymerisation of ethylene oxide and of propylene oxide by 10 wt% of solutions of sodium hydroxide of various concentrations has been done using ARC. Results below show onset temperatures/corrected adiabatic exotherm/maximum pressure attained and heat of polymerisation for the least (0.125 M) and most (1 M) concentrated alkali solutions used as catalysts. 

Peter G. Wolynes is Professor of Chemistry and Biochemistry at the University of California, San Diego. He was previously Professor of Chemistry at the University of Illinois at Urbana-Champaign. He received his A.B. from Indiana University in 1971 and his Ph.D. from Harvard University in 1976. His research area is physical chemistry with specialized interests in chemical physics of condensed matter, quantum dynamics and reaction kinetics in liquids, dynamics of complex... 

I. Condensation of N-Monosubstituted Hydroxylamines with Carbonyl Compounds Condensation of N -monosubstituted hydroxylamines with carbonyl compounds is used as a direct synthesis of many acyclic nitrones. The synthesis of hydroxylamines is being carried out in situ via reduction of nitro compounds with zinc powder in the presence of weak acids (NH4CI or AcOH) (14, 18, 132). The reaction kinetics of benzaldehyde with phenylhydroxylamine and the subsequent reaction sequence are shown in Scheme 2.21 (133). 

---