Cellulose induced

Langsford et al. reported that Cellulomonas fimi culture supernatants contained cellulase and proteinase activities, for which there appeared to be a relationship. Glucose repressed the synthesis of both activities and cellulose induced both 60), Adding cellulose to Cellulomonas sp. (NRCC 2406) cultures stimulated growth and improved production of cellulases 61). Optimum conditions for growth and cellulase production were pH 6.5 and 30 C. The addition of glucose in the presence of cellulose inhibited growth. Several species of Cellulomonas have cellobiose phosphorylase. 

In addition to their role in primary stabilization related to viscosity increase, some hydrocolloids (particularly carrageenan) are traditionally used as secondary stabilizers. Many of the primary stabilizing hydrocolloids, including locust bean gum and carboxy methyl cellulose induce precipitation of the milk proteins in the mix. This phenomenon in ice cream mix is known as wheying-off, and may be due to direct protein-polysaccharide binding and/or protein-polysaccharide incompatibility in the water phase40. The latter phenomenon may be due to decreased solvent quality due to the competition between protein and polysaccharide for solubilisation. 

Figure 8, Graft copolymerization of methyl methacrylate onto cotton cellulose induced by mechanical cutting with a Wiley mill.

Hult, E.L., et al., 2003. Aggregation of ribbons in bacterial cellulose induced by high pressure incubation. Carbohydrate Polymers 53 (1), 9—14. 

Palme, A., Idstrdm, A., Nordstiema, L., Brelid, H., 2014. Chemical and iiltrastrucmral changes in cotton cellulose induced by laundering and textile use. Cellulose 2 (6), 4681—4691. 

A second degradation process is oxidation, often photo-induced especially by exposure to light not filtered for uv. The radicals resulting from this reaction promote depolymerization of the cellulose, as well as yellowing and fa ding of paper and media. Aging causes paper to become more crystalline and fragile, and this can be exacerbated particularly if the paper is subjected to poor conditions. 

Treatment of the algal cellulose (mixture of la—IP) from Valonia in ethylenediamine to give Cellulose IIIj simultaneously induced sub fibrillation in the initial microfihril (75). Thus crystallites 20 nm wide were spHt into subunits only 3—5 nm wide, even though the length was retained. Conversion of this IIIj back to I gave a material with an electron diffraction pattern and nmr spectmm similar to that of cotton Cellulose ip. 

Our results [104,117] have shown that the extended chains of ethyl cellulose liquid crystal at high pressures can act as the nucleus of PE ECC and induce the formation of ECC. (The details will be introduced in Section IX.)... 

The photo-induced process of modification of cellulose and its derivatives was reported by Geacintov and coworkers [67,68]. Thus, acrylonitrile, vinyl acetate, styrene, MMA, and the binary system of styrene and AN were grafted onto cellulose and cellulose derivatives. In... 

Photo-induced grafting onto wood cellulose with several vinyl monomers using phenyl acetophenone and benzophenone derivatives as photosensitizers has been reported [72]. A fast increase in grafting was observed for short irradiation times, whereas longer ones resulted in a decreased percent grafting. 

The mechanistic details of photo-induced grafting of styrene onto cellulose in the presence of mineral acids with methanol and dioxane as solvents was investigated... 

In general, organic contaminants induce foaming and inorganics increase surface tension, although clearly there are exceptions. For example, sugar increases surface tension, while tannins, lignosulfonates, car-boxymethyl cellulose (CMC), phosphinocarboxylic acids (PCAs), and other dispersants reduce surface tension and help destabilize foams. 

Several procedures have been suggested for heat-mediated cellulose activation, e.g., by using the reaction solvent itself as the heating medium. This activation, first proposed by Ekmanis, is based upon the fact that the vapor pressure of DMAc, near, or at its boiling point is sufficiently high to induce efficient fiber penefration and swelling [50]. Heat activation is considered more... 

Finally, dissolution of non-activated cellulose in LiCl/DMAc, and in ionic liquids has been accelerated by microwave irradiation [72,103,104], although the effect of microwave heating on the DP of the polymer has not been investigated. This last point is relevant in view of the fact that ILs are heated with exceptional efficiency by microwaves [105], so that care must be taken to avoid excessive localized heating that can induce chain degradation of the polymer during its dissolution. 

All cultures were grown with lOg 1 sugar under self-induced anaerobic conditions. Growth and PG activity were measured after 16 hrs. There was no growth on galacturonic acid, pectins, cellulose or rhamnose. indicates standard deviation. 

---