Angle of slope

Angle of slope The optimum slope of inclined vibrating screens is that which will handle the greatest volume of oversize and still remove the available undersize required by the standards of the particular operation. To separate a material into coarse and fine fractions, the bed thickness must be limited so that vibration can stratify the load and allow fines to work their way to the screen surface and pass through the opening. Increased slope naturally increases the rate of travel, and at a given rate it reduces the bed thickness. 

Bbschungswlnkel, m. angle of slope. bSse, a. bad, evil harmful, noxious sore, aching. — boses Wesen, epilei y. — bdses Wetter, choke damp. 

As regards shear flow the role of particle s geometry of the filler is rather unambiguous with an increase in the ratio between the length of the filler and their diameter the viscosity of equiconcentrated dispersions increases [22], as it is schematically shown in Fig. 13. For the region q> -> 0 this effect results in an increase in the initial angle of slope of tangents to the dependences r)sp([Pg.89]

While landfills may outwardly appear simple, they need to operate carefully and follow specific guidelines that inclnde where to start filling, wind direction, the type of equipment used, method of filling, roadways to and within the landfill, the angle of slope of each daily cell, controlling contact of the waste with groundwater, and the handling of equ ment at the landfill site. 

It was stated, that macroporous carbons of plant origin show better properties in dynamic than in static conditions. It is cormected with relationship of quantity of macropores and diffusion rate. Greater differences in classsification are observed at lower equilibrium concentrations (0,1 and 0,01 mg/dm ) in static adsorption. Therefore direct factors of Freundlich s isotherms influencing adsorption capacities at different concentrations should be considered. It was stated that angle of slope, adsorption rate in static conditions, shape of breaktrough curves in dynamic conditions... 

Trommel efficiency is affected both by geometrical and operational factors, such as length, diameter, angle of slope, rotational speed, and feed rate. Rotational speed is the most crucial operational parameter, as it must be maintained at an optimum value. Optimum rotational speed occurs when the waste material tumbles in the drum forming a cascade, which means that waste material is partially carried up the interior wall of the rotating drum, reaches about the maximum height, and then falls back on the bottom. The optimum rotational... 

A method of protecting personnel from sidewall cave-in by forming sides of an excavation that are inclined away from the excavation. The safe angle of slope required varies with different types of soil, exposure to the elements, and snperimposed loads. Slow-Moving Vehicle Emblem... 

The angle of slope j5 (see Figure 5.16) between the plains of the composition (3) and the quartz glass (2) is controlled by screws and, in this case, reflected from the surface of quartz glass and surface of the monomeric photocomposition laser beams b and c form the interferential picture in the plain P (see Figure 5.15). The interferential picture thus formed is received by the photo-receiver (7). The signal from the photo-receiver is intensified by means of the amplifier (8) and after that is controlled by the automatic potentiometer (9). 

A is cross-sectional of a vehicle along a driving direction (m ), u is the driving speed (m/s), and 6 is the angle of slope. 

Most excavations will require some form of support. Unsupported excavation is safe only if the sides are battered back sufficiently and the vertical depth of the trench does not exceed 1.2 m. HSG 185 gives details of safe angles of slope for different soils. 

A characteristic of transition states of the carbene-to-alkene addition reactions, particularly sensitive to the philicity of a carbene, is the angle of slope of the carbene plane relative to the double-bond plane. According to calculations [44, 45] one may hold that the carbenes for which in the transition states of addition to alkenes the angle a < 45° are electrophilic. The angle a > 50° is typical of nucleophilic carbenes, while the 45° < a < 50° region relates to the ambiphilic carbenes. Ab initio [44, 52, 53] and semiempirical (MNDO) [54] calculations of pathways of addition reactions of various carbenes have verified this dependence. 

Coefficient of exchange of momentum between neighboring streams of the fluid Mass transfer coefficient

[Pg.349]

Figure IV.17 illustrates the antagonism between the action of electrolytes (in the present case aluminum chloride solution) and alcohol on adhesion [8]. As the AICI3 increases to 0.1 mole per liter in the absence of alcohol, the value of since rises, i.e., the sine of the limiting angle of slope at which the quartz particles become detached from the glass surface increases. For >...

The angle of slope of a line of a current ddj, located in a plane cOOjCj (Figs. 18.4 and 18.5), is defined. 

From geometrical parities (Fig. 18.3) and the Eq. (6), we will receive expression for an angle of slope of a line of movement of particles of metal ddj, located in planes OcCjOj and capacity of forces of shift on the side Oab (Fig. 18.2). 

The scroll usually is carried on a hollow axial hub, through which the slurry feed tube passes to the feed zone. The diameter, the number, and the pitch of the conveyor flights are chosen to match the needs of the slurry being treated — as are the depth of the pond, the length of the bowl, the conveyor differential speed, and the angle of slope of the beach. 

Slosh test 10 cycles, cycle duration 5 s, angle of slope 15°, temperature 40°G,... 

The only smooth surfaces we know are those of liquids at rest. No sliding friction is observed on them. Boundary lubricants fill the depressions on the rough surfaces and thus lower the effective angle of slope usually, they have also other functions which are of no interest to the problem at hand. Frictional vibrations (or "stick-slip" friction) has been explained long ago by the difference between static and dynamic friction. Perhaps you will be interested to consult my paper in Rev. Modern Physics (19 ). 

Using the chart presented in Fig. 15.14, as a function of the angle of slope and friction... 

Radioiodide has also been separated from iodine-labeled proteins (human serum albumin and Bovine IgG) by thin-layer gel filtration on Sephadex G-200 and G-75 superfine layers (163). (Sephadex is a modified dextran.) The protein solutions were applied in amounts of 5-10 vJL to the Sephadex layers and the angle of slope of the layers was 15°. Elution was carried out with 0.2 M Tris buffer (Tris = tris (hydroxymethyl) aminomethane) at pH 8.0. The buffer contained Tween 80. Separations took 45-60 min on Sephadex G-75 and 3-4 h on Sephadex G-200 and were particularly good on the latter. 

Figure 2.3 shows deformation curves plotted in tensile strain versus tensile stress coordinates. The endpoints on the curves conform to the time of sample rupture with respective stress and strain. The elasticity modulus of the samples was calculated by the tangent of the angle of slope of the initial segments of the deformation curves. The deformation curves of filled SAN are characteristic of plastics with brittle failure. Nonfilled SAN exhibits considerable deformations. As seen in Figure 2.3 and Table 2.4, addition of up to 10% diamond carbon to SAN... 

A uniform hoop and/or disc begins to roll, without either friction nor sliding, along an inclined plate with an angle of slope a = 10° from the height = 40 cm (Figure El.14). Determine (1) linear velocities of CM (hoop) and V 2 (cylinder) of both bodies at the end of the plane (2) time of their rolling Tj and... 

---