Aromatic acids Substituted

Aliphatic and aromatic acids, simple and substituted, vary con siderably in their properties, and no one reaction for the preparation of crystalline derivatives is general. The following are recommended as most promising. 

All laromatics. The aromatic ring is fairly inert toward attack by oxygen-centered radicals. Aromatic acids consisting of carboxyl groups substituted on aromatic rings are good candidates for production by LPO of alkylaromatics since thek k /k ratios are low. TerephthaUc acid [100-21 -0]... 

Ozonation of Aromatics. Aromatic ring unsaturation is attacked much slower than olefinic double bonds, but behaves as if the double bonds in the classical Kekule stmctures really do exist. Thus, benzene yields three moles of glyoxal, which can be oxidized further to glyoxyUc acid and then to oxahc acid. Substituted aromatics give mixtures of aUphatic acids. Ring substituents such as amino, nitro, and sulfonate are cleaved during ozonation. 

The aromatic ring has high electron density. As a result of this electron density, toluene behaves as a base, not only in aromatic ring substitution reactions but also in the formation of charge-transfer (tt) complexes and in the formation of complexes with super acids. In this regard, toluene is intermediate in reactivity between benzene and the xylenes, as illustrated in Table 2. 

Production of cellulose esters from aromatic acids has not been commercialized because of unfavorable economics. These esters are usually prepared from highly reactive regenerated cellulose, and their physical properties do not differ markedly from cellulose esters prepared from the more readily available aHphatic acids. Benzoate esters have been prepared from regenerated cellulose with benzoyl chloride in pyridine—nitrobenzene (27) or benzene (28). These benzoate esters are soluble in common organic solvents such as acetone or chloroform. Benzoate esters, as well as the nitrochloro-, and methoxy-substituted benzoates, have been prepared from cellulose with the appropriate aromatic acid and chloroacetic anhydride as the impelling agent and magnesium perchlorate as the catalyst (29). 

Substitutions that displace electrons toward the carboxyl group of aromatic acids diminish the rate of the reaction (16). The substitution of fluoromethoxy or ethoxy groups in the ortho position has an accelerating action, whereas iodo, bromo, nitro, or methyl groups produce retardation. The influence of groups in the meta and para positions is not nearly so marked (17). 

In a series of organic acids of similar type, not much tendency exists for one acid to be more reactive than another. For example, in the replacement of stearic acid in methyl stearate by acetic acid, the equilibrium constant is 1.0. However, acidolysis in formic acid is usually much faster than in acetic acid, due to higher acidity and better ionizing properties of the former (115). Branched-chain acids, and some aromatic acids, especially stericaHy hindered acids such as ortho-substituted benzoic acids, would be expected to be less active in replacing other acids. Mixtures of esters are obtained when acidolysis is carried out without forcing the replacement to completion by removing one of the products. The acidolysis equilibrium and mechanism are discussed in detail in Reference 115. 

Medium reactivity contaminants alcohols, ketones, organic acids, esters, alkyl-substituted aromatics, nitro-substituted aromatics, carbohydrates. 

Tetrahydroharman, m.p. 179-80°, has been prepared by a number of workers by a modification of this reaction, viz., by the interaction of tryptamine (3-)5-aminoethylindole) with acetaldehyde or paraldehyde and Hahn et al. have obtained a series of derivatives of tetrahydronorharman by the use of other aldehydes and a-ketonic acids under biological conditions of pH and temperature, while Asahina and Osada, by the action of aromatic acid chlorides on the same amine, have prepared a series of amides from which the corresponding substituted dihydronorharmans have been made by effecting ring closure with phosphorus pentoxide in xylene solution. 

If a substituted aromatic hydrocarbon is used, the ketone gioLip then enteis the paia-position, or, if this is occupied, the oitho-position. Substituted aromatic acid chlorides may. also be used, and if the acid is dibasic and has two caiboxyl chloiide gioups, two molecules of the aromatic hydiocaibon may be. attached. If phosgene is used with two molecules of benzene, benzophenone is obtained. 

Reactions that occur with the development of an electron deficiency, such as aromatic electrophilic substitutions, are best correlated by substituent constants based on a more appropriate defining reaction than the ionization of benzoic acids. Brown and Okamoto adopted the rates of solvolysis of substituted phenyldimeth-ylcarbinyl chlorides (r-cumyl chlorides) in 90% aqueous acetone at 25°C to define electrophilic substituent constants symbolized o-. Their procedure was to establish a conventional Hammett plot of log (.k/k°) against (t for 16 /wcra-substituted r-cumyl chlorides, because meta substituents cannot undergo significant direct resonance interaction with the reaction site. The resulting p value of —4.54 was then used in a modified Hammett equation. 

Heating isoxazole derivatives with aqueous-alkaline permanganate leads to a complete degradation of the heterocycle. With arylisoxa-zoles this results in readily identifiable aromatic acids, from which can be deduced the orientation of electrophilic substitution reac-tions. ° Also, the stability of various heterocycles can be compared. Thus, under these reaction conditions, the pyrazole ring is more stable than that of isoxazole (cf. 197198). ... 

Rhenium oxides are also useful in reduction of carboxylic acids (170" C, 3500 psig). Aromatic acids can be reduced to alcohols without ring saturation 3,4,S,6). Strongly synergistic effects were found on substituting half of the Re207 with rulhenium-on-carbon, and excellent results can be obtained al... 

The various methods that are used for the production of aromatic acids from the corresponding substituted toluenes are outlined in Figure 1. The first two methods -chlorination/hydrolysis and nitric acid oxidation - have the disadvantage of relatively low atom utilization (ref. 13) with the concomitant inorganic salt production. Catalytic autoxidation, in contrast, has an atom utilization of 87% (for Ar=Ph) and produces no inorganic salts and no chlorinated or nitrated byproducts. It consumes only the cheap raw material, oxygen, and produces water as the only byproduct. 

Consequently, as a result of increasing environmental pressure many chlorine and nitric acid based processes for the manufacture of substituted aromatic acids are currently being replaced by cleaner, catalytic autoxidation processes. Benzoic acid is traditionally manufactured (ref. 14) via cobalt-catalyzed autoxidation of toluene in the absence of solvent (Fig. 2). The selectivity is ca. 90% at 30% toluene conversion. As noted earlier, oxidation of p-xylene under these conditions gives p-toluic acid in high yield. For further oxidation to terephthalic acid the stronger bromide/cobalt/manganese cocktail is needed. 

The next step in the development of the extrathermodynamic approach was to find a suitable expression for the equilibrium constant in terms of physicochemical and conformational (steric) properties of the drug. Use was made of a physicochemical interpretation of the dissociation constants of substituted aromatic acids in terms of the electronic properties of the substituents. This approach had already been introduced by Hammett in 1940 [14]. The Hammett equation relates the dissociation constant of a substituted benzoic acid (e.g. meta-chlorobenzoic acid) to the so-called Hammett electronic parameter a ... 

Novel 5-methyl-substituted [l,2,4]triazolo[3,4- ]benzothiazoles 397 have been prepared from 2-hydrazino-4-methylbenzothiazole 393 and several aromatic acids (Equation 76) <2002JST41, 2001MI2>. 

The reaction is believed to begin with the metalation of the substrate via aromatic electrophilic substitution (SEAr) followed by CO insertion and nucleophilic displacement by water or another protic nucleophile such as tri-fluoroacetic acid (TFFA) to give, respectively, the aromatic carboxylic acid or its mixed anhydride derivative, from which the acid is freed by hydrolysis (Scheme 24). 

The phthalic anhydride based resins were the first developed useful unsaturated resins. Using phthalic anhydride offers resin producers the flexibility to substitute, mole-for-mole , maleic anhydride out of the formulation and therefore reduce the active double-bond sites. Consequently, the product becomes less brittle. Furthermore, aromatic acid components in the polymer backbone provided much better strength for the cured products. Phthalic anhydride is not a costly material and historically it is similarly priced to maleic anhydride. By... 

---