Blunting

This method is by far the easiest of the two methods I descnbe, but because it uses bromine liquid as a precursor to the dibromodioxane crystals a fume cupboard (or a fucking good method of fume extraction) is absolutely essential. Surgically removing ones gonads with a blunt knife would be a much less painful way of harming yourself than messing with this stuff in the kitchen. 

The performance of a tool material in a given appHcation is dictated by its response to conditions at the tool tip. High temperatures and stresses can cause blunting from the plastic deformation of the tool tip, whereas high stresses alone may lead to catastrophic fracture. In addition to plastic deformation and fracture, the service life of cutting tools is deterrnined by a number of wear processes, some of which are shown in Figure 2. 

In turbulent flow, the velocity profile is much more blunt, with most of the velocity gradient being in a region near the wall, described by a universal velocity profile. It is characterized by a viscous sublayer, a turbulent core, and a buffer zone in between. 

Vortex-Shedding Flowmeters These flowmeters take advantage of vortex shedding, which occurs when a fluid flows past a non-streamlined objec t (a Blunt body). The flow cannot follow the shape of the object and separates from it, forming turbulent vortices or eddies at the object s side surfaces. As the vortices move downstream, they grow in size and are eventually shed or detached from the objec t. 

Column Operation To assure intimate contact between the counterflowing interstitial streams, the volume fraction of liquid in the foam should be kept below about 10 percent—and the lower the better. Also, rather uniform bubble sizes are desirable. The foam bubbles will thus pack together as blunted polyhedra rather than as spheres, and the suction in the capillaries (Plateau borders) so formed vidll promote good liqiiid distribution and contact. To allow for this desirable deviation from sphericity, S = 6.3/d in the equations for enriching, stripping, and combined column operation [Lemhch, Chem. E/ig., 75(27), 95 (1968) 76(6), 5 (1969)]. Diameter d still refers to the sphere. 

Close visual inspection of the blunt, fractured ends revealed small secondary cracks along the internal surface. Internal surfaces were covered with a layer of deposit that was highly alkaline (Fig. 9.18). 

Figure 10.3 Blunt fracture edges typical of corrosion-fatigue cracks.

A somewhat similar thing happens in many polymers at the glass-rubber transition that we mentioned in Chapter 6. Below the transition these polymers are much more brittle than above it, as you can easily demonstrate by cooling a piece of rubber or polyethylene in liquid nitrogen. (Many other polymers, like epoxy resins, have low Gc values at all temperatures simply because they are heavily cross-linked at all temperatures by covalent bonds and the material does not flow at the crack tip to cause blunting.)... 

Shock in rotor losses. This loss is due to shock occurring at the rotor inlet. The inlet of the rotor blades should be wedgelike to sustain a weak oblique shock, and then gradually expanded to the blade thickness to avoid another shock. If the blades are blunt, a bow shock will result, causing the flow to detach from the blade wall and the loss to be higher. 

---