Columns strength

It Is seen from equation (9) that the maximum sample volume depends on the square of the radius and inversely on the square root of the column inlet pressure. Now, although (r) and (P) are not mathematically interdependent, there is a practical dependance of (r) on (P). The column must, physically, be able to withstand the the pressure (P) and thus, the column walls must be sufficiently thick to accommodate the pressure for any given radius (r). The aspect of column strength, and weight will be discussed further in due course. Now, if the mass of the selected solute that is required per separation is (M) and is placed on the column in the maximum permissible sample volume (Vj),... 

In the case of our example, the contradiction table (the intersection of the row weight and the column strength ) provides three inventive patterns, listed here in the order of the decreasing probability that they would be useful ... 

Capillary Tubes Figure 12.42 shows a cross section of a typical capillary tube. Most capillary tubes are made from fused silica coated with a 20-35-)J,m layer of poly-imide to give it mechanical strength. The inner diameter is typically 25-75 )J,m, which is smaller than that for a capillary GC column, with an outer diameter of 200-375 )J,m. 

Duplex stainless steels (ca 4% nickel, 23% chrome) have been identified as having potential appHcation to nitric acid service (75). Because they have a lower nickel and higher chromium content than typical austenitic steels, they provide the ductabdity of austenitic SS and the stress—corrosion cracking resistance of ferritic SS. The higher strength and corrosion resistance of duplex steel offer potential cost advantages as a material of constmction for absorption columns (see CORROSION AND CORROSION CONTROL). 

Retention and stereoselectivity on the BSA columns can be changed by the use of additives to the aqueous mobile phase (30). Hydrophobic compounds generally are highly retained on the BSA, and a mobile-phase modifier such as 1-propanol can be added to obtain reasonable retention times. The retention and optical resolution of charged solutes such as carboxyUc acids or amines can be controlled by pH and ionic strength of the mobile phase. 

Detectors. The function of the gc detector is to sense the presence of a constituent of the sample at the outlet of the column. Selectivity is the property that allows the detector to discriminate between constituents. Thus a detector selective to a particular compound type responds especially weU to compounds of that type, but not to other chemical species. The response is the signal strength generated by a given quantity of material. Sensitivity is a measure of the abiHty of the detector to register the presence of the component of interest. It is usually given as the quantity of material that can be detected having a response at twice the noise level of the detector. 

Selection of Equipment Packed columns usually are chosen for very corrosive materials, for liquids that foam badly, for either small-or large-diameter towers involving veiy low allowable pressure drops, and for small-scale operations requiring diameters of less than 0.6 m (2 ft). The type of packing is selected on the basis of resistance to corrosion, mechanical strength, capacity for handling the required flows, mass-transfer efficiency, and cost. Economic factors are discussed later in this sec tion. 

---