Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Conative

The standard-state fugacity of any component must be evaluated at the same temperature as that of the solution, regardless of whether the symmetric or unsymmetric convention is used for activity-coefficient normalization. But what about the pressure At low pressures, the effect of pressure on the thermodynamic properties of condensed phases is negligible and under such con-... [Pg.19]

Outside the two-phase region, ELIPS yields a value of 0 for E/F on the R-phase side and 1 for E/F on the E-phase side. Con-, vergence to these values again requires about eight or fewer iterations, except near the plait-point region where convergence is somewhat slower. [Pg.127]

Iron is converted into steel by the Bessemer, Siemens-Martin or electrical processes. Iron can be rendered passive by contact with con-... [Pg.222]

The kinetics of this type of polymerization are the same as for simple condensation for this reason, the use of the term polycondensation is perhaps more appropriate. Unless kinetic evidence suggests otherwise, polymerizations involving the formation of chain polymers from cyclic compounds, following ring scission, are classed as condensation polymerizations. Some important con-... [Pg.321]

C. Nockemann, T. Fritz, G.-R. Tillak, S. Nikisch, D. Surges. Alternative Methoden zur Validierung von ZfP-Verfahren Proc. Annual Con. of the DGZfP 1996... [Pg.677]

Each of the methods described above has its pros and cons. The search method can be the most effective way to find information, but you will need 3 things ... [Pg.977]

Sulphites are oxidised by chlorine water and solutions con-tainingchloric(I) (hypochlorous)acid or the chlorate(I) (hypochlorite) ion... [Pg.292]

It can be seen from Table 2 that the intrinsic values of the pK s are close to the model compound value that we use for Cys(8.3), and that interactions with surrounding titratable residues are responsible for the final apparent values of the ionization constants. It can also be seen that the best agreement with the experimental value is obtained for the YPT structure suplemented with the 27 N-terminal amino acids, although both the original YPT structure and the one with the crystal water molecule give values close to the experimentally determined one. Minimization, however, makes the agreement worse, probably because it w s done without the presence of any solvent molecules, which are important for the residues on the surface of the protein. For the YTS structure, which refers to the protein crystallized with an SO4 ion, the results with and without the ion included in the calculations, arc far from the experimental value. This may indicate that con-... [Pg.193]

An instability of the impulse MTS method for At slightly less than half the period of a normal mode is confirmed by an analytical study of a linear model problem [7]. For another analysis, see [2]. A special case of this model problem, which gives a more transparent description of the phenomenon, is as follows Consider a two-degree-of-freedom system with Hamiltonian p + 5P2 + + 4( 2 This models a system of two springs con-... [Pg.324]

The adjacency matrix of a molecule con.si.sting of n atom.s i.s a square (n / n) matrix. with the entric.s giving all the connectivities of the atoms. The intersection of a row and a column obtains a value of 1 if the corresponding atoms are connected. If there is no bond between the atoms being considered, the position in the matrix obtains the value 0. Thus, this matrix representation is a Boolean matrix with bits (0 or I) (Figure 2-13). [Pg.35]


See other pages where Conative is mentioned: [Pg.351]    [Pg.55]    [Pg.65]    [Pg.93]    [Pg.105]    [Pg.121]    [Pg.208]    [Pg.218]    [Pg.248]    [Pg.255]    [Pg.293]    [Pg.343]    [Pg.357]    [Pg.369]    [Pg.390]    [Pg.422]    [Pg.10]    [Pg.788]    [Pg.804]    [Pg.1485]    [Pg.2384]    [Pg.2510]    [Pg.2570]    [Pg.2945]    [Pg.3000]    [Pg.432]    [Pg.448]    [Pg.495]    [Pg.433]    [Pg.38]    [Pg.118]    [Pg.128]    [Pg.217]    [Pg.226]    [Pg.235]    [Pg.281]    [Pg.301]    [Pg.364]    [Pg.396]    [Pg.458]    [Pg.504]   
See also in sourсe #XX -- [ Pg.97 ]




SEARCH



7-con-O-Methylnogarol antitumor activity

AK-Con

Biotransformations pros/cons

CON division

CON group

Chili con came

Combustion (Con

Con A agarose

Con A induced liver injury

Con A model

Con A-Sepharose

Con Carbon

Con former

Con rotatory

Con sideration

Con thermal

Con-elation

Concanavalin A (Con

Conclusion pros and cons of rapid sensory methods in the automotive context

Conning tower

DNA (Con

Density, gases (Con calculation methods

Di-e/n-7-con-O-methylnogarol synthesis

Emete-Con

Enzyme (Con

Example of a Record in CON Division

Ideal Con tin uous Stirred-tank Fermen ter

Klor-Con/EF

Klor-con

Multicomponent reactions (con tetrafluoroborate

Naphazoline (Albalon, AK-Con

Phosphorus—con

Physical Treatment (Pigging) Pros and Cons

Polymer supports, scope, pros and cons

Pros and Cons of Risk Pooling

Pros and Cons of the Common Control Schemes

Pros and Cons of the Different Treatment Routes

Pros and cons

Pros and cons of using different energy carriers

Rapid Tests Pros and Cons

The Cons

© 2024 chempedia.info