Hydroboration catecholborane

NaOH-HiOz) or to carboxylic acids (with w-chloroperbenzoic acid).-190 Double bonds can be hydroborated in the presence of triple bonds if the reagent is 9-BBN.191 On the other hand, dimesitylborane selectively hydroborates triple bonds in the presence of double bonds.192 Furthermore, it is often possible to hydroborate selectively one particular double bond of a nonconjugated diene.191 When the reagent is catecholborane, hydroboration is catalyzed by rhodium complexes, such as Wilkinson s catalyst.194 Enantioselective hydro-boration-oxidation has been achieved by the use of optically active rhodium complexes.195... 

Catecholborane hydroborations of carbonyl and related functionalities are also accelerated by RhCl(PPh3)3 (eqs 39 1) however, several related reactions proceed with similar selectivities in the absence of rhodium. ... 

Recently, Fu observed that MAT-dimethylacetamide facilitates catecholborane hydroboration under ambient conditions (2amide leads to the formation of the corresponding H3B amide complex. These observations further illustrate the scope of the above mentioned hydroboration-exchange mechanistic pathway. 

Hydroboration of conjugated dienes proceeds without a catalyst to give 1,2-adducts. However, the less reactive catecholborane reacts with isoprene with catalysis by Pd(PhiP)4, yielding the 1,4-adduct 73[66]. 

Hydrometallation is catalyzed by Pd. Hydroboration of l-buten-2-methyl-3-yne (197) with catecholborane (198) gives the 1,4-adduct 199 with 84% selectivity. The ratio of Pd to phosphine (1 1.5) is important[l 10]. The vinyl sulfide 201 is prepared by a one-pot reaction of the thioalkyne 200 via a Pd-catalyzed hydroborution-coupling sequence using dppf as a ligand[l 11]. 

Catalytic Asymmetric Hydroboration. The hydroboration of olefins with catecholborane (an achiral hydroborating agent) is cataly2ed by cationic rhodium complexes with enantiomericaHy pure phosphines, eg, [Rh(cod)2]BE4BINAP, where cod is 1,5-cyclooctadiene and BINAP is... 

The differences in the steric effect between catecholborane and pinacolborane, and the valence effect between a cationic or neutral rhodium complex reverse the re-gioselechvity for fluoroalkenes (Scheme 1-4) [26]. The reaction affords one of two possible isomers with excellent regioselectivity by selecting borane and the catalyst appropriately, whereas the uncatalyzed reaction of 9-BBN or SiaiBH failed to yield the hydroboration products because of the low nucleophilicity of fluoroalkenes. The regiochemical preference is consistent with the selectivity that is observed in the hydroboration of styrene. Thus, the internal products are selectively obtained when using a cationic rhodium and small catecholborane while bulky pinacolborane yields terminal products in the presence of a neutral rhodium catalyst. 

The dominant factors reversing the conventional ds-hydroboration to the trans-hydroboration are the use of alkyne in excess of catecholborane or pinacolborane and the presence of more than 1 equiv. of EtsN. The P-hydrogen in the ris-product unexpectedly does not derive from the borane reagents because a deuterium label at the terminal carbon selectively migrates to the P-carbon (Scheme 1-5). A vinylidene complex (17) [45] generated by the oxidative addition of the terminal C-H bond to the catalyst is proposed as a key intermediate of the formal trans-hydroboration. 

Hydroboration of alkenes or alkynes followed by cross-coupling with organic electrophiles provides a straightforward method for the carbon-carbon bond formation (Scheme 1-19). The hydroboration of thioalkynes with catecholborane in the presence of a nickel or palladium catalyst yields P-(aLkylthio)-l-alkenylboronates (72a)... 

Catecholborane and pinacolborane, in which the boron has two oxygen substituents, are much less reactive hydroborating reagents than alkyl or haloboranes because the boron electron deficiency is attenuated by the oxygen atoms. Nevertheless, they are useful reagents for certain applications.161 The reactivity of catecholborane has been found to be substantially enhanced by addition of 10-20% of N,N-dimethylacetamide to CH2C12.162... 

Catecholborane and pinacolborane are especially useful in hydroborations catalyzed by transition metals.163 Wilkinson s catalyst Rh(PPh3)3Cl is among those used frequently.164 The general mechanism for catalysis is believed to be similar to that for homogeneous hydrogenation and involves oxidative addition of the borane to the metal, generating a metal hydride.165... 

Alkenylmercury compounds can be prepared by hydroboration of an alkyne with catecholborane, followed by reaction with mercuric acetate.185... 

In addition to trialkylboranes, various alkoxyboron compounds have prominent roles in synthesis. Some of these, such as catecholboranes (see. p. 340) can be made by hydroboration. Others are made by organometallic or related substitution reactions. Alkoxyboron compounds are usually named as esters. Compounds with one alkoxy group are esters of borinic acids and are called borinates. Compounds with two alkoxy groups are called boronates. Trialkoxyboron compounds are borates. 

The field of transition metal-catalyzed hydroboration has developed enormously over the last 20 years and is now one of the most powerful techniques for the transformation of C=C and C=C bonds.1-3 While hydroboration is possible in the absence of a metal catalyst, some of the more common borane reagents attached to heteroatom groups (e.g., catecholborane or HBcat, (1)) react only very slowly at room temperature (Scheme 1) addition of a metal catalyst M] accelerates the reaction. In addition, the ability to manipulate [M] through the judicious choice of ligands (both achiral and chiral) allows the regio-, chemo-, and enantioselectivity to be directed. 

Mannig and Noth reported the first example of rhodium-catalyzed hydroboration to C=C bonds in 1985.4 Catecholborane reacts at room temperature with 5-hexene-2-one at the carbonyl double bond when the reaction was run in the presence of 5mol.% Wilkinson s catalyst [Rh(PPh3)3Cl], addition of the B—H bond across the C=C double bond was observed affording the anti-Markovnikoff ketone as the major product (Scheme 2). Other rhodium complexes showed good catalytic properties ([Rh(COD)Cl2]2, [ Rh(PPh3)2(C O )C 1], where... 

Early work in the field of asymmetric hydroboration employed norbornene as a simple unsaturated substrate. A range of chiral-chelating phosphine ligands were probed (DIOP (5), 2,2 -bis(diphenyl-phosphino)-l,l -binaphthyl (BINAP) (6), 2,3-bis(diphenylphosphino)butane (CHIRAPHOS) (7), 2,4-bis(diphenylphosphino)pentane (BDPP) (8), and l,2-(bis(o-methoxyphenyl)(phenyl)phos-phino)ethane) (DIPAMP) (9)) in combination with [Rh(COD)Cl]2 and catecholborane at room temperature (Scheme 8).45 General observations were that enantioselectivities increased as the temperature was lowered below ambient, but that variations of solvent (THF, benzene, or toluene) had little impact. 

Hydroboration, the addition of a boron-hydrogen bond across an unsaturated moiety, was first discovered by H. C. Brown in 1956. Usually, the reaction does not require a catalyst, and the borane reagent, most commonly diborane (B2H6) or a borane adduct (BH3-THF), reacts rapidly at room temperature to afford, after oxidation, the /AMarkovnikov alkene hydration product. However, when the boron of the hydroborating agent is bonded to heteroatoms which lower the electron deficiency, as is the case in catecholborane (1,3,2-benzodioxaborole) 1 (Scheme 1), elevated temperatures are needed for hydroboration to occur.4 5... 

The development of a catalytic hydroboration process was aided by the observation of Kono and Ito in 1975 that Wilkinson s catalyst [Rh(PPh3)3Cl] 2 undergoes oxidative addition when treated with catecholborane 1 (Scheme l).6... 

It took another decade however before the idea of developing a rhodium-catalyzed olefin hydroboration process came to fruition. This occurred in 1985 when Mannig and Noth reported the first examples of such a process.8 They discovered that Wilkinson s catalyst 2 was effective for the addition of catecholborane 1 to a range of alkenes and alkynes, as exemplified by cyclopentene 4 (Scheme 2). 

The uncatalyzed hydroboration-oxidation of an alkene usually affords the //-Markovnikov product while the catalyzed version can be induced to produce either Markovnikov or /z/z-Markovnikov products. The regioselectivity obtained with a catalyst has been shown to depend on the ligands attached to the metal and also on the steric and electronic properties of the reacting alkene.69 In the case of monosubstituted alkenes (except for vinylarenes), the anti-Markovnikov alcohol is obtained as the major product in either the presence or absence of a metal catalyst. However, the difference is that the metal-catalyzed reaction with catecholborane proceeds to completion within minutes at room temperature, while extended heating at 90 °C is required for the uncatalyzed transformation.60 It should be noted that there is a reversal of regioselectivity from Markovnikov B-H addition in unfunctionalized terminal olefins to the anti-Markovnikov manner in monosubstituted perfluoroalkenes, both in the achiral and chiral versions.70,71... 

Table 1 Differences in regioselectivity between catalyzed and uncatalyzed hydroboration of vinylarenes with catecholborane...

Table 2 Hydroboration of norbornene, indene, and styrene using catecholborane...

While Josiphos 41 also possessed an element of atom-centered chirality in the side chain, Reetz reported a new class of ferrocene-derived diphosphines which had planar chirality only ligands 42 and 43, which have C2- and C -symmetry, respectively.87 Rhodium(i)-complexes of ligands (—)-42 and (—)-43 were used in situ as catalysts (0.75 mol%) for the hydroboration of styrene with catecholborane 1 for 12 h in toluene at — 50 °C. The rhodium/ i-symmetric (—)-43 catalyst system was the more enantioselective of the two - ( -l-phenylethanol was afforded with 52% and 77% ee with diphosphines (—)-42 and (—)-43, respectively. In both cases, the regioselectivity was excellent (>99 1). With the same reaction time but using DME as solvent at lower temperature (—60 °C), the rhodium complex of 43 afforded the alcohol product with an optimum 84% ee. 

Ligand 73 was prepared directly from a single enantiomer of the corresponding naphthol of QUINAP 60, an early intermediate in the original synthesis, and both enantiomers of BINOL. Application in hydroboration found that, in practice, only one of the cationic rhodium complexes of the diastereomeric pair proved effective, (aA, A)-73. While (aA, A)-73 gave 68% ee for the hydroboration of styrene (70% yield), the diastereomer (aA, R)-73 afforded the product alcohol after oxidation with an attenuated 2% ee (55% yield) and the same trend was apparent in the hydroboration of electron-poor vinylarenes. Indeed, even with (aA, A)-73, the asymmetries induced were very modest (31-51% ee). The hydroboration pre-catalyst was examined in the presence of catecholborane 1 at low temperatures and binuclear reactive intermediates were identified. However, when similar experiments were conducted with QUINAP 60, no intermediates of the same structural type were found.100... 

---