Buildings legislative requirements

As discussed above, there are laws and regulations which dictate where and how we build and operate our process plants. These vary between countries. It is necessary to meet the legislative requirements of the country in which we operate. 

The posting of fire safety signs has been a legislative requirement for many years. Their primary purpose is to ensure that the occupants and users of buildings are aware, not only, of escape routes and exits but also of any hazards and dangers that may be present. 

Numbers These should be kept to the minimum, consistent with operational requirements and any other requirements imposed under Building Regulations and fire/health and safety legislation ... 

Vitrified slag. This has a quality that meets the requirements of Dutch legislation for secondary building materials. 

Similarly, legislation has been, or will be, introduced to deal with the disposal of treated wood waste at the end of a product lifetime. No longer will it be acceptable to dispose of treated wood waste by dumping in landfill. Proper disposal will require the incineration of treated wood waste in appropriate facilities that have the necessary equipment to prevent stack emissions of toxic compounds. This requires expensive investment to build plant that can meet the relevant environmental requirements. Such methods probably represent the best option for the permanent removal of these potential pollutants. The ash generated in these plants may contain high concentrations of arsenic, which will then have to be disposed of as hazardous waste. 

Clean air is an important prerequisite for sustainable development and is a basic requirement for human health and welfare. In addition, air pollutants contribute to atmospheric problems such as acidification and global climate change, which have impacts on crop productivity, forest growth, biodiversity, buildings, and cultural monuments. The benefits from the progress made in the areas of waste gas treatment and environmental legislation are partially offset by industrialization, an increase in the number of private cars in use, and overpopulation. 

For work areas (rooms inside buildings in which workplaces have been permanently installed) the requirements relating to workplaces as specified in the Workplaces Ordinance must be observed. Basically rooms in workplaces (such as office rooms, for example) are deemed to be indoor environments in the aforementioned sense when the air pollutants found there are not used as working materials or when a working material from an area subject to hazardous substances legislation crosses into these rooms (Welzbacher, 1999). 

Title III - Indoor Radon Abatement-. This change was made on October 28,1988 (Pub. L. 100-551). The purpose of this legislation was to assist states in responding to the threat to human health posed by exposure to radon. EPA is required to publish and keep current a citizen s guide to radon health risk, and to perform studies of the radon levels in schools and radon contamination in federal buildings. 

Health and safety considerations need to be taken into account. Legislation, even though not yet enacted, could require a product to be replaced while it is stUl functionally effective and cost effective. One of the best fibrous reinforcements in the FRP world used to be asbestos. Its strength, stiffness and especially its heat resistance were outstanding, but since the mid-1970s, removing asbestos-based materials from factories, schools and other buildings has been an industry in itself. It is therefore prudent to consider the... 

---