Cells equilibrium redox potential constant

The photoelectrolysis of H2O can be performed in cells being very similar to those applied for the production of electricity. They differ only insofar as no additional redox couple is used in a photoelectrolysis cell. The energy scheme of corresponding systems, semiconductor/liquid/Pt, is illustrated in Fig. 9, the upper scheme for an n-type, the lower for a p-type electrode. In the case of an n-type electrode the hole created by light excitation must react with H2O resulting in 02-formation whereas at the counter electrode H2 is produced. The electrolyte can be described by two redox potentials, E°(H20/H2) and E (H20/02) which differ by 1.23 eV. At equilibrium (left side of Fig. 9) the electrochemical potential (Fermi level) is constant in the whole system and it occurs in the electrolyte somewhere between the two standard energies E°(H20/H2) and E°(H20/02). The exact position depends on the relative concentrations of H2 and O2. Illuminating the n-type electrode the electrons are driven toward the bulk of the semiconductor and reach the counter electrode via the external circuit at which they are consumed for Hj-evolution whereas the holes are dir tly... 

While the redox titration method is potentiometric, the spectroelectrochemistry method is potentiostatic [99]. In this method, the protein solution is introduced into an optically transparent thin layer electrochemical cell. The potential of the transparent electrode is held constant until the ratio of the oxidized to reduced forms of the protein attains equilibrium, according to the Nemst equation. The oxidation-reduction state of the protein is determined by directly measuring the spectra through the tranparent electrode. In this method, as in the redox titration method, the spectral characterization of redox species is required. A series of potentials are sequentially potentiostated so that different oxidized/reduced ratios are obtained. The data is then adjusted to the Nemst equation in order to calculate the standard redox potential of the proteic species. Errors in redox potentials estimated with this method may be in the order of 3 mV. 

It is necessary to distinguish between the concept of a potential and the measurement of a potential. Redox or electrode potentials (quoted in tables in Stability Constants of Metal-Ion Complexes or by Bard et al., 1985) have been derived from equilibrium data, thermal data, and the chemical behavior of a redox couple with respect to known oxidizing and reducing agents, and from direct measurements of electrochemical cells. Hence there is no a priori reason to identify the thermodynamic redox potentials with measurable electrode potentials. 

We mentioned in Sect. 23.2 that galvanic cells can make the energy released by a chemical reaction usable, but they can also be utilized as a measuring instrument for the differences of redox potentials and therefore the electron potentials of various redox pairs. Moreover, because the electron potential itself is determined by the chemical potentials of the substances making up the redox pair, it is also possible to find the fi values as well as the drive A of the underlying total reaction with the help of galvanic cells. Reversible cell voltages measured with zero current can be used to determine these quantities and derived ones such as equilibrium constants. 

Environment and Life, RSC Publishing, p. i60 As this cytoplasmic (in cell) organic chemistry was reductive of necessity, because the ingredients were made of the oxides of carbon, it was inevitable that oxidizing compounds, which became oxygen, would be released. There followed in the environment an unavoidable and predictable sequence of the oxidation of minerals and non-metal elements in solution, limited by diffusion but generally following sequentially equilibrium constants, redox potentials. ... 

The above important relationship now allows evaluation of the thermodynamic driving force of a redox reaction in terms of a measurable cell emf. Moreover, it is possible to utilize the relationship between the standard state potential and the standard state free energy to arrive at an expression for the equilibrium constant of a redox reaction in terms of the emf. Thus... 

Equilibrium considerations other than those of binding are those of oxidation/reduction potentials to which we drew attention in Section 1.14 considering the elements in the sea. Inside cells certain oxidation/reductions also equilibrate rapidly, especially those of transition metal ions with thiols and -S-S- bonds, while most non-metal oxidation/reduction changes between C/H/N/O compounds are slow and kinetically controlled (see Chapter 2). In the case of fast redox reactions oxidation/reduction potentials are fixed constants. 

FIGURE 18.7 The relationship between the equilibrium constant K for a redox reaction with n = 2 and the standard cell potential E°. Note that K is plotted on a logarithmic scale. 

When the equivalence point is reached, the Fe2+ will have been totally consumed (the large equilibrium constant ensures that this will be so), and the potential will then be controlled by the concentration ratio of Ce3+/Ce4+. The idea is that both species of a redox couple must be present in reasonable concentrations for a concentration to control the potential of an electrode of this kind. If one works out the actual cell potentials for various concentrations of all these species, the resulting titration curve looks much like the familiar acid-base titration curve. The end point is found not by measuring a particular cell voltage, but by finding what volume of titrant gives the steepest part of the curve. 

Because the potential of an electrochemical cell depends on the concentrations of the participating ions, the observed potential can be used as a sensitive method for measuring ion concentrations in solution. We have already mentioned the ion-selective electrodes that work by this principle. Another application of the relationship between cell potential and concentration is the determination of equilibrium constants for reactions that are not redox reactions. For example, consider a modified version of the silver concentration cell shown in Fig. 11.11. If the 0.10 M AgN03 solution in the left-hand compartment is replaced by 1.0 M NaCl and an excess of solid AgCl is added to the cell, the observed cell potential can be used to determine the concentration of Ag+ in equilibrium with the AgCl(s). In other words, at 25°C we can write the Nernst equation as... 

The third largest class of enzymes is the oxidoreductases, which transfer electrons. Oxidoreductase reactions are different from other reactions in that they can be divided into two or more half reactions. Usually there are only two half reactions, but the methane monooxygenase reaction can be divided into three "half reactions." Each chemical half reaction makes an independent contribution to the equilibrium constant E for a chemical redox reaction. For chemical reactions the standard reduction potentials ° can be determined for half reactions by using electrochemical cells, and these measurements have provided most of the information on standard chemical thermodynamic properties of ions. This research has been restricted to rather simple reactions for which electrode reactions are reversible on platinized platinum or other metal electrodes. 

When the heterogeneous electron-transfer process at the electrode becomes slow and irreversible, the use of the direct OTTLE/Nernst experiment is inconvenient because of the uncertainties associated with a slow equilibration process. A mediated OTTLE/Nernst experiment should rather be considered, where a redox mediator Mox/Mred characterized by a high heterogeneous rate constant is added to the cell (Eq. 111). The concentration ratio of the mediator couple will be adjusted quickly to the applied electrode potential E and, furthermore, it will be in a redox equilibrium (Eq. 112) with the redox pair O/R in the bulk solution, according to Eq. 113. 

Potentiometric transducers measure the potential under conditions of constant current. This device can be used to determine the analytical quantity of interest, generally the concentration of a certain analyte. The potential that develops in the electrochemical cell is the result of the free-energy change that would occur if the chemical phenomena were to proceed until the equilibrium condition is satisfied. For electrochemical cells containing an anode and a cathode, the potential difference between the cathode electrode potential and the anode electrode potential is the potential of the electrochemical cell. If the reaction is conducted under standard-state conditions, then this equation allows the calculation of the standard cell potential. When the reaction conditions are not standard state, however, one must use the Nernst equation to determine the cell potential. Physical phenomena that do not involve explicit redox reactions, but whose initial conditions have a non-zero free energy, also will generate a potential. An example of this would be ion-concentration gradients across a semi-permeable membrane this can also be a potentiometric phenomenon and is the basis of measurements that use ion-selective electrodes (ISEs). 

The foregoing example illustrates how equilibrium constants for overall cell reactions can be determined electrochemically. Although the example dealt with redox equilibrium, related procedures can be used to measure the solubility product constants of sparingly soluble ionic compounds or the ionization constants of weak acids and bases. Suppose that the solubility product constant of AgCl is to be determined by means of an electrochemical cell. One half-cell contains solid AgCl and Ag metal in equilibrium with a known concentration of CP (aq) (established with 0.00100 M NaCl, for example) so that an unknown but definite concentration of Kg aq) is present. A silver electrode is used so that the half-cell reaction involved is either the reduction of Ag (aq) or the oxidation of Ag. This is, in effect, an Ag" Ag half-cell whose potential is to be determined. The second half-cell can be any whose potential is accurately known, and its choice is a matter of convenience. In the following example, the second half-cell is a standard H30" H2 half-cell. 

The silver-silver chloride electrode is an example of a metal electrode that participates as a member of a redox couple. The silver-silver chloride electrode consists of a silver wire or rod coated with AgCl(s) that is immersed in a chloride solution of constant activity this sets the half-cell potential. The Ag/AgCl electrode is itself considered a potentiometric electrode, as its phase boundary potential is governed by an oxidation-reduction electron transfer equilibrium reaction that occurs at the surface of the silver ... 

We will use standard electrode potentials throughout the rest of this text to calculate cell potentials and equilibrium constants for redox reactions as well as to calculate data for redox titration curves. You should be aware that such calculations sometimes lead to results that are significantly different from those you would obtain in the laboratory. There are two main sources of these differences (1) the necessity of using concentrations in place of activities in the Nernst equation and (2) failure to take into account other equilibria such as dissociation, association, complex formation, and solvolysis. Measurement of electrode potentials can allow us to investigate these equilibria and determine their equilibrium constants, however. 

Calculating Redox Equilibrium Constants Using Cell Potential Data. 

As will be shown later (Section 9.17 and Worked Problem 9.20), the standard electrode potential is related to the equilibrium constant for the cell reaction. This has proved extremely useful for determining equilibrium constants for the redox reactions of inorganic systems and for redox reactions occurring in biological systems. 

---