Compressive strength definition

Relation Between Surface Hardness and Compressive Straigth. The surface hardness of latex-modified systems is generally improved to some extent over ordinary cement systems, depending on the polymer type and the polymer-cement ratio. A definite correlation between the surface hardness and compressive strength of most latex-modified systems is recognized as shown in Fig. 4.29.1 ... 

The maximum compressive stress a material is capable of developing. With a brittle material that fails in compression by fracturing, the compressive strength has a definite value. In the case of ductile, malleable, or semi-viscous materials (which do not fail in compression by a shattering fracture), the value obtained for compressive strength is an arbitrary value dependent on the degree of distortion that is regarded as effective failure of the material. 

The static failure theory for brittle materials has historically been the Coulomb-Mohr failure theory. A simple definition of a brittle material is that the ultimate compressive strength is greater than the tensile strength, >5 and the yield strengths are approximately eqnal to the nltimate strengths in tension and compression, = S and Cast iron, rock, and concrete are typical materials that are analyzed by... 

There are three definitions needed to accurately describe this process. (1) Compaction is the compression and consolidation of a two-phase (particulate solid/gas) system by the application of an external force (2) compression causes an increase in the apparent density (or a reduction in volume) by the displacement of air and (3) consolidation is defined as an increase in mechanical strength due to particle-particle interaction [1,2]. 

The compression-molded part, by definition, does not have flow-induced orientation. Comparison of compression-molded part properties with those of an injection-molded part can show the effect of melt temperature on properties. In the compression-molded article without flow-induced orientation, the impact strength remains constant until a certain melt temperature is surpassed and then decreases. This thermal degradation effect can be attributed to the polybutadiene component, which acts as an initiation site for oxidative degradation of the matrices. 

By definition, direct compression diluents are intended to be mixed with other ingredients. Therefore, not only should the pressure-tablet strength profile of the diluent be determined, but also should those of mixtures of the diluent with an active ingredient. The capacity of a direct compression diluent is the proportion of another ingredient that can be mixed with it while still obtaining tablets of acceptable quality. The definition of acceptable will depend on the purpose for which the tablets are required. 

---