Coating 194 INDEX

The coupling coefficients vs. the SRI are reported in Fig. 3.6 b-d for overlay thicknesses of 200, 250, 300 nm, respectively, always with the same coating index of 1.578. From these figures, it can be clearly inferred that increasing the overlay thickness the coupling coefficients curves shift toward lower SRIs as it happens for the effective refractive index curves. 

Economic importance. About 23,000 tons/year of hardmetal are currently used in the western world, which correspond to more than 60% of tungsten demand [9.1]. The world market volume for hardmetal cutting tools in 1995 was estimated to be roughly 9 billion DM [9.10]. The price ofhardmetals, on average, equals that of silver. For special tools, like coated indexable inserts, the price is about double that of silver [9.11]. 

Antireflection coatings are used over the silicon surface which, without the coating, reflects ca 35% of incident sunlight. A typical coating consists of a single layer of a transparent dielectric material with a refractive index of ca 2, which is between the index of siUcon and ait or cover material. Materials such as titanium dioxide, tantalum pentoxide, Ta20, or siUcon nitride, Si N, ca 0.08-p.m thick are common. The coating and a physically textured... 

To achieve the maximum coating opacity the opacifter particle size should be between 0.2 and 0.3 ]lni. A good opacifter should not be soluble in the vitreous system, should have a refractive index substantially different from the refractive index of the system, should be inexpensive, easily milled to a submicrometer particle size, and thermally stable at the film s firing temperature. 

The surface burning characteristics (flame spread index and smoke developed index) for wood and wood products as measured by American Society for Testing and Materials (44) can be reduced with fire retardant treatments, either chemical impregnation or coatings (48). Fire retardant treatments also reduce the heat release rate of a burning piece of wood (49,50). The heat release rates (51) of the burning materials are an important factor in fire growth. 

Glaze coatings (58) are appHed to dry or bisque-fired clay ceramics to form a strong, impermeable surface that is aesthetically pleasing. Protective ceramic coatings can also be deposited by CVD (68,90). Plasma activated CVD has been used extensively to produce diamond and diamondlike films. Diamond films can also be used to make optical coatings with a tailored refractive index. 

---