Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Homogeneous condensation

The entropy of a condensed homogeneous solution (isomorphous solid solution) is then ... [Pg.503]

Knoevenagel condensation, Michael additions, and aldol condensations Homogeneous base catalysts Basic zeolites — [58]... [Pg.204]

Detonations of the condensed homogeneous explosives nitromethane and liquid TNT were found to exhibit unstable periodic behavior. The steady-state Chapman-Jouguet theory of the detonation process will not properly describe the behavior of homogeneous explosives that exhibit such unstable behavior. [Pg.22]

Output cooling air temperature must be lower than the process gas input temperature. This ensures that the process gas is being cooled over the whole length of the glass condenser tubes. However, the process gas must not be so cool that sulfuric acid mist condenses homogeneously inside the glass tubes (Schoubye, 1993). This restricts exit cooling air temperature to above 190 °C. [Pg.306]

As pointed out previously, the separation of homogeneous fluid mixtures requires the creation or addition of another phase. The most common method is by repeated vaporization and condensation— distillation. The three principal advantages of distillation are... [Pg.74]

Into a 750 ml. round-bottomed flask furnished with a reflux condenser place a solution of 34 g. (18-5 ml.) of concentrated sulphuric acid in 100 ml, of water add 33 g. of di-n-butyl cyanamide and a few fragments of porous porcelain. Reflux gently for 6 hours. Cool the resulting homogeneous solution and pour in a cold solution of 52 g. of sodium hydroxide in 95 ml. of water down the side of the flask so that most of it settles at the bottom without mixing with the solution in the flask. Connect the flask with a condenser for downward distillation and shake it to mix the two layers the free amine separates. Heat the flask when the amine with some water distils continue the distillation until no amine separates from a test portion of the distillate. Estimate the weight of water in the distillate anp add about half this amount of potassium hydroxide in the form of sticks, so that it dissolves slowly. [Pg.419]

In a 500 ml. flask, fitted with a reflux condenser, place 53 g. of 1-chloro-methylnaphthalene (Section IV.23), 84 g, of hexamethylenetetramine and 250 ml. of 1 1 acetic acid [CAUTION 1-Chloromethylnaphtha-lene and, to a lesser degree, a-naphthaldehyde have lachrymatory and vesicant properties adequate precautions should therefore be taken to avoid contact with these substances.] Heat the mixture under reflux for 2 hours it becomes homogeneous after about 15 minutes and then an oil commences to separate. Add 100 ml. of concentrated hydrochloric acid and reflux for a further 15 minutes this will hydrolyse any SchifiF s bases which may be formed from amine and aldehyde present and will also convert any amines into the ether-insoluble hydrochlorides. Cool, and extract the mixture with 150 ml. of ether. Wash the ether layer with three 50 ml. portions of water, then cautiously with 50 ml. of 10 per cent, sodium carbonate solution, followed by 50 ml. of water. Dry the ethereal solution with anhydrous magnesium sulphate, remove the ether by distillation on a steam bath, and distil the residue under reduced pressure. Collect the a-naphthaldehyde at 160-162718 mm. the yield is 38 g. [Pg.700]

Hydrolysis of benzyl cyanide to phenylacetamide. In a 1500 ml. three-necked flask, provided with a thermometer, reflux condenser and efficient mechanical stirrer, place 100 g. (98 ml.) of benzyl]cyanide and 400 ml. of concentrated hydrochloric acid. Immerse the flask in a water bath at 40°. and stir the mixture vigorously the benzyl cyanide passes into solution within 20-40 minutes and the temperature of the reaction mixture rises to about 50°, Continue the stirring for an additional 20-30 minutes after the mixture is homogeneous. Replace the warm water in the bath by tap water at 15°, replace the thermometer by a dropping funnel charged with 400 ml. of cold distilled water, and add the latter with stirring crystals commence to separate after about 50-75 ml. have been introduced. When all the water has been run in, cool the mixture externally with ice water for 30 minutes (1), and collect the crude phenylacetamide by filtration at the pump. Remove traces of phenylacetic acid by stirring the wet sohd for about 30 minutes with two 50 ml. portions of cold water dry the crystals at 50-80°. The yield of phenylacetamide, m.p. 154-155°, is 95 g. RecrystaUisation from benzene or rectified spirit raises the m.p. to 156°. [Pg.762]

The structure of the solid determines the mechanism for which internal liquid flow may occur. These mechanisms can include (1) diffusion in continuous, homogeneous solids, (2) capillary flow in granular and porous sohds, (3) flow caused by shrinkage and pressure gradients, (4) flow caused by gravity, and (5) flow caused by a vaporization-condensation sequence. [Pg.1179]

Condensations of aldehydes and ketones are catalyzed homogeneously by acids and bases, but solid bases are preferred, such as anion exchange resins and alkah or alkaline earth hydroxides or phosphates. [Pg.2094]

Polymerization of olefins such as styrene is promoted by acid or base or sodium catalysts, and polyethylene is made with homogeneous peroxides. Condensation polymerization is catalyzed by acid-type catalysts such as metal oxides and sulfonic acids. Addition polymerization is used mainly for olefins, diolefins, and some carbonyl compounds. For these processes, initiators are coordination compounds such as Ziegler-type catalysts, of which halides of transition metals Ti, V, Mo, and W are important examples. [Pg.2095]

Finally, atmospheric chemical transformations are classified in terms of whether they occur as a gas (homogeneous), on a surface, or in a liquid droplet (heterogeneous). An example of the last is the oxidation of dissolved sulfur dioxide in a liquid droplet. Thus, chemical transformations can occur in the gas phase, forming secondary products such as NO2 and O3 in the liquid phase, such as SO2 oxidation in liquid droplets or water films and as gas-to-particle conversion, in which the oxidized product condenses to form an aerosol. [Pg.167]


See other pages where Homogeneous condensation is mentioned: [Pg.503]    [Pg.127]    [Pg.4]    [Pg.286]    [Pg.503]    [Pg.127]    [Pg.4]    [Pg.286]    [Pg.67]    [Pg.264]    [Pg.298]    [Pg.97]    [Pg.403]    [Pg.488]    [Pg.497]    [Pg.567]    [Pg.771]    [Pg.791]    [Pg.911]    [Pg.914]    [Pg.938]    [Pg.939]    [Pg.272]    [Pg.239]    [Pg.58]    [Pg.320]    [Pg.471]    [Pg.424]    [Pg.400]    [Pg.409]    [Pg.251]    [Pg.234]    [Pg.344]    [Pg.395]    [Pg.436]    [Pg.655]    [Pg.655]    [Pg.1414]    [Pg.25]    [Pg.1]    [Pg.76]   
See also in sourсe #XX -- [ Pg.2 , Pg.23 ]




SEARCH



Chemical potential homogeneous nucleation of water-vapor condensation

© 2024 chempedia.info