Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Characteristic time, effect

As is evident from the fomi of the square gradient temi in the free energy fiinctional, equation (A3.3.52). k is like the square of the effective range of interaction. Thus, the dimensionless crossover time depends only weakly on the range of interaction as In (k). For polymer chains of length A, k A. Thus for practical purposes, the dimensionless crossover time is not very different for polymeric systems as compared to the small molecule case. On the other hand, the scaling of to is tln-ough a characteristic time which itself increases linearly with k, and one has... [Pg.740]

The superpositioning of experimental and theoretical curves to evaluate a characteristic time is reminiscent of the time-tefnperature superpositioning described in Sec. 4.10. This parallel is even more apparent if the theoretical curve is drawn on a logarithmic scale, in which case the distance by which the curve has to be shifted measures log r. Note that the limiting values of the ordinate in Fig. 6.6 correspond to the limits described in Eqs. (6.46) and (6.47). Because this method effectively averages over both the buildup and the decay phases of radical concentration, it affords an experimentally less demanding method for the determination of r than alternative methods which utilize either the buildup or the decay portions of the non-stationary-state free-radical concentration. [Pg.379]

A parameter indicating whether viscoelastic effects are important is the Deborah number, which is the ratio of the characteristic relaxation time of the fluid to the characteristic time scale of the flow. For small Deborah numbers, the relaxation is fast compared to the characteristic time of the flow, and the fluid behavior is purely viscous. For veiy large Deborah numbers, the behavior closely resembles that of an elastic solid. [Pg.631]

The fact that there are no characteristic length scales immediately implies a similar lack of any characteristic time scales for the fluctuations. Consider the effect of a single perturbation of a random site of a system in the critical state. The perturbation will spread to the neighbors of the site, to the next nearest neighbors, and so on, until, after a time r and a total of / sand slides, the effects will die out. The distribution of the life-times of the avalanches, D t), obeys the power law... [Pg.441]

Though the accuracy of description of flow curves of real polymer melts, attained by means of Eq. (10), is not always sufficient, but doubtless the equation of such a structure based on the idea of relaxation mechanism of non-Newtonian polymer flow, correctly reflects the main peculiarities of viscous properties. Therefore while discussing the effect a filler has on the viscosity properties of polymer melts, besides the dependences Y(filler modifies the characteristic time of relaxation. According to [19], a possible form of the X versus

[Pg.86]

This is obvious for the simplest case of nondeformable anisotropic particles. Even if such particles do not change the form, i.e. they are rigid, a new in principle effect in comparison to spherical particles, is their turn upon the flow of dispersion. For suspensions of anisodiametrical particles we can introduce a new characteristic time parameter Dr-1, equal to an inverse value of the coefficient of rotational diffusion and, correspondingly, a dimensionless parameter C = yDr 1. The value of Dr is expressed via the ratio of semiaxes of ellipsoid to the viscosity of a dispersion medium. [Pg.89]

The existence of characteristic time D"1 must lead to the appearance of specific relaxation effects. This relaxation mechanism has nothing in common with visco-... [Pg.89]

A possible approach to interpretation of a low-frequency region of the G ( ) dependence of filled polymers is to compare it with a specific relaxation mechanism, which appears due to the presence of a filler in the melt. We have already spoken about two possible mechanisms — the first, associated with adsorption phenomena on a filler s surface and the second, determined by the possibility of rotational diffusion of anisodiametrical particles with characteristic time D 1. But even if these effects are not taken into account, the presence of a filler can be related with the appearance of a new characteristic time, Xf, common for any systems. It is expressed in the following way... [Pg.94]

The characteristic times on which catalytic events occur vary more or less in parallel with the different length scales discussed above. The activation and breaking of a chemical bond inside a molecule occurs in the picosecond regime, completion of an entire reaction cycle from complexation between catalyst and reactants through separation from the product may take anywhere between microseconds for the fastest enzymatic reactions to minutes for complicated reactions on surfaces. On the mesoscopic level, diffusion in and outside pores, and through shaped catalyst particles may take between seconds and minutes, and the residence times of molecules inside entire reactors may be from seconds to, effectively, infinity if the reactants end up in unwanted byproducts such as coke, which stay on the catalyst. [Pg.18]

Another extremely important military characteristic is effectiveness against many different species of insects without the development of resistant strains. Every insecticide that must be added to the military list of supplies geometrically increases the difficulties of procurement and distribution. At the present time, nineteen different insecticides and insect repellents and four different rodenticides are issued by the Army Quartermaster. These figures do not include the different formulations of insect repellents issued under the same stock number. The three basic insect repellents are dimethyl phthlate, Indalone, and Rutgers 612. These repellents are issued either alone or in various combinations, further complicating the supply situation because of the variation in efficiency of these substances against different species of mosquitoes in different parts of the world. [Pg.215]

The self-similar spectrum is not valid at short times, X < X0, where the details of chemical structure become important (glass transition, entanglements, etc.). The cross-over to the glass transition at short times is typical for all polymeric materials, for both liquids and solids. The critical gel is no exception in that respect. X0 could be used as a characteristic time in the CW spectrum since it somehow characterizes the molecular building block of the critical gel however, it has no direct relation to the LST. At times shorter than X0, the LST has no immediate effect on the rheology. Indirect effects might be seen as a shift in the glass transition, for instance, but these will not be studied here. [Pg.175]

Next consider the solute. We will again call the relevant solute nuclear coordinate s and the characteristic time now xs. For a thermally activated bamer crossing, where s is the reaction coordinate for passage over an effective potential VeffH ) at temperature T, a reasonable expression is... [Pg.63]


See other pages where Characteristic time, effect is mentioned: [Pg.131]    [Pg.177]    [Pg.1760]    [Pg.2]    [Pg.53]    [Pg.488]    [Pg.165]    [Pg.448]    [Pg.90]    [Pg.93]    [Pg.65]    [Pg.37]    [Pg.480]    [Pg.212]    [Pg.89]    [Pg.520]    [Pg.45]    [Pg.183]    [Pg.435]    [Pg.119]    [Pg.229]    [Pg.33]    [Pg.598]    [Pg.5]    [Pg.93]    [Pg.82]    [Pg.44]    [Pg.48]    [Pg.68]    [Pg.35]    [Pg.369]    [Pg.139]    [Pg.194]    [Pg.23]    [Pg.235]    [Pg.336]    [Pg.219]    [Pg.44]   
See also in sourсe #XX -- [ Pg.320 ]




SEARCH



Effective time

Time characteristic times

Time effect

© 2024 chempedia.info