Ammonia anhydrides

M.p. 234-235 C. Hydrolyses to aspartic acid. L-asparagine can be prepared from lupin seedlings, and DL-asparagine is synthesised from ammonia and maleic anhydride. L-asparagine is very widely distributed in plants, being found in all the Leguminosae and Gramineae, and in many other seeds, roots and buds. 

They are formed by heating dibasic acids or their anhydrides with ammonia. The hydrogen atom of the NH group is acidic and can be replaced by a metal. Mild hydrolysis breaks the ring to give the half amide of the acid. See succinimide and phthalimide. 

Prepared by stirring phthalimide with cold concentrated ammonia solution. Hydrolysed to phlhalic acid with dilute acids. Dehydration with ethanoic anhydride gives first n-cyano-benzamide and then phthalonitrile. 

Heating phthalic anhydride with urea (or ammonia) and a metallic salt. 

The choice of type of derivative should be based on whether the chloride or anhydride is aliphatic or aromatic, because this factoi largely determines the reactivity. Aliphatic acid chlorides are best converted into their anilides, as in 4 above aromatic acid chloride may be similarly converted into their anilides, or they may be converted into their amides by shaking with an excess of ammonia (p, 120). (M.ps., pp. 544-545.) Aliphatic acid anhydrides should be converted into their crystalline anilides, but aromatic acid anhydrides arc best hydrolysed to the acid, which can then be converted into one of the standard derivatives (p. 349). 

Reaction with ammonia and amines (Section 20 14) Acid an hydrides react with ammonia and amines to form amides Two molar equivalents of amine are required In the example shown only one acyl group of acetic anhydride becomes incor porated into the amide the other becomes the acyl group of the amine salt of acetic acid... 

Amides are readily prepared by acylation of ammonia and amines with acyl chlorides acid anhydrides or esters... 

The 7 glutamyl phosphate formed m this step is a mixed anhydride of glutamic acid and phosphoric acid It is activated toward nucleophilic acyl substitution and gives glutamine when attacked by ammonia... 

Chlorosulfonic acid Saturated and unsaturated acids, acid anhydrides, nitriles, acrolein, alcohols, ammonia, esters, HCl, HF, ketones, hydrogen peroxide, metal powders, nitric acid, organic materials, water... 

Chromic(VI) acid Acetic acid, acetic anhydride, acetone, alcohols, alkali metals, ammonia, dimethylformamide, camphor, glycerol, hydrogen sulflde, phosphorus, pyridine, selenium, sulfur, turpentine, flammable liquids in general... 

Hydrogen chloride Acetic anhydride, aluminum, 2-aminoethanol, ammonia, chlorosulfonic acid, ethylenediamine, fluorine, metal acetylides and carbides, oleum, perchloric acid, potassium permanganate, sodium, sulfuric acid... 

Nitric oxide Aluminum, BaO, boron, carbon disulflde, chromium, many chlorinated hydrocarbons, fluorine, hydrocarbons, ozone, phosphine, phosphorus, hydrazine, acetic anhydride, ammonia, chloroform, Fe, K, Mg, Mn, Na, sulfur... 

Rea.ctlons, As with other tertiary alcohols, esterification with carboxyUc acids is difficult and esters are prepared with anhydrides (181), acid chlorides (182), or ketene (183). Carbamic esters may be prepared by treatment with an isocyanate (184) or with phosgene followed by ammonia or an amine (185). 

Trifluoromethanesulfonic acid anhydride, bp 84°C, is prepared by refluxing the acid over an excess of phosphorous pentoxide (18,26). The anhydride reacts instantaneously with ammonia or amines to form trifluoromethanesulfonamides. The anhydride reacts with most polar organic solvents. 

The materials of constmction of the radiant coil are highly heat-resistant steel alloys, such as Sicromal containing 25% Cr, 20% Ni, and 2% Si. Triethyi phosphate [78-40-0] catalyst is injected into the acetic acid vapor. Ammonia [7664-41-7] is added to the gas mixture leaving the furnace to neutralize the catalyst and thus prevent ketene and water from recombining. The cmde ketene obtained from this process contains water, acetic acid, acetic anhydride, and 7 vol % other gases (mainly carbon monoxide [630-08-0][124-38-9] ethylene /74-< 3 -/7, and methane /74-< 2-<7/). The gas mixture is chilled to less than 100°C to remove water, unconverted acetic acid, and the acetic anhydride formed as a Hquid phase (52,53). 

Amidation. Reaction of maleic anhydride or its isomeric acids with ammonia [7664-41-7] (qv), primary amines (qv), and secondary amines produces mono- or diamides. The monoamide derivative from the reaction of ammonia and maleic anhydride is called maleamic acid [557-24-4] (8). Another monoamide derivative formed from the reaction of aniline [62-53-3] and maleic anhydride is maleanilic acid [555-59-9] (9). 

Nitrile Intermediates. Most quaternary ammonium compounds are produced from fatty nitriles (qv), which are ia turn made from a natural fat or oil-derived fatty acid and ammonia (qv) (Fig. 2) (see Fats AND FATTY oils) (225). The nitriles are then reduced to the amines. A variety of reduciag agents maybe used (226). Catalytic hydrogenation over a metal catalyst is the method most often used on a commercial scale (227). Formation of secondary and tertiary amine side-products can be hindered by the addition of acetic anhydride (228) or excess ammonia (229). In some cases secondary amines are the desired products. 

The formation of amides can be accompHshed by dehydration of the ammonium salts of sahcyhc acid. The more common method for amines is the reaction of the ester, acyl hahde, or anhydride with an amine or ammonia. Each step is fast and essentially irreversible. 

V-Alkyl or A/-aryl succinimides can be prepared from the corresponding amines (107) or from succinic anhydride, ammonia, and the corresponding alcohol (108). Succinimides are also obtained by vapor-phase hydrogenation of the corresponding maleimides ia the presence of a catalyst (109). 

---